Skip to main content
Log in

Synthesis of molecular imprinted polymer nanoparticles followed by application of response surface methodology for optimization of metribuzin extraction from urine samples

  • Original Paper
  • Published:
Chemical Papers Aims and scope Submit manuscript

Abstract

A molecular imprinted polymer was prepared with precipitation polymerization technique and applied as a sorbent for selective extraction and enrichment of metribuzin herbicide prior to high performance liquid chromatography. Optimization of critical variables affecting the efficiency of molecularly imprinted solid-phase extraction (MISPE), such as sorbent mass, sample pH and flow rate of sample, volume, concentration, and flow rate of elution solvent was done by employing central composite design (CCD) of the response surface methodology. Two separate models were developed for the adsorption and recycling steps. The analysis of variance (ANOVA) demonstrated that, experimental data were excellently fitted to the proposed response models. The optimum operating conditions were: a sorbent mass of 25 mg, sample pH 6.19, sample flow rate of 2.15 mL/min, and a 5 mL portion of methanol/acetic acid with 92.7:7.3 (v/v) ratio and flow rate of 2.1 mL/min for the extraction process. Under the optimized conditions, the linear range was obtained from 20 to 120 µg/L (R2 = 0.999) and the lowest detectable concentration (LOD) and the lowest quantitative concentration (LOQ) were calculated as 5.75 and 19.86 µg/L, respectively. Finally, the designed MISPE method was successfully applied to determine trace amount of metribuzin in real samples. The diluted urine samples were spiked with metribuzin at 4 levels and extracted with recoveries ranging from 93.82 to 97.84% and the relative standard deviation (RSD) less than 4.8%.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3

Similar content being viewed by others

References

Download references

Acknowledgements

This research has been supported by Tehran University of Medical Sciences grant (Project no. 32438). The authors acknowledge the University and also the laboratory personnel of occupational health department for all valuable supports.

Funding

The authors received no specific funding for this work.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Seyed Jamaleddin Shahtaheri.

Ethics declarations

Conflict of interest

The authors declare that they have no conflict of interest.

Human and animal rights statement

This article does not contain any studies with human participants or animals performed by any of the authors.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Heravizadeh, O.R., Khadem, M., Nabizadeh, R. et al. Synthesis of molecular imprinted polymer nanoparticles followed by application of response surface methodology for optimization of metribuzin extraction from urine samples. Chem. Pap. 72, 3057–3068 (2018). https://doi.org/10.1007/s11696-018-0546-z

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11696-018-0546-z

Keywords

Navigation