The current analysis is an effort to obtain the vibration characteristics of a cantilever rotor shaft with an extra mass added at the free end of the rotor shaft partially immersed in a viscous medium. This work is concentrated on the theoretical analysis of the natural frequency and amplitude of the spinning cantilever rotor shaft with addition mass using the influence coefficient method. The influence of fluid forces is studied using the Navier–Stokes equation. The gap ratio (ratio of the fluid-filled container radius to the shaft radius) and viscosity of the fluid are taken as the main variable parameters.MATLAB programming is used to obtain vibration behavior from the theoretical expressions. The obtained result from the numerical analysis is validated by the comparison of the results of experimental analysis.
Similar content being viewed by others
References
J. Wauer, “On the dynamics of cracked rotors: A literature survey,” Appl. Mech. Rev., 43, No. 1, 13–17 (1990).
S. G. Kadyrov, J. Wauer, and S. V. Sorokin, “A potential technique in the theory of interaction between a structure and a viscous, compressible fluid,” Arch. Appl. Mech., 71, 405–417 (2001).
W. H. Walston, W. F. Ames, and L. G. Clark, “Dynamic stability of rotating shafts in viscous fluids,” ASME J. Appl. Mech., 31, No. 2, 292–299 (1964).
C. A. Papadopoulos and A. D. Dimarogonas, “Coupled longitudinal and bending vibrations of a rotating shaft with an open crack,” J. Sound Vibr., 117, No. 1, 81–93 (1987).
W. M. Ostachowicz and M. Krawczuk, “Coupled torsional and bending vibrations of a rotor with an open crack,” Arch. Appl. Mech., 62, No. 3, 191–201 (1996).
R. Gasch, “A survey of the dynamic behaviour of a simple rotating shaft with a transverse crack,” J. Sound Vibr., 160, No. 2, 313–332 (1993).
R. J. Fritz, “The effects of an annular fluid on the vibrations of a long rotor. Part 1: Theory,” J. Basic Eng., 92, No. 4, 923–930 (1970).
L. Cho-Chung, L. Ching-Chao, T. Yuh-Shiou, and L. Wen-Hao, “The free vibration analysis of submerged cantilever plates,” Ocean Eng., 28, No. 9, 1225–1245 (2001).
J. C. Sol, “Vibration detection of a transverse crack in a rotating machine shaft,” Mecanique Materiaux Electricite, 371, 404–409 (1980).
C. Brennen, “On the flow in an annulus surrounding a whirling cylinder,” J. Fluid Mech., 75, No. 1, 173–191 (1976).
W. H. Walston, W. F. Ames, and L. G. Clark, “Dynamic stability of rotating shafts in viscous fluids,” ASME, J. Appl. Mech., 31, No. 2, 292–299 (1964).
J. D. Achenbach and J. Qu, “Resonant vibrations of a submerged,” J. Sound Vibr., 105, No. 2, 185–198 (1986).
Q. Han and F. Chu, “Dynamic instability and steady-state response of an elliptical cracked shaft,” Arch. Appl. Mech., 82, 709–722 (2012).
S. Xiaohui, L. Wenxiu, and C. Fulei, “Dynamic analysis of rectangular plates with a single side crack and in contact with water on one side based on the Rayleigh–Ritz method,” J. Fluids Struct., 34, 90–104 (2012).
A. Hossain, L. Humphrey, and A. Mian, “Prediction of the dynamic response of a mini-cantilever beam partially submerged in viscous media using finite element method,” Finite Elem. Anal. Des., 48, 1339–1345 (2012).
M. Shahgholi, S. E. Khadem, and S. Bab, “Free vibration analysis of a nonlinear slender rotating shaft with simply support conditions,” Mech. Mach. Theor., 82, 128–140 (2014).
N. P. Catherine, A. I. Matteo, and P. Maurizio, “Finite amplitude vibrations of cantilevers of rectangular cross sections in viscous fluids,” J. Fluids Struct., 40, 52–69 (2013).
Author information
Authors and Affiliations
Corresponding author
Additional information
Published in Prikladnaya Mekhanika, Vol. 56, No. 5, pp. 136–144, September–October 2020.
Rights and permissions
About this article
Cite this article
Yadao, A.R. Experimental Verification of Effect of Different Fluid Properties on the Vibration Response of a Cantilever Rotor. Int Appl Mech 56, 643–651 (2020). https://doi.org/10.1007/s10778-020-01041-7
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10778-020-01041-7