Skip to main content
Log in

Influence of the Chemical Composition of Al/AlC/a-C:H Coatings on the Mechanical Properties of Magnesium Alloy AZ31

  • Published:
Metal Science and Heat Treatment Aims and scope

The composition of wear-resistant Al/AlC/a-C:H coatings deposited on a magnesium alloy by combination of radio frequency plasma assisted chemical vapor deposition and magnetron sputtering is studied. It is shown that the mechanical properties of the coatings vary depending on the composition of the amorphous C:H layers after changing the negative bias polarization of the process from 150 to 600 V; the carbon structure may be varied from a disordered one to a graphite one as well as the sp2/sp3 bonds ratio.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.
Fig. 7.

Similar content being viewed by others

References

  1. H. Pan, Y. Ren, H. Fu, et al., “Recent developments in rare-earth free wrought magnesium alloys having high strength: A Review,” J. Alloys Compd., 663, 321 – 331 (2016).

    Article  CAS  Google Scholar 

  2. G. Arruebarrena, “Weight reduction in aircraft by means of new magnesium castings,” Mater. Sci. Technol. Conf. Proc., 3, 13 – 20 (2005).

    Google Scholar 

  3. S. Dasa, A. Morales, and A. T. Alpasa, “Microstructural evolution during high temperature sliding wear of Mg – 3% Al – 1% Zn (AZ31) alloy,” Wear, 268, 94 – 103 (2010).

    Article  Google Scholar 

  4. B. Hengyong, M. Yandouzi, C. Lu, and B. Jodin, “Effect of heat treatment on the intermetallic layer of cold sprayed aluminum coatings on magnesium alloy,” Surf. Coat. Technol., 205, 4665 – 4671 (2011).

    Article  Google Scholar 

  5. B. S. DeForce, T. J. Eden, and J. K. Potter, “Cold spray Al – 5% Mg coatings for the corrosion protection of magnesium alloys,” J. Therm. Spray Technol., 20, 1352 – 1358 (2011).

    Article  CAS  Google Scholar 

  6. Z. Zhang, G. Yu, Y. Ouyang, et al., “Studies on influence of zinc immersion and fluoride on nickel electroplating on magnesium alloy AZ91D,” Appl. Surf. Sci., 255, 7773 – 7779 (2009).

    Article  CAS  Google Scholar 

  7. K. Dong, Y. Song, D. Shan, and E. H. Han, “Formation mechanism of a self-sealing pore micro-arc oxidation on AM60 magnesium alloy,” Surf. Coat. Technol., 266, 188 – 196 (2015).

    Article  CAS  Google Scholar 

  8. H. Gaoa, M. Zganga, X. Yangb, et al., “Effect of Na2SiO3 solution concentration of micro-arc oxidation process on lap-shear strength of adhesive-bonded magnesium alloys,” Appl. Surf. Sci., 314, 447 – 452 (2014).

    Article  Google Scholar 

  9. O. Tazegul, F. Muhaffel, O. Meydanoglu, et al., “Wear and corrosion characteristics of novel alumina coatings produced by micro arc oxidation on AZ91D magnesium alloy,” Surf. Coat. Technol., 258, 168 – 173 (2014).

    Article  CAS  Google Scholar 

  10. A. Kielbus, “Microstructure and properties of sand casting magnesium alloys for elevated temperature applications,” Solid State Phenom., 176, 63 – 74 (2011).

    Article  CAS  Google Scholar 

  11. Z. Li, O. Wang, A. A. Luo, et al., “Fatigue strength dependence on the ultimate tensile strength and hardness in magnesium alloys,” Int. J. Fatigue, 80, 468 – 476 (2015).

    Article  CAS  Google Scholar 

  12. S. Dong, Y. Jiang, J. Dong, et al., “Cyclic deformation and fatigue of extruded ZK60 magnesium alloy with aging effects,” Mater. Sci. Eng. A, 615, 262 – 272 (2014).

    Article  CAS  Google Scholar 

  13. A. Zafari, H. M. Ghasemi, and R. Mahmudi, “Tribological behaviour of AZ91D magnesium alloy at elevated temperatures,” Wear, 292 – 293, 33 – 40 (2012).

  14. Y. Maoa, Z. Li, K. Feng, et al., “Preparation, characterization and wear behavior of carbon coated magnesium alloy with electroless plating nickel interlayer,” Appl. Surf. Sci., 327, 100 – 106 (2015).

    Article  Google Scholar 

  15. Y. S. Zou, Y. F. Wu, H. Yang, et al., “The microstructure, mechanical and friction properties of protective diamond line carbon films on magnesium alloy,” Appl. Surf. Sci., 258, 1624 – 1629 (2011).

