Abstract
Aluminium was coated on silicon nitride ceramics by a low-pressure plasma spraying method, in order to form a tight bond between aluminium and the ceramics. Aluminium nitride formed as a interfacial reaction product between the aluminium coating layer and the ceramics. Two pieces of the aluminium-coated Si3N4 ceramics were then joined using the aluminium coating layers as filler metal in a vacuum of 1.3×10−3 Pa at 973 K. The average bending strength and Weibull modulus of the joint are 340 MPa and 6.3 respectively, considerably higher than the 230 MPa and 0.9 of a Si3N4 ceramics joint brazed with an aluminum plate under the same condition.
Similar content being viewed by others
References
X. S. Ning, K. Suganuma, M. Morita and T. Okamoto, Phil. Mag. Lett. 55 (1987) 93.
X. S. Ning, K. Suganuma, T. Okamoto, Y. Miyamoto and A. Koreeda, J. Mater. Sci. 24 (1989) 2865.
X. S. Ning, T. Okamoto, Y. Miyamoto, A. Koreeda and K. Suganuma, ibid.— 24 (1989) 2879.
M. Naka, H. Mori, M. Kubo, I. Okamoto and H. Fujita, J. Mater. Sci. Lett. 5 (1986) 696.
M. E. Milberg, H. D. Blair, W. T. Donlon and S. S. Shinozaki, J. Mater. Sci. 22 (1987) 2560.
X. S. Ning, T. Okamoto, Y. Miyamoto, A. Koreeda and K. Suganuma, ibid.— 26 (1991) 4142.
Y. Arata, A. Ohmori and S. Sano, Trans. J. Weld. Res. Inst. 14 (1985) 284.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Pan, W.X., Okamoto, T. & Ning, X.S. Joining of Al-plasma-sprayed Si3N4ceramics. JOURNAL OF MATERIALS SCIENCE 29, 1436–1440 (1994). https://doi.org/10.1007/BF00368906
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF00368906