Effect of Width of Kerf on Machining Accuracy and Subsurface Layer After WEDM
- 118 Downloads
Wire electrical discharge machining is an unconventional machining technology that applies physical principles to material removal. The material is removed by a series of recurring current discharges between the workpiece and the tool electrode, and a ‘kerf’ is created between the wire and the material being machined. The width of the kerf is directly dependent not only on the diameter of the wire used, but also on the machine parameter settings and, in particular, on the set of mechanical and physical properties of the material being machined. To ensure precise machining, it is important to have the width of the kerf as small as possible. The present study deals with the evaluation of the width of the kerf for four different metallic materials (some of which were subsequently heat treated using several methods) with different machine parameter settings. The kerf is investigated on metallographic cross sections using light and electron microscopy.
Keywordsaluminum 99.5 electrical discharge machining steel 16MnCr5 steel X210Cr12 surface layer titanium alloy Ti6-Al-4V WEDM width of kerf
This research has been financially supported by the Ministry of Education, Youth and Sports of the Czech Republic under the Project CEITEC 2020 (LQ1601). This part of work was carried out with the support of core facilities of CEITEC—Central European Institute of Technology under CEITEC—open access project, ID Number LM2011020, funded by Ministry of Education, Youth and Sports of the Czech Republic under the activity projects of major infrastructures for research, development, and innovations.
- 3.E.C. Jameson, Electrical Discharge Machining, 2001, ISBN 08-726-3521-X.Google Scholar
- 10.V. Parashar, A. Rehman, J.L. Bhagoria, and Y.M. Puri, Kerfs Width Analysis for Wire Cut Electro Discharge Machining of SS 304L Using Design of Experiments, Indian J. Sci. Technol., 2010, 3, p 369–373Google Scholar
- 15.K. Mouralova, Modernítechnologiedrátovéhoelektroerozivníhořezáníkovovýchslitin, Thesis. CERM, Brno, 2015, ISBN 80-214-2131-2.Google Scholar
- 16.J.A. McGeough, Advanced Methods of Machining, Springer, Berlin, 1988Google Scholar
- 18.K. Mouralova, J. Kovar, T. Prokes, J. Bednar, R. Matousek, and L. Klakurkova, Mendel J. Ser., 2016, 22, p 301–304.Google Scholar