Skip to main content
Log in

Investigation of punch resistance of the Allomyrira dichtoloma beetle forewing

  • Published:
Journal of Bionic Engineering Aims and scope Submit manuscript

Abstract

In this study, the punch resistance of the beetle forewing was investigated to address the ability of the forewing against the external force. The punch resistance of the forewing was measured for different sizes and sexes of beetles using a conventional testing method in conjunction with the Digital Image Correlation (DIC) technique. The results showed that the maximum fracture load was measured around 23 N for the female beetle and around 20.2 N for the male beetle in the front-side punch test. Moreover, the fracture load in the front-side punch test was higher than that in the back-side punch test for both male and female beetles. This means that the beetle forewing plays a protection role against external loads. Furthermore, the puncture energy in the front-side punch test for the female beetle (6.91 mJ) was a little higher than that for the male beetle (5.27 mJ). In addition, the DIC results revealed that the first crack occurred along the trachea line and the second crack then appeared in the direction that was perpendicular to the direction of the first crack. This study provides a comprehensive understanding of the mechanical protection properties of the beetle forewing and offers a good lesson for studying lightweight bio-inspired composite material.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. Chen J, Dai G, Xu Y, Iwamoto M. Optimal composite structures in the forewings of beetles. Composite Structures, 2007, 81, 432–437.

    Article  Google Scholar 

  2. Chen J, Ni Q Q, Xu Y, Iwamoto M. Lightweight composite structures in the forewings of beetles. Composite Structures, 2007, 79, 331–337.

    Article  Google Scholar 

  3. Chen J X, Iwamoto M, Ni Q Q, Kurashiki K, Saito K. Cross sectional structure and its optimality of the fore-wing of beetles. Journal of the Society of Materials Science, 2000, 49, 407–412.

    Article  Google Scholar 

  4. Chen J X, Ni Q Q, Yasuhisa E, Masaharu I. Distribution of trabeculae and elytral surface structures of the horned beetle, Allomyrina dichotoma (Linné)(Coleoptera: Scarabaeidae). Insect Science, 2002, 9, 55–61.

    Article  Google Scholar 

  5. Chen J X, Ni Q Q, Yasuhisa E, Masaharu I. Fine structure of trabecula in the elytra of Allomyrina dichotoma (Linne) and Prosopocoilus inclinatus (Motschulsky)(Coleoptera: Scarabaeedae). Insect Science, 2001, 8, 115–123.

    Article  Google Scholar 

  6. Ni Q Q, Chen J X, Iwamoto M, Kurashiki K, Saito K. Interlaminar reinforcement mechanism in a beetle fore-wing. JSME International Journal Series C, 2001, 44, 1111–1116.

    Article  Google Scholar 

  7. Chen J X, Dai G Z, Xu Y, Iwamoto M. Basic study of biomimetic composite materials in the forewings of beetles. Materials Science and Engineering: A, 2008, 483, 625–628.

    Article  Google Scholar 

  8. Chen J X, Wu G. Beetle forewings: Epitome of the optimal design for lightweight composite materials. Carbohydrate Polymers, 2013, 91, 659–665.

    Article  Google Scholar 

  9. Chen J X, Xie J, Wu Z S, Elbashiry E M A, Lu Y. Review of beetle forewing structures and their biomimetic applications in China: (I) On the structural colors and the vertical and horizontal cross-sectional structures. Materials Science and Engineering: C, 2015, 55, 605–619.

    Article  Google Scholar 

  10. Chen J X, Zu Q, Wu G, Xie J, Tuo W Y. Review of beetle forewing structures and their biomimetic applications in China: (II) On the three-dimensional structure, modeling and imitation. Materials Science and Engineering: C, 2015, 55, 620–633.

    Article  Google Scholar 

  11. He C, Zu Q, Chen J, Noori M N. A review of the mechanical properties of beetle elytra and development of the biomimetic honeycomb plates. Journal of Sandwich Structures and Materials, 2015, 1099636215576881.

    Google Scholar 

  12. Sun J Y, Tong J, Zhang Z J. Nanomechanical properties and the hierarchical structure of elytra cuticle of dung beetle (Copris ochus Motschulsky). International Conference on Mechatronics and Automation, Changchun, China, 2009, 4277–4282.

    Google Scholar 

  13. Dai Z, Yang Z. Macro-/micro-structures of elytra, mechanical properties of the biomaterial and the coupling strength between elytra in beetles. Journal of Bionic Engineering, 2010, 7, 6–12.

    Article  Google Scholar 

  14. Lomakin J, Huber P A, Eichler C, Arakane Y, Kramer K J, Beeman R W, Kanost M R, Gehrke S H. Mechanical properties of the beetle elytron, a biological composite material. Biomacromolecules, 2010, 12, 321–335.

    Article  Google Scholar 

  15. Chen J X, Iwamoto M, Ni Q Q, Kurashiki K, Saito K. Laminated structure and its mechanical properties of the fore-wing of beetle. Journal of the Society of Materials Science, 2001, 50, 455–460.

    Article  Google Scholar 

  16. McCullough E L. Mechanical limits to maximum weapon size in a giant rhinoceros beetle. Proceedings of the Royal Society of London B: Biological Sciences, 2014, 281, 20140696.

    Article  Google Scholar 

  17. McCullough E L, Tobalske B W, Emlen D J. Structural adaptations to diverse fighting styles in sexually selected weapons. Proceedings of the National Academy of Sciences, 2014, 111, 14484–14488.

    Article  Google Scholar 

  18. Jaekel D J, MacDonald D W, Kurtz S M. Characterization of PEEK biomaterials using the small punch test. Journal of the Mechanical Behavior of Biomedical Materials, 2011, 4, 1275–1282.

