Failure of Fractional Horsepower Ventilation Fan Motors

Article
  • 16 Downloads

Abstract

Fractional horsepower motors are used to power exhaust fans such as those found in bathrooms and oven hoods. There was an increase in fires attributed to these motors shortly after the year 2000. Still, many argue that these motors cannot cause fires because they contain a thermal cutoff (TCO) unit that shuts off electrical current when the TCO reaches a specific temperature. In this paper we describe an unsafe failure mode that can occur after extended use. As fans age, the bearings wear out, resulting in heating of the coil wires. Excessive heating results in break down of the wire insulation, which can lead to a short between wires and create an autotransformer configuration. An autotransformer can support high current in only part of the wiring, resulting in resistive heating sufficient for ignition. With the low thermal conductivity of the coil (\(0.0162\,W/(\hbox {cm}\,{^{\circ }}\hbox {C})\)) and the poor performance of the TCO (no cutoff up to \(260{^{\circ }}\hbox {C}\)), a large temperature gradient is possible. The gradient allows for ignition in one part of the motor without activating the TCO. We experimentally validated the proposed mechanism in an isolated motor and a complete fan assembly resulting in ignition after 18 s and 23 s. The assembled fan burned for more than 6 minutes before we extinguished the flames for safety reasons. Our results are consistent with field results from actual fires.

Keywords

Ventilation fan Shaded-pole motor Thermal protection device Arcing Ignition 

References

  1. 1.
    Hall Jr JR (2013) Home electrical fires. Technical report, National Fire Protection AssociationGoogle Scholar
  2. 2.
    Hall Jr JR (2012) Home fires involving air condition, fans or related equipment. Technical report, National Fire Protection AssociationGoogle Scholar
  3. 3.
    MacLeod K (2015) 7 killed in Lowell fire remembered on anniversary. CBS Boston Online, July 2015Google Scholar
  4. 4.
    Elder AT, Squires T, Busuttil A (1996) Fire fatalities in elderly people. Age Ageing 25(3):214–216CrossRefGoogle Scholar
  5. 5.
    Warda L, Tenenbein M, Moffatt MEK (1999) House fire injury prevention update. Part I. A review of risk factors for fatal and non-fatal house fire injury. Inj Prev 5(2):145–150CrossRefGoogle Scholar
  6. 6.
    Delonno A (2004) All controls are not created equal: thermal cutoffs require extra consideration. Prof Saf 49(10):47, 10Google Scholar
  7. 7.
    Lewis KH, Scheiff S, Challman T, Murphy D, Thoresen A (2015) Ventilation fan fires: overheated windings lead to failed thermal limit switch. Fire Technol 51(5):1033–1050CrossRefGoogle Scholar
  8. 8.
    Wise S, Cardwell R (2015) The warning firefighters want you to hear about bathroom exhaust fans. CBS WTVR Online, February 2015.Google Scholar
  9. 9.
    Monfort A (2015) Firefighters warn about bathroom fan fire danger. NBC12 Online, February 2015.Google Scholar
  10. 10.
    Lawrie RJ (ed) (1987) Electric motor manual. McGraw-Hill Book Company, New YorkGoogle Scholar
  11. 11.
    Geiger, GH, Poirier, DR (1973) Transport phenomenon in metallurgy. Addison-Wesley, ReadingGoogle Scholar
  12. 12.
    Byron BR, Stewart WE, Lightfoot EN (1960) Transport phenomena. Wiley, New YorkGoogle Scholar
  13. 13.
    NFPA 921: Guide for fire and explosion investigations. Technical report, National Fire Protection Association (2014)Google Scholar
  14. 14.
    Davis JR (1998) Metals handbook, 2nd Ed. ASM International, Materials Park, OHGoogle Scholar
  15. 15.
    Higgins RA (2010) Materials for engineers and technicians, 5th Ed. Elsevier, Burlington, MAGoogle Scholar
  16. 16.
    Drysdale D (1998) An introduction to fire dynamics. Wiley, New YorkGoogle Scholar
  17. 17.
    Ganguli TK (2005) Transformers chapter introduction, McGraw-Hill, New York, pp 1–5.Google Scholar
  18. 18.
    Winders Jr JJ (2002) Power transformers. Marcel Dekker Inc, New YorkCrossRefGoogle Scholar
  19. 19.
    Singh RK (2005) Transformers chapter principles of transformers. McGraw-Hill, New York, pp 6–33Google Scholar
  20. 20.
    Feinberg R (ed) (1979) Modern power transformer practice. Wiley, New YorkGoogle Scholar
  21. 21.
    Rawat BL (2005) Transformers chapter transformer protection. McGraw-Hill, New York, pp 456–465Google Scholar
  22. 22.
    National Electrical Manufacturers Association (NEMA) MG 1-2016 Motors and GeneratorsGoogle Scholar
  23. 23.
    Menges G, Osswald TA (2013) Material science of polymers for engineers. 3 edn. Hanser, MunichGoogle Scholar
  24. 24.
    Brancato EL (1992) Estimation of lifetime expectancies of motors. IEEE Electr Insul Mag, 8(3):5–13CrossRefGoogle Scholar
  25. 25.
    DeHaan JD (2002) Kirk’s fire investigation. 5th edn. Prentice Hall, Englewood CliffsGoogle Scholar
  26. 26.
    Lee A (2017) CPSC staff assessment on eutectic-type thermal-cutoff fuse failures in shaded-pole motors used in exhaust fans. Consumer Product Safety Commission, Directorate for Engineering SciencesGoogle Scholar

Copyright information

© Springer Science+Business Media, LLC, part of Springer Nature 2018

Authors and Affiliations

  1. 1.Massachusetts Institute of TechnologyCambridgeUSA

Personalised recommendations