Cellulose

pp 1–12 | Cite as

Preparation of cellulose colloidal particles in aqueous solution with good photochromic and photoluminescent performances by grafting a spiropyran derivative onto filter paper cellulose

Original Paper
  • 49 Downloads

Abstract

The cellulose colloidal particles with good photochromic and photoluminescent performances had been developed in aqueous solution based on a spiropyran-grafted filter paper cellulose (SP–cellulose) in this study. The insoluble filter paper cellulose dramatically became soluble in ethanol after grafting a spiropyran derivative onto its backbone via esterification. During this process, the optical properties of the spiropyran had been successfully inherited. With the aid of ultraviolet and visible light, the obtained SP–cellulose colloidal particles showed light-induced tunability on both photochromism and photoluminescence, corresponding to the significant change of the spiropyran between weak polar ring-closed spiropyran and strong polar ring-opened zwitterionic merocyanine. Based upon this result, the SP–cellulose colloidal particles were finally obtained in water by follow-up dialysis process. In comparison to the pure spiropyran showing poor optical properties in mixed solvent of ethanol/water, the obtained SP–cellulose colloidal particles in water showed good photochromic and photoluminescent performances as well as fine stability. Considering also the raw material of filter paper being cheap and easy to get as well as the facile preparation process of the functional colloidal particles, our experimental results may bring about more promising applications of spiropyran species and water-insoluble cellulose in aqueous medium.

Keywords

Spiropyran Filter paper cellulose Colloidal particles Photochromism Photoluminescence 

Notes

Acknowledgments

This work is financially supported by the Natural Science Foundation of Shandong Province of China (ZR2018MB011).

Compliance with ethical standards

Conflict of interest

The authors declare that there is no conflict of interest.

Supplementary material

10570_2018_1844_MOESM1_ESM.docx (1 mb)
The synthetic process, FTIR spectrum, and 1H NMR spectrum of the SP–COOH, GPC data of the SP–Cellulose, details of calculation about the grafting rate and the degree of substitution of the SP–Cellulose, relative fluorescence quantum yield of SP–COOH and SP–cellulose samples in different solvents, and other supplementary data are given (DOCX 1050 kb)

