Skip to main content
Log in

Morphological response of diamond films in dry sliding contact

  • Surface Modification
  • Research Summary
  • Published:
JOM Aims and scope Submit manuscript

Abstract

Reciprocating dry sliding friction tests performed on diamond-coated tungsten substrates produced changes in the surface morphology. A right-cylinder-on-flat geometry was used for the tribotesting. The morphological changes were investigated with scanning electron and atomic force microscopy. The composition of the diamond film was determined with Raman spectroscopy. The frictional response of the coating is examined in relation to the surface changes. A wear model for diamond films in dry sliding contact based on the morphological response is presented.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. M.T. Dugger, D.E. Peebles, and L.E. Pope, Surface Science Investigation in Tribology: Experimental Approaches, ACS Symposium Series No. 485, ed. Y.W. Chung, A.M. Homola, and G.B. Street (Washington, D.C.: American Chemical Society, 1992), p. 72.

    Chapter  Google Scholar 

  2. D. Tabor, The Properties of Diamond, ed. E. Field (New York: Academic Press, 1979), pp. 345–349.

    Google Scholar 

  3. P.J. Blau et al., Mechanics of Coatings, Leeds-Lyon 16, Tribology Series, 17, ed. D. Dowson, C.M. Taylor, and M. Godat (Amsterdam, the Netherlands: Elsevier Science B.V., 1990), pp. 399–407.

    Google Scholar 

  4. I.P. Hayward and I.L. Singer, 2nd Int. Conf. on the New Diamond Science and Technology, Washington, D.C. (September 25–27,1990).

    Google Scholar 

  5. M.N. Gardos and B.L. Soriano, Journal of Material Research, 5 (1990), pp. 2599–2609.

    Google Scholar 

  6. J.F. Braza and T.S. Sudarshan, Surface Modification Technologies V, ed. T.S. Sudarshan and J.F. Braza (London: The Institute of Materials, 1992), pp. 801–819.

    Google Scholar 

  7. I.P. Hayward, The Friction and Strength Properties of Diamond; Ph.D. thesis, U. of Cambridge (1987), pp. 71–94.

    Google Scholar 

  8. S. Jahanmir et al, Wear, 133 (1989), pp. 73–81

    CAS  Google Scholar 

  9. T. Evans, The Properties of Diamond, ed. E. Field (New York: Academic Press, 1979), pp. 403–423.

    Google Scholar 

  10. M.N. Gardos and B.L. Soriano, J. Mater. Res., 5 (1990), pp. 2599–2609.

    Google Scholar 

  11. I.P. Hayward, I.L. Singer, and L.E. Seitzman (Paper presented at the 17th Int. Conf. on Metallurgical Coatings and 8th Int. Conf. on Thin Films, San Diego, CA, April 2–6, 1990).

    Google Scholar 

  12. J.L. Davidson, C. Ellis and R. Ramesham, J. of Elec Mats, 18 (6) (1989) p. 711–715.

  13. M.L. Languell et al., Proceedings from the VIIth Int. Conf. on Surface Modification Technologies (Nagaoka, Japan: Nov. 1–3, 1993).

    Google Scholar 

  14. P.J. Blau, Friction and Weat Transitions of Materials (Park Ridge, NJ: Noyes Publications, New Jersey, 1989) p. 268.

    Google Scholar 

  15. R.L.C. Wu et al., Surface and Coating Technology, Vol. 62 (1993), pp. 589–594.

    CAS  Google Scholar 

  16. J. Wilks and E. Wilks, Properties and Applications of Diamond (Oxford, U.K.: Butterworth-Heinemann Ltd, 1991), pp. 245–248.

    Google Scholar 

  17. M.A. George et al., Journal of Applied Physics (submitted March 1994).

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Languell, M.L., George, M.A., Wert, J.J. et al. Morphological response of diamond films in dry sliding contact. JOM 46, 66–70 (1994). https://doi.org/10.1007/BF03220754

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF03220754

Keywords

Navigation