Experimental and Theoretical Investigation on Flexural Behavior of Corroded Steel Beams Strengthened by CFRP Plate

Abstract

To investigate the flexural behavior of corroded steel beams strengthened by carbon fiber reinforced polymer (CFRP) plate, flexural test of five steel beams were carried out. The effects of corrosion and prestressing force levels on the flexural capacity, failure modes and interfacial stress were investigated. Meanwhile, considering the corrosion surface the calculation method of flexural capacity of corroded beams strengthened by CFRP plate was also established. The results showed that failure modes of corroded beams were the fracture of the CFRP plate after the shear failure of interface on the mid-span and fracture location of CFRP plate was mostly at the loading point. The rough surface of the corroded steel can enhance the efficiency of stress transfer at the interface, thereby improving the effective bond length of the interface. The shear stress was mainly concentrated on the CFRP plate end, and peak value appeared at the loading point. Compared the reference beam, the ultimate flexural capacity of the corroded beam strengthened by CFRP plate with 15% prestress level increased at a ratio of 21%, and utilization ratio of the CFRP plates was up to 71.59%.

This is a preview of subscription content, log in to check access.

Abbreviations

A cf :

Section area of CFRP Plate

As(te):

Section area of steel beam

D s :

Corrosion ratio

E :

Elastic modulus

E cf :

Elastic modulus of CFRP plate

E s :

Elastic modulus of steel

f u :

Ultimate strength

f y :

Yield strength

G :

Shear modulus

H :

Section height of steel beam

I :

Inertia moment

I′ t e :

Inertial moment of steel beam to composite section

Is(te):

Inertia moment of steel beam before reinforcement

M y :

Yield moment

P u :

Ultimate load

P y :

Yield load

S a :

Arithmetic average height of surface

S ku :

High degree of kurtosis

S p :

Maximum peak height of surface

S q :

Mean square height of surface

S s :

Cross-sectional area of weak position

S sk :

Skewness of surface height distribution

S 0 :

Cross-sectional area of steel

t e :

Equivalent thickness

t f :

Thickness of CFRP plate

t max :

Maximum residual thickness

y0(te):

Distance from the neutral axis before reinforcement

a Ef :

The ratio of elastic modulus of CFRP plate and steel

ε:

The strain of CFRP plate overcoming reverse deformation

ε0 :

Tensile strain after deducting prestress loss

υ :

Poisson’s ratio

ζ :

Elongation

References

  1. Benachour A, Benyoucef S, Tounsi A (2008) Interfacial stress analysis of steel beams reinforced with bonded prestressed FRP plate. Engineering Structures 3(11):3305–3315, DOI: 10.1016/j.engstruct.2008.05.007

    Article  Google Scholar 

  2. Cinitha A, Umesha PK, Iyer NR (2014) An overview of corrosion and experimental studies on corroded mild steel compression members. KSCE Journal of Civil Engineering 18(9):1735–1744, DOI: 10.1007/s12205-014-0362-0

    Article  Google Scholar 

  3. Deng J, Li J, Wang Y, Xie W (2018) Numerical study on notched steel beams strengthened by CFRP plates. Construction and Building Materials 163:622–633, DOI: 10.1016/j.conbuildmat.2017.12.110

    Article  Google Scholar 

  4. Ding J, Wang F, Huang X, Chen S (2014) The effect of CFRP length on the failure mode of strengthened concrete beams. Polymers 6(6): 1705–1726, DOI: 10.3390/polym6061705

    Article  Google Scholar 

  5. Edalati SA, Yadollahi Y, Pakar I, Bayat M (2015) On the effect of GFRP fibers on retrofitting steel shear walls with low yield stress. Earthquakes and Structures 8(6):1453–1461, DOI: 10.12989/eas.2015.8.6.1453

    Article  Google Scholar 

  6. Feng P, Cheng S, Yu T (2018) Seismic performance of hybrid column of concrete-filled square steel tube with FRP-confined concrete core. Journal of Composites for Construction 22(4):04018015, DOI:10.1061/(ASCE)CC.1943-5614.0000849

