Comparative Analysis About Degradation Mechanisms of Printed Circuit Boards (PCBs) in Slow and Fast Pyrolysis: The Influence of Heating Speed

  • Fabian Diaz
  • Benedikt Flerus
  • Samant Nagraj
  • Katrin Bokelmann
  • Rudolf Stauber
  • Bernd Friedrich
Innovations in WEEE Recycling
  • 6 Downloads

Abstract

Despite the high number of publications regarding pyrolysis of electronic scraps, there have not been many attempts to correctly understand the degradation mechanisms of organics. Hence, it is a challenge to identify the optimum parameters that can benefit its metallurgical recycling and especially the recovery of technological elements. This article refers to a detailed analysis of the degradation mechanisms during slow pyrolysis as well as its deflection under fast heating speed. The analysis was made based on continuous off-gas analysis by Fourier transform infrared spectroscopy (FTIR), kinetic analysis on slow pyrolysis and measurement of total carbon (TC), total organic carbon (TOC), and elemental carbon (EC) in solid products at different pyrolysis temperatures. Results have evidenced that degradation of organics in pyrolysis of PCBs takes place in at least three different stages, which are driven by different reaction mechanisms and kinetic conditions. In addition, fast pyrolysis has shown to be beneficial if operated above 600 °C, where high-quality syngas is produced, containing elevated concentrations of CH4 and H2, and a lower concentration of H2O(g) compared to conventional pyrolysis and fast pyrolysis at lower temperatures.

Keywords

WEEE Pyrolysis Recycling Printed circuit boards Thermal pre-processing 

Notes

Acknowledgement

This study is supported by the cooperation project RessourcenKolleg.NRW, funded by the North Rhine-Westphalia Ministry of Science. Special thanks to Prof. Flamme for the constructive discussion and for providing the test material used for this study.