    Article  CAS  Google Scholar 

  16. S. Jonas, K. Kyzioł, J. Lis, and K. Tkacz-OEmiech, “Stability of a-C:N:H layers by RF plasma enhanced CVD,” Solid State Phenom., 147 – 149, 738 – 743 (2009).

  17. D. Kottfer, M. Marton, M. Ferdinandy, et al., “A study of structural and wear properties of PACVD deposited a-C:H thin films for application as protective layers on Al alloys,” Phys. Status Solidi A, 212(10), 2271 – 2277 (2015).

    Article  CAS  Google Scholar 

  18. K. Kyzioł, S. Kluska, M. Januoe, et al., “Chemical composition and selected mechanical properties of Al – Zn alloy modified in plasma conditions by RF CVD,” Appl. Surf. Sci., 311, 33 – 39 (2014).

    Article  Google Scholar 

  19. Ł. Kaczmarek, M. Stegliñski, J. Sawicki, et al., “Optimization of the heat treatment and tribological properties of 2024 and 7075 aluminum alloys,” Arch. Metall. Mater., 58(2), 535 – 540 (2013).

    Article  CAS  Google Scholar 

  20. G. M. Pharr and W. C. Oliver, “An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments,” J. Mater. Res., 7, 613 – 617 (1992).

    Article  CAS  Google Scholar 

  21. L. Marcinauskas, A. Grigonis, H. Manikowski, and V. Valincius, “Deposition of amorphous hydrogenated carbon coatings by plasma jet,” Acta Phys. Pol. A, 113, 1063 – 1066 (2008).

    Article  CAS  Google Scholar 

  22. J. Coates, Encyclopedia of Analytical Chemistry: Interpretation of Infrared Spectra, a Practical Approach, John Wiley & Sons Ltd (2000).

  23. P. J. Fallon, V. S. Veerasamy, C. A. Davis, et al., “Properties of filtered-ion-beam-deposited diamond-like carbon as a function of ion energy,” Phys. Rev. B, 48, 4777 – 4782 (1993).

    Article  CAS  Google Scholar 

  24. J. Robertson, “Diamond-like amorphous carbon,” Mater. Sci. Eng., 37, 129 – 281 (2001).

    Article  Google Scholar 

  25. G. Socrates, Infrared and Raman Characteristic Group Frequencies, John Wiley & Sons Ltd (2004).

  26. M. Hesse, H. Meier, and B. Zeeh, Spektroskopische Methoden in der Organischen Chemie, Georg Thieme Verlag (2005).

  27. Spectroscopic Tools, Online software, http://www.science-andfun.de/tools/.

  28. A. C. Ferrari, “Determination of bonding in diamond-like carbon by Raman spectroscopy,” Diam. Rel. Mat., 11, 1053 – 1061 (2002).

    Article  CAS  Google Scholar 

  29. A. C. Ferrari and J. Robertson, “Interpretation of Raman spectra of disordered and amorphous carbon,” Phys. Rev., 61(20), 14095 – 14107 (2000).

    Article  CAS  Google Scholar 

  30. H. Li, T. Xu, C. Wang, et al., J. Phys. Appl. Phys., 38, 62 – 69 (2005).

    Article  CAS  Google Scholar 

  31. L. Rosenberger, R. Baird, E. McCullen, et al., Surf. Interface Anal., 40, 1254 – 1261 (2008).

    Article  CAS  Google Scholar 

  32. W. J. Gammon, O. Kraft, A. C. Reilly, and B. C. Holloway, Carbon, 41, 1917 – 1923 (2003).

    Article  CAS  Google Scholar 

  33. C. Logofatu, C. C. Negrila, R. V. Ghita, et al., Crystalline Silicon – Properties and Uses, In Tech. (2001).

  34. K. Nose, Y. Sasaki, M. Kamiko, and Y. Mitsuda, Jpn. J. Appl. Phys., 51, 090127 (2012).

    Article  Google Scholar 

  35. G. Wu, W. Dai, H. Zheng, and A. Wang, Surf. Coat. Technol., 205(7), 2067 – 2073 (2010).

    Article  CAS  Google Scholar 

Download references

The present work has been supported by the Polish State Committee for Scientific Research (Project No. NN 507 269540) and by the European Commission in the framework of the ERA. Net RUS Plus Program (Project LIGHTMAT4SPACE: Lightweight Nanocrystalline Aluminum-Based Material for Space Applications; modelling and technology verification).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Ł. Kaczmarek.

Additional information

Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 7, pp. 31 – 37, July, 2018.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Kaczmarek, Ł., Klich, M., Tuta, W. et al. Influence of the Chemical Composition of Al/AlC/a-C:H Coatings on the Mechanical Properties of Magnesium Alloy AZ31. Met Sci Heat Treat 60, 443–449 (2018). https://doi.org/10.1007/s11041-018-0298-y

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11041-018-0298-y

Key words

Navigation