    Google Scholar 

  7. Feng P, Hu LL, Zhang YH, Ye LP (2019a) Behavior analysis of FRP tube/filling strengthened steel members under axial compression. Thin-Walled Structure 134:475–490, DOI: 10.1016/j.tws.2018.10.015

    Article  Google Scholar 

  8. Feng P, Qiang HL, Ou X, Qin WH, Yang JX (2019b) Progressive collapse resistance of GFRP-strengthened RC beam-slab subassemblages in a corner column removal scenario. Journal of Composites for Construction 23(1):04018076, DOI: 10.1061/(ASCE)CC.1943-5614.0000917

    Google Scholar 

  9. Feng P, Zhang P, Meng XM (2014) Mechanical analysis of stress distribution in a carbon fiber-reinforced polymer rod bonding anchor. Polymers 6(4):1129–1143, DOI: 10.3390/polym6041129

    Article  Google Scholar 

  10. Garbatov Y, Saad-Eldeen S, Guedes Soares C (2019) Tensile test analysis of corroded cleaned aged steel specimens. Corrosion Engineering Science and Technology 54(2):154–162, DOI: 10.1080/1478422X.2018.1548098

    Article  Google Scholar 

  11. GB/T 228.1 (2010) Tensile test method for metallic materials at room temperature. GB/T 228.1, Standards Press of China, Beijing, China

    Google Scholar 

  12. Ghafoori E (2013) Interfacial stresses in beams strengthened with bonded prestressed plates. Engineering Structures 46:508–510, DOI:10.1016/j.engstruct.2012.08.011

    Article  Google Scholar 

  13. Ghafoori E, Motavalli M (2013) Flexural and interfacial behavior of metallic beams strengthened by prestressed bonded plates. Composite Structures 101:22–34, DOI: 10.1016/j.compstruct.2013.01.021

    Article  Google Scholar 

  14. Ghafoori E, Motavalli M (2015) Innovative CFRP-Prestressing system for strengthening metallic structures. Journal of Composites for Construction 19(6):04015006, DOI: 10.1061/(ASCE)CC.1943-5614.0000559

    Google Scholar 

  15. Huo JH, Wang LG, Zhang HF (2015) Experimental research on prestressed CFRP sheets strengthened corroded steel beams. Journal of Building Structure 36:72–77, DOI: 10.14006/j.jzjgxb.2015.11.009 (in Chinese)

    Google Scholar 

  16. Kianmofrad F, Ghafoori E, Elyasi MM (2017) Strengthening of metallic beams with different types of pre-stressed un-bonded retrofit systems. Composite Structures 159:81–95, DOI: 10.1016/j.compstruct.2016.09.020

    Article  Google Scholar 

  17. Li R, Miao CQ, Yu J (2020a) Effect of characteristic parameters of pitting on strength and stress concentration factor of cable steel wire. Construction and Building Materials 240:117915, DOI: 10.1016/j.conbuildmat.2019.117915

    Article  Google Scholar 

  18. Li R, Miao CQ, Zhuang ML (2020b) Experimental and numerical investigation of stress concentration factor of cable steel wire with corrosion pits. KSCE Journal of Civil Engineering 24(5):1581–1592, DOI: 10.1007/s12205-020-1787-2

    Article  Google Scholar 

  19. Lu YY, Li WJ, Li S, Li XJ, Zhu T (2015) Study of the tensile properties of CFRP strengthened steel plates. Polymers 7(12):2595–2610, DOI:10.3390/polym7121537

    Article  Google Scholar 

  20. Nie B, Xu SH, Yu J, Zhang HJ (2019) Experimental investigation of mechanical properties of corroded cold-formed steels. Journal of Constructional Steel Research 162:105706, DOI: 10.1016/j.jcsr.2019.105706

    Article  Google Scholar 

  21. Nie B, Xu SH, Zhang ZX, Gu RJ (2020) Experimental investigation on corroded cold-formed steel beam-columns under compression and major axis bending. Journal of Constructional Steel Research 169:105706, DOI: 10.1016/j.jcsr.2020.106026

