Skip to main content

Advertisement

SpringerLink
Log in

Ultrasound grading of round Eucalyptus timber using the Brazilian standard

  • Original
  • Published:
European Journal of Wood and Wood Products Aims and scope Submit manuscript

Abstract

The structural use of round timber has been considered competitive in terms of both economics and sustainability due to the low energy consumption required for processing it. However, structural uses of wood in round and sawed forms require knowledge of wood properties, which makes the grading of these properties essential. In Brazil, an ultrasound grading standard for wood was proposed based on tests of lumber from tropical species with an average age of approximately 45 years. The objective of the present study was to evaluate whether the grades proposed by this standard could be used, either directly or by applying correction factors, to grade round timber derived from a planted Eucalyptus forest. For this evaluation, round timber with different diameters was tested using ultrasound at saturated moisture content (MC) greater than 30% and at environmental equilibrium (an MC of approximately 12%). Static bending tests were conducted only when the MC was at the environmental equilibrium (approximately 12%). Although it is necessary to validate the conclusions with a larger data set, the results indicate that due to the correlation between the diameter of round timber and its acoustic and mechanical properties, any round timber grading system must consider the diameter of the pieces. The larger the diameter of the round wood is, the greater the difference between the actual velocity in the log and the velocity expected by the grading standard that considers the stiffness.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8

Similar content being viewed by others

References

  • Amishev D, Murphy GE (2008) In-forest assessment of veneer grade Douglas-fir logs based on acoustic measurement of wood stiffness. For Prod J 58:42–47

    Google Scholar 

  • Bartholomeu A (2001) Classificação de peças estruturais de madeira através do ultra-som, (Ultrasound grading of wood beams), Dissertation, University of Campinas

  • Bertoldo C (2011) Estimativa de propriedades de rigidez da madeira a partir de avaliação acústica na árvore e em toras recém abatidas. (Acoustic assessment from the tree and the freshly-felled logs for estimating wood stiffness).Thesis (Master), University of Campinas

  • Bucur V (2006) Acoustics of Wood. Springer, Berlin

    Google Scholar 

  • Calil C Jr, Brito LD (2010) Manual de projeto e construção de estruturas com peças roliças de madeira de reflorestamento. (Manual of design and construction of structures with reforestation roundwood). University of São Paulo, São Carlos

    Google Scholar 

  • Carter P, Briggs D, Ross RJ, Wang X (2005) Acoustic testing to enhance western forest values and meet customer wood quality needs. Productivity of western forests: a forest products focus, Portland, OR: U.S. Dept. of Agriculture, Forest Service, Pacific Northwest Research Station. General technical report PNW; GTR-642, pp 121–129

  • EN 408 (2010) Structural timber and glued laminated timber. Determination of some physical and mechanical properties, CEN 2010

    Google Scholar 

  • Gonçalves R, Costa OL (2008) Influence of moisture content in longitudinal, radial and tangential ultrasonic velocity for two Brazilian wood species. Wood Fiber Sci 40(4):580–586

    Google Scholar 

  • Gonçalves R, Lorensani RGM, Negreiros TO, Bertoldo C (2017) Moisture-related adjustment factor to obtain a reference ultrasonic velocity in structural lumber of plantation hardwood. Wood Mater Sci Eng. https://doi.org/10.1080/17480272.2017.1313312

    Google Scholar 

  • Íñiguez-González G, Arriaga F, Esteban M, Llana DF (2015) Reference conditions and modification factors for the standardization of nondestructive variables used in the evaluation of existing timber structures. Constr Build Mater 101(2):1166–1171

    Article  Google Scholar 

  • Kretschmann D, Hernandez R (2006) Grading timber and glued structural members. Primary wood processing: principles and practice, Springer, cap.10, pp 339–390

  • Lobão MS, Lúcia RMD, Moreira MSS, Gomes A (2004) Caracterização das propriedades físico-mecânicas da madeira de eucalipto com diferentes densidades. (Characterization of physical and mechanical properties of Eucalyptus lumber with different specific gravities). Árvore 28(6):889–894

    Article  Google Scholar 

  • Lorensani RGM (2013) Classificação de peças estruturais de eucalipto utilizando ultrassom. (Mechanical classification of structural Eucalyptus pieces using ultrasound). Dissertation, University of Campinas

  • Molina JC (2009) Relatório final da caracterização dos eucaliptos. (Final Report on the characterization of Eucalyptus). Project: environmental education center (CEAM), Votorantin Metallurgy, Forest Factory

  • NBR 15521 (2007) Non-destructive testing—ultrasonic testing—mechanical classification of dicotyledonous sawn wood. ABNT—Brazilian Association of Technical Standards, Rio de Janeiro

    Google Scholar 

  • NBR 16202 (2013) Treated Eucalyptus utility poles for distribution lines—requirments. ABNT—Brazilian Association of Technical Standards, Rio de Janeiro

    Google Scholar 

  • NBR 7190 (1997) Design of wooden strucutres. ABNT—Brazilian Association of Technical Standards, Rio de Janeiro

