Advertisement

Acta Physica Academiae Scientiarum Hungaricae

, Volume 42, Issue 4, pp 283–287 | Cite as

The change of the load-microhardness curves of NaCl single crystals due to heat treatment and impurity

  • J. Sárkozi
  • A. Tóth
  • Z. Morlin
Article

Abstract

In order to determine the physical meaning of the constantsa andn in the equationH=1854·a·d n−2 describing the microhardness of the alkali halide crystals quenching experiments were carried out on NaCl: Ca systems. By means of combined electrical conductivity and microhardness measurements it was found that values of the constantsa andn depend on the concentration and state of impurities in the crystals. The results obtained show thata andn are not defined by the crystal type alone, but also by the type and concentration of impurity centres interacting with the dislocations.

Keywords

Impurity Concentration Microhardness Measurement Impurity State Crystal Type NaC1 Crystal 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. 1.
    G. P. Upit andS. A. Varchenya, phys. stat. sol.,17, 831, 1966.CrossRefGoogle Scholar
  2. 2.
    Z. Morlin, phys. stat. sol.,8, K77, 1965.CrossRefADSGoogle Scholar
  3. 3.
    R. Voszka, I. Tarján, L. Berkes andJ. Krajsovszky, Kristall und Technik,1, 423, 1966CrossRefGoogle Scholar

Copyright information

© with the authors 1977

Authors and Affiliations

  • J. Sárkozi
    • 1
  • A. Tóth
    • 1
  • Z. Morlin
    • 1
  1. 1.Institute of Physics Department of Experimental PhysicsTechnical UniversityBudapest

Personalised recommendations