Abstract
Microelectromechanical systems (MEMS) use silicon based dielectric films such as SiO2 and Si3N4 for providing insulation. In capacitive transducers, these layers are used as insulation layers for capacitive actuators to prevent short-circuiting of electrodes by contact of electrodes and in case of touchmode capacitive pressure sensors (TMCPS), the dielectric layer provides for overload protection and provides for operation in the pressure ranges in which the diaphragm comes in contact with dielectric. The pressure at which diaphragm just touches the dielectric is referred to as touch-point pressure. In case of actuator, pull-in voltage is a critical parameter that decides the onset of instability in operation of the device. Silicon based dielectric thin films have the tendency to store or trap static charges, the presence of which alters the ideal behaviour of dielectrics. These trapped static charges introduced due fabrication processes; handling and operation affect the operation of capacitive transducers by influencing the pull-in voltage and by affecting the touch-point pressure. This paper presents a novel methodology, which predicts the pull-in voltage and touch-point pressure in presence of the static charges in a dielectric. The method proposed is less complex and less time consuming. Closed form expressions have been derived for pull-in voltage, touch-point pressure and critical displacement in presence of static charges. The results are compared with those obtained by experiment.
Similar content being viewed by others
Abbreviations
- Qres :
-
Residual charge density in dielectric layer
- Ê0 :
-
Electric field in the air-gap
- Êd :
-
Electric field in the dielectric
- d0 :
-
Air-gap at zero applied voltage and/or pressure
- V:
-
Applied voltage
- A:
-
Area of the diaphragm
- tm :
-
Thickness of the dielectric
- deff :
-
tm/εi
- σres :
-
Surface charge density
- h:
-
Diaphargm thickness
- E:
-
Young’s Modulus of the diaphragm material
- a:
-
Half side length of the diaphragm
- w(x, y):
-
Deflection of the diaphragm at a given point (x,y)
- εr :
-
Relative permittivity of the medium, it is denoted by εa for air and εi for the dielectric
References
Ko, W.H., wang, Q.: Touch mode capacitive pressure sensor. Sens. Actuator A 75, 242–251 (1999)
Sze, S.M.: Physics of Semiconductor Devices. Wiley, New York (1969)
Ono, T., Sim, D.Y., Esashi, M.: Micro-discharge and electric breakdown in a micro-gap. J. Micromech. Microeng. 10, 445–450 (2000)
Zhang, X., Sesslera, G.M.: Charge dynamics in silicon nitride/silicon oxide double layers. Appl. Phys. Lett. 78(18), 2757–2759 (2001)
Wibbeler, J., Pfeifer, G., Hietschold, M.: Parasitic charging of dielectric surfaces in capacitive micro-electro-mechanical systems (MEMS). Sens. Actuators A 71, 74–80 (2000)
Chan, E.K., Garikipati, K., Dutton, R.W.: Characterization of contact electro-mechanics through capacitance–voltage measurements and simulations J. Microelectromech. Syst. 8, 208–217 (1999)
Bingqian, L., Changchun, Z., Junhua, L.: Electrostatic force influeneced by space charge in submicrometer or nanometer silicon micrstructures. J. Micromech. Microeng. 9, 319–323 (1999)
Cabuz, C., Cabuz, E.I., Ohnstein, T.R., Neus, J., Maboudian, R.: Factors enhancing the reliability of touch-mode electrostatic actuators. Sens. Actuators A 79, 245–250 (2000)
Walraven, J.A.: Future challenges for MEMS failure analysis. In: ITC International Test Conference, pp. 850–855 (2003)
Goldsmith, C., Ehmke, J., Malczewski, A., Pillans, B., Eshelman, S., Yao, Z., Brank, J., Eberly, M.: Lifetime characterization of capacitive RF MEMS switches. In: Microwave Symposium Digest, vol. 1, pp. 227–230. IEEE MTT-S International (2001)
Bochobza-Degani, O., Socher, E., Nemirovsky, Y.: On the effect of residual charges on the pull-in parameters of the electrostatic actuators. Sens. Actuators A 97–98, 563–568 (2002)
Wu, Y., Shannon, M.A.: Theoretical analysis of the effect of static charges in silicon-based dielectric thin films on micro- to nanoscale electrostatic actuation. J. Microelectromech. Syst. 14, 98–998 (2004)
van Spengen, W.M., Puers, R., Mertens, R. De Wolf, I.: A comprehensive model to predict the charging and reliability of capacitive, RF MEMS switches. J. Micromech. Microeng. 14, 514–521 (2004)
Molinero, D., Comulada, R., Castañer, L.: Dielectric charge measurements in capacitive microelectromechanical switches. Appl. Phys. Lett. 89, 103506 (2006)
Eaton, W.P., Bitsie, F., Smith, J.H., Plummer, D.W.: A new analytical solution for diaphragm deflection and its application to a surface-micromachined pressure sensor. In: International Conference on Modeling and Simulation of Microsystems, MSM99 (1999)
Zhang, Y., Zhao, Ya.: Numerical and analytical study on the pull-in instability of micro-structure under electrostatic loading. Sens. Actuators A 127, 366–380 (2006)
Sharma, A., George, P.J.: A simple method for calculation of the pull-in voltage and touch-point pressure for the small deflection of square diaphragm in MEMS. Sens. Actuators A 141, 376–382 (2008)
Sharma, A.: Modelling the effect of applied voltage, residual stress and parasitic charges on the behavior of MEMS capacitive pressure sensor with square diaphragm. In: Proceedings of Fourth International Conference on Sensing Technology, Leece, Italy, June 3–5, pp 11–16 (2010)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sharma, A., George, P.J. A novel method to predict the effect of static charges on the pull-in voltage and touch-point pressure of the capacitive transducer with square diaphragm. Int J Adv Eng Sci Appl Math 2, 55–60 (2010). https://doi.org/10.1007/s12572-010-0008-5
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12572-010-0008-5