    Google Scholar 

  • Pelizan TR (2004) Estudo de propriedades mecânicas de peças roliças de eucalipto citridora utilizando a técnica de ultra-som. (Study of mechanical properties of Eucalyptus citriodora round pieces using ultrasound technique). Dissertation, University of São Paulo

  • Rais A, Pretzsch H, Van De Kuilen J (2013) Roundwood pre-grading with longitudinal acoustic waves for production of structural boards. Eur J Wood Prod 72:87–98

    Article  Google Scholar 

  • Ranta-Maunus A (1999) Round small-diameter timber for constructions. Final Report of Project FAIR CT-95-0091. Technical Research Centre of Finland, Finand

    Google Scholar 

  • Sakai H, Minamisawa A, Takagi K (1990) Effect of moisture content on ultrasonic velocity and attenuation in woods. Ultrasonics 28:382–385

    Article  Google Scholar 

  • Sandoz JL (1990) Triage et fiabilité des bois de construction: validité de la méthode ultrason (Grading and reliability of construction timber, validation of the ultrasound method). Thesis, Federal Polytechnic School of Lausanne

  • Sandoz JL (1994) Ultrasound applications to structural timber. In: pacific timber engineering conference—PTEC´94. Gold Coast, Australia

    Google Scholar 

  • Tsehaye A, Buchanan AH, Walker JCF (1995) Stiffness and tensile strength variation within and between radiate pine trees. J Inst Wood Sci 13:513–518

    Google Scholar 

  • Tsehaye A, Buchanan AH, Walker JCF (2000) Sorting of logs using acoustics. Wood Sci Technol 34:337–344

    Article  CAS  Google Scholar 

  • Wang X (2013) Stress wave E-rating of structural timber-size and moisture content effects. Nondestructive testing and evaluation of wood symposium, 18th. Madison

  • Wang X, Ross RJ, Brashaw BK, Erickson JR, Forsman JW, Pellerin R (2004) Diameter effect on stress-wave evaluation of modulus of elasticity of logs. Wood Fiber Sci 36(3):368–377

    CAS  Google Scholar 

  • Wang X, Carter P, Ross RJ, Brashaw BK (2007) Acoustics assessment of wood quality of raw forest materials—a path to increased profitability. For Prod J 57:6–14

    Google Scholar 

  • Waubke NV (1981) Grundsätzliche Untersuchungen zur Eignung der Ultraschall-Impulslaufzeitmessungen als vereinfachte und genauere Methode zur Klassifikation von Bauhölzern. (Fundamental investigations on the suitability of ultrasound pulse duration measurements as simplified and accurate method for sorting timber). Institute for Materials Science and Physics of the University of the Bundeswehr Munich, Neubiberg

  • Waubke NV (1988) Einsatz der Ultraschall-Impulslaufzeitmessung für die Sortierung von Bauhölzern. (Use of flight time measurement for sorting timber). Holzbauforschung, Innsbruck Univ. (Austria), pp 152–154

    Google Scholar 

  • Wolfe R, Murphy J (2005) Strength of small-diameter round and tapered bending members. For Prod J 55:50–55

    Google Scholar 

  • Zangiácomo AL (2007) Estudo de elementos estruturais roliços de madeira. (Study of structural round timber). Thesis, University of São Paulo

  • Zangiácomo AL, Christoforo AL, Rocco Lahr FA (2013) Módulos de elasticidade longitudinal e transversal em vigas roliças de madeira de Corymbia citriodora. (Shear and longitudinal modulus of elasticity in Corymbia citriodora round timber beams). Vértices 15:63–68

    Article  Google Scholar 

Download references

Acknowledgements

Funding was provided by Fundação de Amparo à Pesquisa do Estado de São Paulo (Grant nos. 2012/22599-9, 2013/03449-9, 2015/05692-3) and scholarship by Conselho Nacional de Desenvolvimento Científico e Tecnológico (Grant no. 131853/2014-7).

Author information

Authors and Affiliations

  1. Laboratory of Nondestructive Testing, LabEND, College of Agricultural Engineering, FEAGRI, University of Campinas, UNICAMP, Av. Cândido Rondon, 501, Barão Geraldo, Campinas, São Paulo, Brazil

    Mônica Ruy, Raquel Gonçalves, Douglas Moraes Pereira, Rafael Gustavo Mansini Lorensani & Cinthya Bertoldo

Authors
  1. Mônica Ruy
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Raquel Gonçalves
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Douglas Moraes Pereira
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Rafael Gustavo Mansini Lorensani
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. Cinthya Bertoldo
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Raquel Gonçalves.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Ruy, M., Gonçalves, R., Pereira, D.M. et al. Ultrasound grading of round Eucalyptus timber using the Brazilian standard. Eur. J. Wood Prod. 76, 889–898 (2018). https://doi.org/10.1007/s00107-018-1292-1

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00107-018-1292-1

Search

Navigation