Abstract
This paper discusses the typical corrosion anomalies likely to occur in the wet oil system of a Floating Storage and Offloading Vessel (FPSO). The root causes and operational mitigations are identified. A neural network is proposed for capturing relationships within the large volume and diversity of data and hence permit effective modelling of corrosion and integrity of specific piping sections. Novel mitigations which can minimize severity of wall loss for flowing lines include; corrosion modelling of separator fluids and consequent pressure and temperature adjustments and calculated partition coefficients P derived from corrosion inhibitor (CI) injection and residual lab data for first-pass assessment of the effectiveness of CI injections, hence providing adequate inhibition.
Similar content being viewed by others
References
H.M. Abd El-Lateef et al., Corrosion protection of steel pipelines against CO2 corrosion—a review. Chem. J. 2(2), 52–63 (2012)
R. Nyborg. CO2 corrosion models for oil and gas production systems. Corrosion 2010, NACE-10371, San Antonio, 14–18 March
S.S. Cross et al., Introduction to neural networks. The Lancet 346(8982), 1075–1079 (1995)
Guidance for corrosion management in oil and gas production and processing. Energy Institute, Oil & Gas UK, May 2008
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ifezue, D., Tobins, F.H. Corrosion in Wet Oil Piping: Root Cause Failure Analysis, Mitigation and Neural Networking. J Fail. Anal. and Preven. 16, 243–254 (2016). https://doi.org/10.1007/s11668-016-0075-4
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11668-016-0075-4