    Article  Google Scholar 

  22. Qin GC, Lan T, Qin Q, Xu SH (2019) Degradation model and evaluation criteria for the seismic behavior of corrosion H-section steel column. KSCE Journal of Civil Engineering 23(8):3694–3705, DOI: 10.1007/s12205-019-0153-8

    Article  Google Scholar 

  23. Stratford T, Cadei J (2006) Elastic analysis of adhesion stresses for the design of a strengthening plate bonded to a beam. Construction and Building Materials 20:34–45, DOI: 10.1016/j.conbuildmat.2005.06.041

    Article  Google Scholar 

  24. Teng JG, Yu T, Fernando D (2012) Strengthening of steel structures with fiber-reinforced polymer composites. Journal of Constructional Steel Research 78:131–143, DOI: 10.1016/j.jcsr.2012.06.011

    Article  Google Scholar 

  25. Wang YD, Xu SH, Li H, Zhang HJ (2020) Surface characteristics and stochastic model of corroded structural steel under general atmospheric environment. Acta Metallurgica Sinica 56(2):148–160, DOI: 10.11900/ 0412.1961.2019.00156

    Google Scholar 

  26. Wang YD, Xu SH, Wang H, Li AB (2017) Predicting the residual strength and deformability of corroded steel plate based on the corrosion morphology. Construction and Building Materials 152:777–793, DOI: 10.1016/j.conbuildmat.2017.07.035

    Article  Google Scholar 

  27. Xu SH, Zhang ZX, Li R, Wang H (2019a) Effect of cleaned corrosion surface topography on mechanical properties of cold-formed thin-walled steel. Construction and Building Materials 222:1–14, DOI: 10.1016/j.conbuildmat.2019.06.130

    Article  Google Scholar 

  28. Xu SH, Zhang ZX, Qin GQ (2019b) Study on the seismic performance of corroded H-shaped steel columns. Engineering Structures 191:39–61, DOI: 10.1016/j.engstruct.2019.04.037

    Article  Google Scholar 

  29. Xu, SH, Li H, Wang YD, Wang YJ (2020) Influence of corrosion on the bond behavior in CFRP-steel single lap joints. Construction and Building Materials 236:117607, DOI: 10.1016/j.conbuildmat.2019. 117607

  30. Zhang ZX, Xu SH, Li R (2020a) Comparative investigation of the effect of corrosion on the mechanical properties of different parts of thin-walled steel. Thin-Walled Structures 146:106450, DOI: 10.1016/j.tws.2019.106450

    Article  Google Scholar 

  31. Zhang ZX, Xu SH, Nie B, Li R, Xing Z (2020b) Experimental and numerical investigation of corroded steel columns subjected to in-plane compression and bending. Thin-Walled Structures 151:106735, DOI: 10.1016/j.tws.2020.106735

    Article  Google Scholar 

  32. Zhao XL, Zhang L (2007) State-of-the-art review on FRP strengthened steel structures. Engineering Structures 29(8):1808–1823, DOI: 10.1016/j.engstruct.2006.10.006

    Article  Google Scholar 

  33. Zhou Y, Fan H, Jiang K, Gou M, Li N, Zhu P (2014) Experimental flexural behaviors of CFRP strengthened aluminum beams. Composite Structures 116(1):761–771, DOI: 10.1016/j.compstruct.2014.06.012

    Article  Google Scholar 

Download references

Acknowledgements

The financial support provided by National Natural Science Foundation of China under Grant No. 51678477 is highly acknowledged. The authors also would like to express the gratitude to the reviewers for careful comments.

Author information

Affiliations

Authors

Corresponding author

Correspondence to Zong-Xing Zhang.

Rights and permissions

Reprints and Permissions

About this article

Verify currency and authenticity via CrossMark

Cite this article

Zhang, Z., Xu, S., Mu, L. et al. Experimental and Theoretical Investigation on Flexural Behavior of Corroded Steel Beams Strengthened by CFRP Plate. KSCE J Civ Eng 24, 2160–2172 (2020). https://doi.org/10.1007/s12205-020-2140-5

Download citation

Keywords

  • Prestress
  • CFRP plate
  • Corrosion damage
  • Steel beam
  • Flexural behavior