References

  1. Abdollahi A, Rad JK, Mahdavian AR (2016) Stimuli-responsive cellulose modified by epoxy-functionalized polymer nanoparticles with photochromic and solvatochromic properties. Carbohydr Polym 150:131–138CrossRefGoogle Scholar
  2. Bletz M, Pfeifer-Fukumura U, Kolb U, Baumann W (2002) Ground-and first-excited-singlet-state electric dipole moments of some photochromic spirobenzopyrans in their spiropyran and merocyanine form. J Phys Chem A 106:2232–2236CrossRefGoogle Scholar
  3. Chen L, Wang W, Su B, Wen Y, Li C, Zhou Y, Li M, Shi X, Du H, Song Y, Jiang L (2014a) A light-responsive release platform by controlling the wetting behavior of hydrophobic surface. ACS Nano 8:744–751CrossRefGoogle Scholar
  4. Chen L, Wu J, Schmuck C, Tian H (2014b) A switchable peptide sensor for real-time lysosomal tracking. Chem Commun 50:6443–6446CrossRefGoogle Scholar
  5. Fissi A, Pieroni O, Ruggeri G, Ciardelli F (1995) Photoresponsive polymers. Photomodulation of the macromolecular structure in poly (L-lysine) containing spiropyran units. Macromolecules 28:302–309CrossRefGoogle Scholar
  6. Gericke M, Trygg J, Fardim P (2013) Functional cellulose beads: preparation, characterization, and applications. Chem Rev 113:4812–4836CrossRefGoogle Scholar
  7. Hammarson M, Nilsson J, Li S, Beke-Somfai T, Andréasson J (2013) Characterization of the thermal and photoinduced reactions of photochromic spiropyrans in aqueous solution. J Phys Chem B 117:13561–13571CrossRefGoogle Scholar
  8. Hu W, Liu S, Chen S, Wang H (2011) Preparation and properties of photochromic bacterial cellulose nanofibrous membranes. Cellulose 18:655–661CrossRefGoogle Scholar
  9. Hufendiek A, Barner-Kowollik C, Meier MAR (2015) Renewable, fluorescent, and thermoresponsive: cellulose copolymers via light-induced ligation in solution. Polym Chem 6:2188–2191CrossRefGoogle Scholar
  10. Johns VK, Wang Z, Li X, Liao Y (2013) Physicochemical study of a metastable-state photoacid. J Phys Chem A 117:13101–13104CrossRefGoogle Scholar
  11. Joubert F, Musa OM, Hodgson DR, Cameron NR (2014) The preparation of graft copolymers of cellulose and cellulose derivatives using ATRP under homogeneous reaction conditions. Chem Soc Rev 43:7217–7235CrossRefGoogle Scholar
  12. Klajn R (2014) Spiropyran-based dynamic materials. Chem Soc Rev 43:148–184CrossRefGoogle Scholar
  13. Kohl-Landgraf J, Braun M, Özçoban C, Gonçalves DP, Heckel A, Wachtveitl J (2012) Ultrafast dynamics of a spiropyran in water. J Am Chem Soc 134:14070–14077CrossRefGoogle Scholar
  14. Kumari S, Chauhan GS (2014) New cellulose–lysine schiff-base-based sensor–adsorbent for mercury ions. ACS Appl Mater Interfaces 6:5908–5917CrossRefGoogle Scholar
  15. Li YJ, Tseng YT, Unnikrishnan B, Huang CC (2013) Gold-nanoparticles-modified cellulose membrane coupled with laser desorption/ionization mass spectrometry for detection of iodide in urine. ACS Appl Mater Interfaces 5:9161–9166CrossRefGoogle Scholar
  16. Markworth PB, Adamson BD, Coughlan NJA, Goerigk L, Bieske EJ (2015) Photoisomerization action spectroscopy: flicking the protonated merocyanine–spiropyran switch in the gas phase. Phys Chem Chem Phys 17:25676–25688CrossRefGoogle Scholar
  17. Mi W, Tian W, Tian J, Jia J, Liu X, Dai J, Wang X (2013) Synthesis of CdSe quantum dots in ethanol: a facile way to achieve photoluminescence with high brightness. Coll Surf A 417:179–182CrossRefGoogle Scholar
  18. Nilsson JR, Li S, Onfelt B, Andreasson J (2011) Light-induced cytotoxicity of a photochromic spiropyran. Chem Commun 47:11020–11022CrossRefGoogle Scholar
  19. Paramonov SV, Lokshin V, Fedorova OA (2011) Spiropyran, chromene or spirooxazine ligands: insights into mutual relations between complexing and photochromic properties. J Photochem Photobiol C 12:209–236CrossRefGoogle Scholar
  20. Pinkert A, Marsh KN, Pang S, Staiger MP (2009) Ionic liquids and their interaction with cellulose. Chem Rev 109:6712–6728CrossRefGoogle Scholar
  21. Rad JK, Mahdavian AR (2016) Preparation of fast photoresponsive cellulose and kinetic study of photoisomerization. J Phys Chem C 120:9985–9991CrossRefGoogle Scholar
  22. Rad JK, Mahdavian AR (2017) Photoswitchable dual-color fluorescent particles from seeded emulsion polymerization and role of some affecting parameters on FRET process. Eur Polym J 88:56–66CrossRefGoogle Scholar
  23. Roy D, Semsarilar M, Guthrie JT, Perrier S (2009) Cellulose modification by polymer grafting: a review. Chem Soc Rev 38:2046–2064CrossRefGoogle Scholar
  24. Schiphorst J, Broek M, Koning T, Murphy JN, Schenning APHJ, Esteves ACC (2016) Dual light and temperature responsive cotton fabric functionalized with a surface-grafted spiropyran–NIPAAm-hydrogel. J Mater Chem A 4:8676–8681CrossRefGoogle Scholar
  25. Tian W, Tian J (2014a) An insight into the solvent effect on photo-, solvato-chromism of spiropyran through the perspective of intermolecular interactions. Dyes Pigment 105:66–74CrossRefGoogle Scholar
  26. Tian W, Tian J (2014b) Synergy of different fluorescent enhancement effects on spiropyran appended onto cellulose. Langmuir 30:3223–3227CrossRefGoogle Scholar
  27. Wagner K, Byrne R, Zanoni M, Gambhir S, Dennany L, Breukers R, Higgins M, Wagner P, Diamond D, Wallace GG, Officer DL (2011) A multiswitchable poly (terthiophene) bearing a spiropyran functionality: understanding photo-and electrochemical control. J Am Chem Soc 133:5453–5462CrossRefGoogle Scholar
  28. Wang H, Gurau G, Rogers RD (2012) Ionic liquid processing of cellulose. Chem Soc Rev 41:1519–1537CrossRefGoogle Scholar
  29. Wang B, Chen K, Yang R, Yang F, Liu J (2014) Stimulus-responsive polymeric micelles for the light-triggered release of drugs. Carbohydr Polym 103:510–519CrossRefGoogle Scholar
  30. Xue Y, Tian J, Tian W, Gong P, Dai J, Wang X (2015) Significant fluorescence enhancement of spiropyran in colloidal dispersion and its light-induced size tunability for release control. J Phys Chem C 119:20762–20772CrossRefGoogle Scholar
  31. Zhao J, Lu C, He H, Zhang X, Zhang W (2015) Polyethylenimine-grafted cellulose nanofibril aerogels as versatile vehicles for drug delivery. ACS Appl Mater Interfaces 7:2607–2615CrossRefGoogle Scholar
  32. Zhu MQ, Zhu L, Han JJ, Wu W, Hurst JK, Li AD (2006) Spiropyran-based photochromic polymer nanoparticles with optically switchable luminescence. J Am Chem Soc 128:4303–4309CrossRefGoogle Scholar
  33. Zhu MQ, Zhang GF, Hu Z, Aldred MP, Li C, Gong WL, Chen T, Huang ZL, Liu S (2014) Reversible fluorescence switching of spiropyran-conjugated biodegradable nanoparticles for super-resolution fluorescence imaging. Macromolecules 47:1543–1552CrossRefGoogle Scholar

Copyright information

© Springer Science+Business Media B.V., part of Springer Nature 2018

Authors and Affiliations

  1. 1.School of Materials Science and EngineeringOcean University of ChinaQingdaoPeople’s Republic of China
  2. 2.State Key Laboratory for Marine Corrosion and ProtectionLuoyang Ship Material Research InstituteQingdaoPeople’s Republic of China
  3. 3.College of Materials Science and Chemical EngineeringHarbin Engineering UniversityHarbinPeople’s Republic of China

Personalised recommendations