Abstract
Doubts have been raised on whether the car industry will manage to reach the goal set by the Voluntary Agreement with the European Commission, unless tougher measures are taken to reduce CO2 emissions. Taking a stance from the concept of downsizing, we study the historical development of two strategies: first, shifting the market toward smaller cars, market downsizing; second, a technical downsizing, i.e., technical improvements that have enabled a reduction of engine size. We focus on the Swedish new car market from 1975 to 2002. Analysis is done by combining sales statistics with databases over car model parameters. The development of the top and bottom 10% and 20% of the car market of various parameters points to an increased differentiation of the market; still, the market share of small models remains low. We identify the potential for downsizing created by increase of maximum specific torque and power and conclude that these have enabled the cylinder volume to stabilize around 2 l. Increase in engine size has also partly been dampened by the utilization of supercharging. The potential savings of fuel use presented by the introduction of a sixth gear in manual gearboxes have not materialized since gearshifts have not systematically been used to lower engine speed. We conclude that there are few signs of a downsizing in the Swedish new car fleet. From a market perspective, larger cars are still dominant and the technical potentials to reduce engine size have not been harnessed.
Similar content being viewed by others
Notes
The index has been developed by an independent Swedish company (Autograph-bilfakta AB) which successively measures and publishes data on most new commercially available car models in Sweden. The index is a sum (in millimeter) of nine passenger volume measures all adhering to the international Society of Automotive Engineers standard.
All fuel consumption values are in accordance with the European Union NEDC drive cycle. For a description of how these values have been computed, see Sprei et al. (2008).
Between 1985 and 1995, there is no real change in maximum torque per mass unit.
References
Blechingberg, M. (1999). Energiframtid i backspegeln. Sveriges energianvändning sedan 1975. Uppföljning av Energi – till vad och hur mycket. Master Thesis. Göteborg, Sweden: Physical Resource Theory, Chalmers University of Technology (In Swedish).
Boyd, H., & Mellman, R. (1980). The effect of fuel economy standards on the U.S. automotive market: A hedonic demand analysis. Transportation Research Part A, 14A, 367–378.
Cardell, N. S., & Dunbar, F. C. (1980). Measuring the societal impacts of automobile downsizing. Transportation Research Part A, 14A, 423–434.
Crandall, R. W., Gruenspecht, H. K., Keeler, T. E., & Lave, L. B. (1986). Regulating the automobile. Washington, DC: The Brooking Institution.
DeCicco, J., An, F., & Ross, M. (2001). Technical options for improving the fuel economy of U.S. cars and light trucks by 2010–2015. Washington DC: American Council for an Energy-Efficient Economy.
European Automobile Manufacturers’ Association [ACEA] (2008). ACEA Tax Guide 2008. http://www.acea.be/index.php/news/news_detail/acea_tax_guide_2008/. Accessed 20 May 2008.
European Commission [EC] (1995). A community strategy to reduce CO2 emissions from passenger cars and improve fuel economy. European Commission, COM(95) 689 final, 20/12/1995. Brussels: European Commission.
European Commission [EC] (1999). Commission recommendation of 5 February 1999 on the reduction of CO2 emissions from passenger cars. Brussels: European Commission http://ec.europa.eu/environment/co2/99125/en.pdf. Accessed 25 March 2008.
European Commission [EC] (2006). Monitoring of ACEA’s commitment on CO2 emission reductions from passenger cars (2004). Joint report of the European Automobile Manufacturers Association and the Commission Services. COM (2006) 463 final. Brussels: European Commission.
Fontaras, G., & Samaras, Z. (2007). A quantitative analysis of the European automakers’ voluntary commitment to reduce CO2 emissions from new passenger cars based on independent experimental data. Energy Policy, 31(4), 2239–2246. doi:10.1016/j.enpol.2006.07.012.
Greene, D. (1998). Why CAFE worked. Energy Policy, 26, 595–613. doi:10.1016/S0301-4215(98)00016-0.
Greene, D., & Liu, J.-T. (1988). Automotive fuel economy improvements and consumer surplus. Transportation Research Part A, 22A, 203–218. doi:10.1016/0191-2607(88)90037-4.
Kutlar, O. A., Hikmet, A., & Calik, A. T. (2005). Methods to improve efficiency of four stroke, spark ignition engines at part load. Energy Conversion and Management, 46, 3202–3220. doi:10.1016/j.enconman.2005.03.008.
Kågeson, P. (2005). Reducing CO2 emissions from new cars, a progress report on the car industry’s voluntary agreement and an assessment of the need for policy instruments. Brussels: T & E—European Federation for Transport and Environment.
Lecointe, B., & Monnier, G. (2003). Downsizing a gasoline engine using turbocharging with direct injection. SAE Technical Paper Series, 2003-01-0542.
Leduc, P., Dubar, B., Ranini, A., & Monnier, G. (2003). Downsizing of gasoline engine: An efficient way to reduce CO2 emissions. Oil & Gas Science and Technology—Rev. IFP, 58(1), 115–127.
Petitjean, D., Bernardini, L., Middlemass, C., & Shahed, S. M. (2004). Advanced gasoline engine turbocharging technology for fuel economy improvements. SAE Technical Paper Series, 2004-01-0988.
Ross, M. (1994). Automobile fuel consumption and emissions: Effects of vehicle and driving characteristics. Annual Review of Energy and the Environment, 19, 75–112. doi:10.1146/annurev.eg.19.110194.000451.
Sprei, F., Karlsson, S., & Holmberg, J. (2008). Better performance or lower fuel consumption? Technological development in the Swedish new car fleet 1975–2002. Transportation Research Part D, 13, 75–85.
U.S. Environmental Protection Agency [USEPA] (2007). Light-duty automotive technology and fuel economy trends: 1975 through 2007. (EPA420-R-07-008). Washington, DC: US Environmental Protection Agency.
Visnic, B., Banks, C., Winter, D., Murphy, T., & McClellan, B. (2006). WARD’S 10 best engines 2006. Ward’s Auto World, Jan 2006.
Acknowledgment
Funding from the AES program at the Swedish National Energy Administration is gratefully acknowledged. Thanks to Bilfakta AB, Vägverket, and Bengt Ogren at Volvo Car Corporation for providing data, Johanna Ivefors for invaluable work on the database, and John Holmberg for comments on the idea and manuscript.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sprei, F., Karlsson, S. The role of market and technical downsizing in reducing carbon emissions from the Swedish new car fleet. Energy Efficiency 1, 107–120 (2008). https://doi.org/10.1007/s12053-008-9016-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12053-008-9016-8