Modeling Quasi-Elastic Properties of Sand while considering Inherent and Stress-Induced Anisotropies
- 26 Downloads
The hypoelastic model (HongNam and Koseki, 2005)−which can describe inherent and stress-induced anisotropies in the quasielastic properties of sand subjected to cyclic triaxial and torsional loadings−was modified to more rationally evaluate the elastic components of sand in the general three-dimensional stress state. In the new simulation, the compliance matrix that links the stress and elastic strain increments in the principal stress axes was formulated symmetrically, as required by the law of thermodynamics. Comparisons between the simulation results and experimental data showed that the modified model could effectively simulate the experimental data values. Note that differences between the simulated values of compliance matrix [M] in the material axes obtained by both models were generally small within the employed stress paths, except the M26 and M62 values. The effect of inherent anisotropy on quasi-elastic components of the compliance matrix in the material axes was generally small at low shear stress ratio values (τzθ/σ′θ) during torsional loading from the isotropic stress state, and increased at larger shear stress ratio values, especially during torsional loading from the anisotropic stress state.
Keywordssand elasticity anisotropy shear modulus Young’s modulus Poisson’s ratio
Unable to display preview. Download preview PDF.
- Hardin, B. O. (1978). “The nature of stress-strain behavior of soils.” Proc., Geotech. Engg. Div. Specialty Conf. on Earthquake Engg. and Soil Dynamics, ASCE, Pasadena, CA, USA, Vol. 1, pp. 3–90.Google Scholar
- Hardin, B. O. and Richart, F. E., Jr. (1963). “Elastic wave velocities in granular soils.” Journal of Soil Mechanics and Foundation Division, ASCE, Vol. 89, No. 1, pp. 33–65.Google Scholar
- HongNam, N., Koseki, J., and Sato, T. (2008). “Effect of specimen size on quasi-elastic properties of Toyoura sand in hollow cylinder triaxial and torsional shear tests.” Geotechnical Testing Journal, ASTM, Vol. 31, No. 2, pp. 132–144, DOI: 10.1520/GTJ100022.Google Scholar
- Jardine, R. J. (2013). “Advanced laboratory testing in research and practice.” 2nd Bishop Lecture, 18th Conf. on Soil Mechanics and Geotechnical Engineering, Presses des Ponts, Paris, France, pp. 25–55.Google Scholar
- Roesler, S. K. (1979). “Anisotropic shear modulus due to stress anisotropy.” Journal of Geotechnical Engineering, ASCE, Vol. 105, No. 7, pp. 871–880.Google Scholar
- Tatsuoka, F. (2011). “Laboratory stress-strain tests for developments in geotechnical engineering.” Proc. 5th Int. Symp. on Deformation Characteristics of Geomaterials, Seoul, Korea, Vol. 1, pp. 3–53.Google Scholar
- Tatsuoka, F., Ishihara, M., Uchimura, T., and Gomes Correia, A. (1999). “Non-linear resilient behavior of unbound granular materials predicted by the cross-anisotropic hypo-quasi-elasticity model.” Proc., Workshop on Modelling and Advanced Testing for Unbound Granular Materials, Lisbon, Portugal, pp. 197–204.Google Scholar
- Tatsuoka, F. and Kohata, Y. (1995). “Stiffness of hard soils and soft rocks in engineering applications.” Proc., International Symposium on Pre-failure Deformation of Geomaterials, Sapporo, Japan, Vol. 2, pp. 947–1063.Google Scholar