Advertisement

Research on Chemical Intermediates

, Volume 40, Issue 7, pp 2553–2558 | Cite as

Influence of magnetic and dielectric loss of polymer composites containing magnetic flake particles (Sendust, Permalloy) on noise absorption in microstrip lines

  • Sung-Soo Kim
Article

Abstract

Magnetic and dielectric loss have been systematically controlled by using two kinds of high-permeability particles with different electrical conductivity (Sendust, Permalloy), and the effect of the magnetic and dielectric loss on the noise-absorbing properties has been investigated. Noise-absorbing sheets are composite materials of magnetic flake particles of high aspect ratio dispersed in a polymer matrix. The frequency dispersion of the complex permeability was almost the same for the Sendust and Permalloy composite specimens. However, the complex permittivity of the Permalloy composite (ε r′ ≈ 250, ε r″ ≈ 50) was much greater than that of the Sendust composite (ε r′ ≈ 70, ε r″ ≈ 0). Enhancement of the space-charge polarization between the highly conductive Permalloy particles results in the high values of ε r′ and ε r″. Due to the large dielectric loss of the Permalloy composite (in addition to its inherent magnetic loss), the bandwidth of noise absorption is increased, especially in the lower frequency region. Dielectric loss should be considered in the design of broad-bandwidth noise-absorbing composites.

Keywords

Noise absorption Magnetic particles Dielectric loss Polymer composites 

Notes

Acknowledgments

This research was supported by the Basic Research Program through the National Research Foundation of Korea (NRF) funded by the Ministry of Education, Science, and Technology (grant no. 2013R1A1A2A10005073 ).

References

  1. 1.
    S. Yoshida, M. Sato, E. Sugawara, Y. Shimada, J. Appl. Phys. 85, 4636 (1999)CrossRefGoogle Scholar
  2. 2.
    S.-T. Kim, H.-S. Cho, S.-S. Kim, IEEE Trans. Mag. 41, 3562 (2005)Google Scholar
  3. 3.
    O. Hashimoto, Y. Takase, S. Haga, Trans. IEICE Jpn. J86-B 113, 2487 (2003)Google Scholar
  4. 4.
    S. Yoshida, H. Ono, S. Ando, F. Tsuda, T. Ito, Y. Shimada, M. Yamaguchi, K.-I. Arai, S. Ohnuma, T. Masumoto, IEEE Trans. Magn. 37, 2401 (2001)CrossRefGoogle Scholar
  5. 5.
    K.H. Kim, M. Yamaguchi, K.-I. Arai, H. Nagura, S. Ohnuma, J. Appl. Phys. 93, 8002 (2003)CrossRefGoogle Scholar
  6. 6.
    S.-T. Kim, Y.-G. Park, S.-S. Kim, Met. Mater. Int. 14, 233 (2008)Google Scholar
  7. 7.
    S.S. Kim, S.B. Jo, K.I. Gueon, K.K. Choi, J.M. Kim, K.S. Churn, IEEE Trans. Magn. 27, 5462 (1991)CrossRefGoogle Scholar
  8. 8.
    S.-S. Kim, S.-T. Kim, Y.-C. Yoon, K.-S. Lee, J. Appl. Phys. 97, 10F905 (2005)Google Scholar
  9. 9.
    Y.-K. Park, K.-J. Yang, J. Kor, Inst. Elect. Electr. Mater. Eng. 9(1), 76 (1996)Google Scholar

Copyright information

© Springer Science+Business Media Dordrecht 2014

Authors and Affiliations

  1. 1.Department of Advanced Materials EngineeringChungbuk National UniversityCheongjuKorea

Personalised recommendations