Abstract
The development of Eurocode 5, the future European timber design code which is based on the partial safety coefficient method, means a change of timber design code formats in a number of european countries. Because of the change in the code format from allowable values towards partial safety coefficients, characteristic values of strength and stiffness of materials and connections are needed. In order to establish characteristic values of the strength and stiffness of tooth-plate connections, existing test data have been evaluated. The results of the evaluation correspond well to a calculation model assuming a load sharing between the connector and the bolt.
Zusammenfassung
Die Entwicklung von Eurocode 5, der zukünftigen europäischen Bemessungsnorm für Holzkonstruktionen, die auf der Methode der Teilsicherheitsbeiwerte basiert, bedeutet eine Änderung der Normenformate in einer Reihe von Ländern. Wegen dieses Wechsels des Normenformates von zulässigen Werten hin zu Teilsicherheitsbeiwerten ist die Kenntnis charakteristischer Werte der Tragfähigkeit und des Verformungsverhaltens von Baustoffen und Verbindungen notwendig. Vorhandene Versuchsergebnisse wurden ausgewertet, um die charakteristischen Werte der Tragfähigkeit und des Verformungsverhaltens von Einpreßdübelverbindungen zu bestimmen. Die Ergebnisse der Auswertung stimmen gut mit einem Rechenmodell überein, das ein Zusammenwirken von Einpreßdübel und Bolzen in der Verbindung voraussetzt.
Similar content being viewed by others
References
Frech, P. and Kolb, H.: Prüfung von BULLDOG-Holzverbindern Prüfzeugnis H 30471, Amtliche Forschungs- und Materialprüfungsanstalt für das Bauwesen, Universität Stuttgart 1971
Johansen, K. W.: Theory of timber connections. Internationall Association of Bridge and Structural Engineering. Publication 9 (1949) 249–262
Kuipers, J.: Inteidend onderzoek naar het draagvermogen van kramplaatverbindingen. Rapport 4-57-6-HV-10, Stevin-Laboratorium, Delft University of Technology, Netherlands 1957
Kuipers, J. and Vermeyden, P.: Onderzoek van kramplaatverbindingen—Beproevingsresultaten trekverbindingen met Bulldogkramplaten 75 mm en 95 mm. Rapport 4-61-16-K-1, Stevin-Laboratorium, Delft University of Technology, Netherlands 1961
Kuipers, J. and Kurstjens, P. B. J.: Creep and damage research on timber joints. Part one, Rapport 4-86-15-HD-23, Stevin-Laboratorium, Delft University of Technology, Netherlands 1986
Kurstjens, P. B. J.: Duurproeven ter bestudering van het verband tussen belastingduuren sterktebij houtverbindingen. Sterkteverminderingsproeven. Rapport 4-84-4-HD-21, Stevin-Laboratorium Delft University of Technology, Netherlands 1984
Kurstjens, P. B. J.: Creep and damage research on timber joints. Part two. Rapport 25.4-89-15/C/HD-24, Stevin-Laboratorium Delft University of Technology Netherlands 1989
Kurstjens, P. B. J.: Creep and damage research on timber joints. Part three. Rapport 25.4-90-12/C/HD-26, Stevin-Laboratorium, Delft University of Technology, Netherlands 1990
Kurstjens, P. B. J. and Stolle, P.: Creep and damage research on timber joints. Part four. Rapport 25.4-91-06/C/HD-28, Stevin-Laboratorium, Delft University of Technology, Netherlands 1991
Nielsen, T. F. and M. Johansen: Forsøg med træforbindelser med bolte og mellemlœg. SBI-rapport 67, Statens Byggeforskningsinstitut, Copenhagen, Denmark 1970
Vermeyden, P.: Duurproeven ter bestudering van het verband tussen belastingduur en sterkte bij houtverbindingen: bepaling van de breukbelastingen. Rapport 4-62-11-HD-10, Stevin-Laboratorium, Delft University of Technology, Netherlands 1962
Vermeyden P.: Literatuuronderzoek kramplaatverbindingen en voorstel onderzoek programma. Rapport 4-62-3-K-2, Stevin-Laboatorium, Delft University of Technology, Netherlands 1962
Vermeyden, P.: Proeven op kramplaatverbindingen. Rapport 4-63-13-K-3, Stevin-Laboratorium, Delft University of Technology, Netherlands 1963
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Blaß, H.J., Ehlbeck, J. & Schlager, M. Characteristic strength of tooth-plate connector joints. Holz als Roh-und Werkstoff 51, 395–399 (1993). https://doi.org/10.1007/BF02628236
Issue Date:
DOI: https://doi.org/10.1007/BF02628236