References

  1. 1.
    Balde CP (2015) The global e-waste monitor 2014: quantities, flows and resources. United Nations University, BonnGoogle Scholar
  2. 2.
    Robinson BH (2009) E-waste: an assessment of global production and environmental impacts. Sci Total Environ 408:183–191CrossRefGoogle Scholar
  3. 3.
    Namias J (2013) The future of electronic waste recycling in the United States: obstacles and domestic solutions. Master Thesis, Columbia UniversityGoogle Scholar
  4. 4.
    Luyima A (2013) Recycling of electronic waste: printed wiring boards: printed wiring boards. Doctoral DissertationsGoogle Scholar
  5. 5.
    Kim B-S, Lee J-C, Seo S-P, Park Y-K, Sohn HY (2004) A process for extracting precious metals from spent printed circuit boards and automobile catalysts. JOM 56:55–58CrossRefGoogle Scholar
  6. 6.
    Yokoyama S, Iji M (1997) Recycling of printed wiring boards with mounted electronic parts. Circuit World 23:109–114Google Scholar
  7. 7.
    Zhao Y, Wen X, Li B, Tao D (2004) Recovery of copper from printed circuit boards. Miner Metal Process 21:99–102Google Scholar
  8. 8.
    Luda MP (2012) Waste electrical and electronic equipment (WEEE) handbook: pyrolysis of WEEE plastics. Woodhead Publishing, CambridgeGoogle Scholar
  9. 9.
    Damoah L, Zuo X, Zhang L, Schuman T, Kers J (2011) Green pyrolysis of used printed wiring boards powders. In: Lifeng Z, Krumdick GK (eds) Recycling of electronic waste II: proceedings of the second symposium. Wiley, HobokenGoogle Scholar
  10. 10.
    Epple B, Leithner R, Linzer W, Walter H (2009) Simulation von Kraftwerken und wärmetechnischen. Anlagen, New YorkCrossRefGoogle Scholar
  11. 11.
    Thomé-Kozmiensky KJ, Pahl U (eds) (1994) Thermische Abfallbehandlung, 2., völlig neu bearb. Aufl. ed., EF-Verl. für Energie- und Umwelttechnik, BerlinGoogle Scholar
  12. 12.
    Thomé-Kozmiensky KJ (ed) (1985) Pyrolyse von Abfällen, 1. Aufl. ed., EF-Verl. für Energie- und Umwelttechnik, BerlinGoogle Scholar
  13. 13.
    Cui J, Zhang L (2008) Metallurgical recovery of metals from electronic waste: a review. J Hazard Mater 158:228–256CrossRefGoogle Scholar
  14. 14.
    Mankhand TR, Singh KK, Gupta SK, Das S (2012) Pyrolysis of printed circuit boards. Int J Metall Eng 1:102–107Google Scholar
  15. 15.
    Moss GP, Smith PAS, Tavernier D (1995) Glossary of class names of organic compounds and reactivity intermediates based on structure (IUPAC Recommendations 1995). Pure Appl Chem 67:1307–1375Google Scholar
  16. 16.
    Basu P (2010) Biomass gasification and pyrolysis: practical design and theory. Elsevier, AmsterdamGoogle Scholar
  17. 17.
    Devi L, Ptasinski KJ, Janssen FJJG (2003) A review of the primary measurement for tar elimination in biomass gasification process. Biomass Bioenerg 24:125–140CrossRefGoogle Scholar
  18. 18.
    Neeft JPA, Knoef HAM, Zielke U (1999) Guideline for sampling an analysis of tar and particles in biomass producer gas 3.1, Energy projectGoogle Scholar
  19. 19.
    Milne TA, Evans RJ (1998) Biomass gasifier tars: their nature, formation, and conversion, National Renewable Energy LaboratoryGoogle Scholar
  20. 20.
    Evans RJ, Milne TA (1997) Chemistry of tar formation and maturation in the thermochemical conversion of biomass. Developments in Thermochemical Biomass Conversion. Springer, NetherlandsCrossRefGoogle Scholar
  21. 21.
    Kantarelis E (2009) Thermochemical treatment of electric and electronic waste thermochemical treatment of electric and electronic waste for energy recovery. Licentiate Thesis, StockholmGoogle Scholar
  22. 22.
    Mayers MA (1934) The combustion of carbon. Chem Rev 14:31–53CrossRefGoogle Scholar
  23. 23.
    Diaz F, Florez S, Friedrich B (2015) Mass flow analysis and metal losses by the degradation process of organic-containing WEEE scraps. Chem Ing Tech 87:1599–1608CrossRefGoogle Scholar
  24. 24.
    Luda MP (2011) Integrated waste management—volume II: recycling of printed circuit boards. InTech, Lurago Marinone, ItalyGoogle Scholar
  25. 25.
    Jie G, Ying-Shun L, Mai-Xi L (2008) Product characterization of waste printed circuit board by pyrolysis. J Anal Appl Pyrol 83:185–189CrossRefGoogle Scholar
  26. 26.
    Barontini F, Cozzani V (2006) Formation of hydrogen bromide and organobrominated compounds in the thermal degradation of electronic boards. J Anal Appl Pyrol 77:41–55CrossRefGoogle Scholar
  27. 27.
    Chien YC, Wang HP, Lin KS, Huang Y-J, Yang YW (2000) Fate of bromine in pyrolysis of printed circuit board wastes. Chemosphere 40:383–387CrossRefGoogle Scholar
  28. 28.
    Scheirs J, Kaminsky W (eds) (2006) Feedstock recycling and pyrolysis of waste plastics: converting waste plastics into diesel and other fuels. Wiley, Chichester, HobokenGoogle Scholar
  29. 29.
    Mishra DP (2014) Experimental combustion. CRC Press, Boca RatonGoogle Scholar
  30. 30.
    Lin MC, Back MH (1966) The thermal decomposition of ethane: Part I. Initiation and termination steps. Can J Chem 44:505–514CrossRefGoogle Scholar
  31. 31.
    Lin MC, Back MH (1966) The thermal decomposition of ethane: Part II. The unimolecular decomposition of the ethane molecule and the ethyl radical. Can J Chem 44:2357–2367CrossRefGoogle Scholar
  32. 32.
    Wendlandt W (1974) Thermal Methods of Analysis, 2nd edn. Wiley, New YorkGoogle Scholar
  33. 33.
  34. 34.
    Quan C, Li A, Gao N (2013) Combustion and pyrolysis of electronic waste: thermogravimetric analysis and kinetic model. Proced Environ Sci 18:776–782CrossRefGoogle Scholar
  35. 35.
    Zhan Z-H, Qiu K-Q (2011) Pyrolysis kinetics and TG-FTIR analysis of waste epoxy printed circuit boards. J Cent South Univ Technol 18:331–336CrossRefGoogle Scholar
  36. 36.
    Zhang H-Y, McKlNNON JT (1995) Elementary reaction modeling of high-temperature benzene combustion. Combust Sci Technol 107:261–300CrossRefGoogle Scholar
  37. 37.
    Seta T, Nakajima M, Miyoshi A (2006) High-temperature reactions of OH radicals with benzene and toluene. J Phys Chem A 110:5081–5090CrossRefGoogle Scholar
  38. 38.
    Suh I, Zhang D, Zhang R, Molina LT, Molina MJ (2002) Theoretical study of OH addition reaction to toluene. Chem Phys Lett 364:454–462CrossRefGoogle Scholar
  39. 39.
    Jackson WM, Conley RT (1964) High temperature oxidative degradation of phenol–formaldehyde polycondensates. J Appl Polym Sci 8:2163–2193CrossRefGoogle Scholar
  40. 40.
    Hollman DS, Simmonett AC, Schaefer HF (2011) The benzene+ OH potential energy surface: intermediates and transition states. Phys Chem Chem Phys 13:2214–2221CrossRefGoogle Scholar
  41. 41.
    Kaeding WW, Lindblom RO, Temple RG, Mahon HI (1965) Oxidation of toluene and other alkylated aromatic hydrocarbons to benzoic acids and phenols. Ind Eng Chem Proc Des Dev 4:97–101CrossRefGoogle Scholar

Copyright information

© The Minerals, Metals & Materials Society 2018

Authors and Affiliations

  1. 1.Institute of Process Metallurgy and Metal Recycling IMERWTH Aachen UniversityAachenGermany
  2. 2.Fraunhofer Institute for Silicate Research ISC, Project Group Materials Recycling and Resource Strategies IWKSAlzenauGermany

Personalised recommendations