Abstract
Air-lift bioreactors containing suspended or immobilized animal cells have been used for the production of a variety of high-value biologicals. In the bioprocessing industry, there is a need to study and quantify the relationships between bioreactor-system properties such as mixing, flow, mass transfer, and cell processes. In the present study, the performance of a 1-L external-loop air-lift bioreactor was investigated by studying gas-liquid oxygen transfer, mixing time, liquid velocity and gas hold-up at various aeration rates. These studies were performed over a range (0-25%) of loadings of small (500-800 μm) calcium alginate beads to investigate the effect of using various concentrations of cell immobilization matrices on the physical properties of the system. At an aeration rate of 0.5 vvm, the mixing time was decreased by 50%, from 75 s at 0% bead loading to 38 s at 10% bead loading. A minimum liquid velocity of 10 cm/s was required to keep the alginate beads in suspension. As bead loading increased, flow within the reactor went from turbulent conditions to the transition zone. At all bead loadings tested, the gas hold-up increased by only 2% with an increase in aeration rate from 0.1 to 1.0 vvm, regardless of whether the total reactor volume (i.e., liquid and beads) or the liquid volume was used in calculating the hold-up. A mathematical correlation was developed for expressing the dependence of the volumetric mass-transfer coefficient, k1a, on aeration rate (vvm) and microbead loading. With this equation it was possible to predict, within 20%, the k1a knowing the gas-flow rate and the volume percentage of microbeads present in the bioreactor. A theoretical study was also performed to calculate the oxygen transfer from the bulk liquid to the center of microcapsules containing animal cells using experimental k1a data. The results suggest that whereas there is no oxygen limitation at 10 to 15% microcapsule loading, there is a potential mass-transfer problem at 25% loading if the bioreactor is operated at an aeration rate of less than 1.06 vvm.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Phillips, T., Ball, G., Fantes, K., Finter, N., and Johnston, M. (1983),Chemtech 6, 433–435.
Thomsen, D. R., Meyer, A. L., and Port, L. E. (1993), inInsect Cell Culture Engineering, Goosen, M. F. A., Daugulis, A. J., and Faulkner, P., eds., Marcel Dekker, New York, pp. 105–138.
Groboillot, A., Boadi, D. K., Poncelet, D., and Neufeld, R. J. (1994), inCritical Review in Biotechnology, vol. 14(2), Stewart, G. G. and Russell, I., eds., CRC Press, New York, pp. 75–108.
Siegel, M. H., Hallaile, M., and Merchuk, J. C. (1988), inUpstream Processes: Equipment and Techniques, Liss, New York, NY, pp. 79–124.
Tramper, J., Degoijer, K. D., and Vlak, J. M. (1993), inInsect Cell Culture Engineering, Goosen, M. F. A., Daugulis, A. J., and Faulkner, P., eds., Marcel Dekker, New York, pp. 139–177.
Onken, U. and Weiland, P. (1980),Eur. J. Appl. Microbiol. Biotechnol. 10, 3140.
Jones, A. G. (1985),Chem. Eng. Sci. 40, 449–462.
Bugarski, B., King, G. A., Javanovic, G., Daugulis, A. J., Goosen, M. F. A., and Faulkner, P. (1989),Appl. Microbiol. Biotechnol. 30, 264–269.
Akita, K., Tatsuya, O., and Koyama, H. (1988),J. Chem. Eng. Japan 21, 476–482.
Chisti, M. Y. and Moo-Young, M. (1988),Chem. Eng. J. 38, 149–152.
Pavko, A. and Charles, M. (1988),Biotechnol. Lett. 10, 537–542.
Bello, R. A., Robinson, C. W., and Moo-Young, M. (1985),Biotechnol. Bioengineer. 27, 369–381.
Siegel, M. H. and Merchuk, J. C. (1988),Biotechnol. Bioeng. 32, 1128–1137.
Zilli, M., Fabiano, B., Ferraiolo, A., and Converti, A. (1996),Biotechnol. Bioeng. 49(4), 391–398.
Linek, V., Vacek, V., and Benes, P. (1987),Chem. Eng. J. 34, 11–34.
McCabe, W. L. and Smith, J. C. (1985),Units of Chemical Engineering, McGraw-Hill, New York, p. 602.
Heath, C. and Belfort, G. (1987),Adv. Biochem. Eng./Biotechnol. 34, 1–31.
Lin, C. H., Fang, B. S., Wu, C. S., Fang, H. Y., Kio, T. F. and Hu, C. Y. (1976),Biotechnology and Bioengineering,28, 1557–1572.
Van’t Riet, K. (1979),Ind. Eng. Chem. Process Des. Dev. 18, 357–364.
Deckwer, W. D., Burckhart, R., and Zoll, R. (1974),Chem. Eng. Sci. 29, 2177–2188.
Moo-Young, M. and Blanch, H. W. (1983),Biochem. Eng. 207, 335–354.
King, G. A., Daugulis, A. J., Faulkner, P., and Goosen, M. F. A. (1987),Biotechnol. Prog. 3, 231–240.
Willaert, R. G., De Backer, L., and Baron, G. V. (1996), inImmobilized Living Cell Systems: Modeling and Experimental Methods, Willaert, R. G., Baron, G. V., De Backer, L., eds., Wiley, Chichester, UK, pp. 21–46.
Singh, V., Hensler, W., Fuchs, R., and Constantinides, A. (1986),International Conference on Bioreactor Fluid Dynamics, April 15–17, 1986.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sharp, N.A., Daugulis, A.J. & Goosen, M.F.A. Hydrodynamic and mass transfer studies in an external-loop air-lift bioreactor for immobilized animal cell culture. Appl Biochem Biotechnol 73, 59–77 (1998). https://doi.org/10.1007/BF02788834
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02788834