    Article  Google Scholar 

  19. Ha N S, Jin T, Goo N S, Park H C. Anisotropy and non-homogeneity of an Allomyrina dichotoma beetle hind wing membrane. Bioinspiration & Biomimetics, 2011, 6, 046003.

    Article  Google Scholar 

  20. Ha N S, Jin T, Goo N S. Modal analysis of an artificial wing mimicking an Allomyrina dichotoma beetle’s hind wing for flapping-wing micro air vehicles by noncontact measurement techniques. Optics and Lasers in Engineering, 2013, 51, 560–570.

    Article  Google Scholar 

  21. Jin T, Ha N S, Le V T, Goo N S, Jeon H C. Thermal buckling measurement of a laminated composite plate under a uniform temperature distribution using the digital image correlation method. Composite Structures, 2015, 123, 420–429.

    Article  Google Scholar 

  22. Soons J, Lava P, Debruyne D, Dirckx J. Full-field optical deformation measurement in biomechanics: Digital speckle pattern interferometry and 3D digital image correlation applied to bird beaks. Journal of the Mechanical Behavior of Biomedical Materials, 2012, 14, 186–191.

    Article  Google Scholar 

  23. Montesano J, Selezneva M, Levesque M, Fawaz Z. Modeling fatigue damage evolution in polymer matrix composite structures and validation using in-situ digital image correlation. Composite Structures, 2015, 125, 354–361.

    Article  Google Scholar 

  24. Jiang Y, Akkus A, Roperto R, Akkus O, Li B, Lang L, Teich S. Measurement of J-integral in CAD/CAM dental ceramics and composite resin by digital image correlation. Journal of the Mechanical Behavior of Biomedical Materials, 2016, 62, 240–246.

    Article  Google Scholar 

  25. Ha N S, Le V T, Goo N S. Investigation of fracture properties of a piezoelectric stack actuator using the digital image correlation technique. International Journal of Fatigue, 2017, 101, Part 1, 106–111.

    Article  Google Scholar 

  26. Hijazi A, Yardi N, Madhavan V, Determination of forming limit curves using 3D digital image correlation and in-situ observation. International SAMPE Symposium and Exhibition, Long Beach, USA, 2004, 16–20.

    Google Scholar 

  27. Reu P L, Vangoethem D, Cordova T E. Measurement of steel plate perforation tests with digital image correlation. Experimental Mechanics Annual Conference, Albuquerque, USA, 2009.

    Google Scholar 

  28. Hammer J, Liutkus T, Seidt J, Gilat A. Using Digital Image Correlation (DIC) in dynamic punch tests. Experimental Mechanics, 2015, 55, 201–210.

    Article  Google Scholar 

  29. Ha N S, Truong Q T, Phan H V, Goo N S, Park H C. Structural characteristics of Allomyrina dichotoma beetle’s hind wings for flapping wing micro air vehicle. Journal of Bionic Engineering, 2014, 11, 226–235.

    Article  Google Scholar 

  30. Ha N S, Truong Q T, Goo N S, Park H C. Relationship between wingbeat frequency and resonant frequency of the wing in insects. Bioinspiration & Biomimetics, 2013, 8, 046008.

    Article  Google Scholar 

  31. Mengesha T, Vallance R, Mittal R. Stiffness of desiccating insect wings. Bioinspiration & Biomimetics, 2010, 6, 014001.

    Article  Google Scholar 

  32. Yu M, Hermann I, Dai Z, Gitis N. Mechanical and frictional properties of the elytra of five species of beetles. Journal of Bionic Engineering, 2013, 10, 77–83.

    Article  Google Scholar 

  33. Clark A J, Triblehorn J D. Mechanical properties of the cuticles of three cockroach species that differ in their wind-evoked escape behavior. PeerJ, 2014, 2, e501.

    Article  Google Scholar 

  34. Hepburn H, Ball A. On the structure and mechanical properties of beetle shells. Journal of Materials Science, 1973, 8, 618–623.

    Article  Google Scholar 

  35. Sun J Y, Jin T, Chen D H, Lin J B. Micro-tensile testing of the lightweight laminated structures of beetle elytra cuticle. Advances in Natural Science, 2010, 3, 225–234.

    Google Scholar 

  36. Cheng L, Wang L, Karlsson A M. Mechanics-based analysis of selected features of the exoskeletal microstructure of Popillia japonica. Journal of Materials Research, 2009, 24, 3253–3267.

    Article  Google Scholar 

  37. Roseland C R, Kramer K J, Hopkins T L. Cuticular strength and pigmentation of rust-red and black strains of Tribolium castaneum. Insect Biochemistry, 1987, 17, 21–28.

    Article  Google Scholar 

  38. Czapla T H, Hopkins T L, Kramer K J. Cuticular strength and pigmentation of five strains of adult Blattella germanica (L.) during sclerotization: Correlations with catecholamines, ß-alanine and food deprivation. Journal of Insect Physiology, 1990, 36, 647–654.

    Article  Google Scholar 

  39. Fenton M, Swanepoel C, Brigham R, Cebek J, Hickey M. Foraging behavior and prey selection by large slit-faced bats (Nycteris grandis; Chiroptera: Nycteridae). Biotropica, 1990, 22, 2–8.

    Article  Google Scholar 

Download references

Acknowledgment

This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIP) (NRF-2016R1A2B4007443). The authors are grateful for the financial support.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Nam Seo Goo.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Ha, N.S., Le, V.T. & Goo, N.S. Investigation of punch resistance of the Allomyrira dichtoloma beetle forewing. J Bionic Eng 15, 57–68 (2018). https://doi.org/10.1007/s42235-017-0004-6

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s42235-017-0004-6

Keywords

Navigation