Failure Analysis of Wire Rope Used for Hoisting in Mining: A Case Study

Peer Reviewed

Abstract

Wire ropes are used in vast range of applications and many of the applications are safety critical. In the mining industry wire ropes are extensively used for hoisting/haulage. Due to the hostile operating load conditions, many wire ropes degrade in service. Fatigue of wires in rope in combination with other detrimental factors is frequently responsible for rope deterioration and premature failure during operation. In this paper the causes of failure of a wire rope used for hoisting in an Indian mine are determined with only a minimum level of information provided by the customer. Samples of the failed rope were obtained and analyzed and potential remedial measures to prevent such degradation are discussed.

Keywords

Catastrophic failure Failure analysis Martensite Mechanical testing Plastic deformation Torsion Wire breakage 

Notes

Acknowledgment

The authors express their sincere thanks to Dr. A. Sinha, Director, CMRI for his kind consent in allowing the paper to be published. The views expressed in this paper are of the authors and not by the institute they belong to.

References

  1. 1.
    Barer, R.D., Peters, B.F.: Why metals fail? Gordon and Breach Science Publisher (1991)Google Scholar
  2. 2.
    Basu, A.K., Mandal, N., Singh, M.K., Singh, T.N.: The impact of the surface quality factor in the performance behaviour of steel wire ropes for the mines. In: Conference Proceedings of the Wire Association International, Inc. Wire & Cable Technical Symposium (WCTS), 69th Annual Convention, Atlanta, Georgia, USA, May 1999, pp 211–216 (1999)Google Scholar
  3. 3.
    Basu, A.K., Ganguli, K.K., Ghosh, J.C., Chakraborty, R.P., Tarafdar, M.N.: Standardisation and safety in mining industry – I M & EJ August (1991)Google Scholar
  4. 4.
    Basu, A.K., Singh, M.K., Ganguli, K.K.: An analytical study into cases of failure of mining safety equipment. J. Mine, Metal Fuel, XLVII, special issue on MINE SAFETY; XLVII, 11, 273–278 (1999)Google Scholar
  5. 5.
    Basu, A.K., Singh, M.K.: Selection of wire ropes for economic use. In: Proceedings of World Conference ‘MassMin 2000’ held at Brisbane, Qld, Australia, 29 October–2 November 2000, pp. 903–910 (2000)Google Scholar
  6. 6.
    Dieter, G.E.: Mechanical Metallurgy, 2nd edn, pp. 11–16. McGraw Hill, Kogakusha Ltd., Tokyo (1961)Google Scholar
  7. 7.
    Dove, A.B. (ed.): Steel Wire Rope Handbook, vol II, pp. 10–17.The Wire Association Inc., Branford, Conn. (1972) Google Scholar
  8. 8.
    Metals Handbook, vol. 10, Failure Analysis and Prevention, 8th edn, pp. 10–29. American Society of Metals, ASM, Metal Park Ohio (1972)Google Scholar
  9. 9.
    Rope Man’s Hand Book. NCB, UKGoogle Scholar
  10. 10.
    Singh, M.K., Basu, A.K.: Relationship between tensile strength and torsion of a steel wire rope under different operational states in an Indian Mine. Wire J. Int. USA 36(6), 62–67 (2003). In: Proceedings of Wire & Cables Technical Symposium (WCTS) held at Wire Expo 2002 in Chicago, IL, pp. 8–13Google Scholar
  11. 11.
    Singh, M.K., Basu, A.K., Choudhary, S.P.: Failure of wire ropes – a few case studies. In: Proceedings of the International Conference on ‘Mining – Challenges of the 21st Century’, New Delhi, November 25–27, pp. 681–690 (1999)Google Scholar
  12. 12.
    Singh, M.K., Pathak, V.N., Mahto, A., Bandhopadhyay, C.: Failure of wire ropes used for hoisting in Indian Mines – a few case studies. In: Proceedings of an International Symposium on ‘Advances in Mining Technology and Management’ (AIMM 2005) held from November 30 to December 2, 2005, Indian Institute of Technology, Kharagpur, pp. 365–370 (2005)Google Scholar

Copyright information

© ASM International 2007

Authors and Affiliations

  • M. K. Singh
    • 1
  • A. Mahto
    • 2
  • R. N. Thakur
    • 3
  • A. Sinha
    • 4
  1. 1.Department of EngineeringCentral Mining Research InstituteDhanbadIndia
  2. 2.Department of Engineering, Material Testing SectionCentral Mining Research InstituteDhanbadIndia
  3. 3.Department of Engineering, Metallurgical LaboratoryCentral Mining Research InstituteDhanbadIndia
  4. 4.Director SectionCentral Mining Research InstituteDhanbadIndia

Personalised recommendations