Résumé
Les granulats de calcaire concassés de dureté moyenne à faible ont le handicap d'un double préjugé défavorable lié à l'influence des variations de teneurs en éléments fins 0/500 μm produits entre la fabrication des granulats 5/20 et leur utilisation et à la «dureté» moins élevée de ces matériaux que les silico-calcaires alluvionnaires traditionnellement employés.
L'étude décrite ne confirme pas ces craintes bien au contraire, elle met en évidence le fait que ces calcaires permettent de confectionner des bétons de caractéristiques très satisfaisantes, et dont la technologie d'emploi ne présente pas de particularité en dehors de la nécessité d'employer des granulats humides. En recherche, la durabilité des bétons mise en évidence par des essais de gel indique qu'il est recommandé surtout pour les bétons à dosage en ciment moyen d'employer un entraîneur d'air.
Abstract
The crushed limestone aggregates with medium to weak hardness present two difficulties concerning first the influence of the variations of the thin elements (0/500μm) content, (these thin elements are produced between the production of the aggregates 5/20 mm and their utilization) and second the hardness of these materials which is lower than for traditionnaly employed silico-calcareous aggregates.
The results of the research described in the paper do no confirm this fear; on the contrary, it is obvious that the limestones allow to elaborate concretes presenting quite satisfactory characteristics; the technology of use does not introduce any particular problem except the necessity of employing wet aggregates. In return, the durability of these concretes, tested through the freezing test, shows that it is better, especially for concretes with a medium cement content, to use an air entrainingagent.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Coquillat, G., Delfau, M. & Lesage, R. Possibilites d'emploi des calcaires de durete moyenne a faible dans les betons hydrauliques. Bulletin of the International Association of Engineering Geology 22, 203–209 (1980). https://doi.org/10.1007/BF02600671
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF02600671