Abstract
TMP (thermo-mechanical pulps) and CTMP (chemo-thermo-mechanical pulps) were made from pine wood and recycling MDF, which has been prepared from pine wood too. The fibres were tested for their wettability using the method developed by Roffael et al (2002). The results reveal that TMP are much less wettable in comparison to CTMP from the same wood. Moreover, fibres made from UF-bonded MDF by the TMP- and CTMP-process are of much higher wettability compared to TMP and CTMP prepared directly from wood. No significant difference in the wettability between TMP and CTMP from UF-bonded MDF was detected. This behaviour has been attributed to the fact that the UF-resin in MDF degrades during thermohydrolytic pulping leading to the formation of ammonia and free urea. Therefore, pulping of UF-bonded boards takes place under chemo-thermo-mechanical conditions (CTMP).
Article PDF
Similar content being viewed by others
Literatur
Franke R, Roffael E (1998) Zum Recycling von Span- und MDF-Platten. Teil 2: Einfluss der thermischen Behandlung von zerkleinerten UF-gebundenen Span- und MDF-Platten sowie Kiefernspänen auf die Formaldehyd- und Ammoniakabgabe. Holz Roh- Werkst 56:381–385
Roffael E, Dix B, Schneider T (2002) Methode zur Erfassung der Benetzung von Holzfasern. Holz Roh- Werkst 60:347–348
Schneider T, Roffael E, Dix B, Erbreich M (2007) Zum Einfluss des Holzes sowie des Holzaufschlussverfahrens auf das Benetzungsverhalten von Kiefern- und Fichten-Faserstoffen. Holz Roh- Werkst 65:29–33
Verein der Zellstoff- und Papier-Chemiker und -Ingenieure (1976) Merkblatt V/8/76, Herstellung von Prüfblättern aus Halbstoffen mit Hilfe des Rapid-Köthen-Gerätes. Verein Zellcheming, Darmstadt
Author information
Authors and Affiliations
Corresponding author
Additional information
Förderung: Das Verbundvorhaben zwischen der Universität Göttingen, dem Fraunhofer-Institut für Holzforschung und dem Institut für Zellstoff und Papier der Papiertechnischen Stiftung wurde mit Mitteln des Bundesministeriums für Wirtschaft und Arbeit (BMWA) durch die Arbeitsgemeinschaft industrieller Forschungsvereinigungen (AiF-Nr. 14801 BG) über den Internationalen Verein für Technische Holzfragen (iVTH) gefördert.
Rights and permissions
Open Access This is an open access article distributed under the terms of the Creative Commons Attribution Noncommercial License (https://creativecommons.org/licenses/by-nc/2.0), which permits any noncommercial use, distribution, and reproduction in any medium, provided the original author(s) and source are credited.
About this article
Cite this article
Roffael, E., Dix, B., Behn, C. et al. Benetzung von TMP und CTMP aus Holz sowie gebrauchten mitteldichten Faserplatten (MDF) . Holz Roh Werkst 66, 389–390 (2008). https://doi.org/10.1007/s00107-008-0256-2
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00107-008-0256-2