Advertisement

Elastic buckling loads of partially embedded piles in cohesive soil

  • Magdy I. SalamaEmail author
  • Ali M. Basha
Technical Paper
  • 80 Downloads

Abstract

Buckling of piles may play an important role in the pile’s design especially for piles that are partially embedded in soil or when the upper layers of the fully embedded piles are loose or weak soils. In this paper, the elastic stability of partially embedded piles subjected to axial force is developed considering all the parameters that may be affecting the buckling load. These parameters are the ratio of the embedded length to the pile length, the elastic modulus of the soil, the pile overall length, and the flexural stiffness of pile that represents the cross section of the pile and its material. Both of the methods of finite element and the minimum potential energy are performed to obtain the buckling loads and then the effective length of the considered pile. The soil is considered as a continuous elastic medium that is replaced by many equally spaced elastic supports of equal rigidity in the finite element modelling. The numerical results are presented in charts to clarify the effect of each parameter on the effective length coefficient of the considered piles. The results of the coefficient of effective length that obtained by the energy technique and the finite element method are also compared in this paper.

Keywords

Stability Piles Energy approach Finite element method Partially embedded SAP2000 

References

  1. 1.
    Terzaghi K (1955) Evalution of coefficient of subgrade reaction. Geotechnique 5:297–326CrossRefGoogle Scholar
  2. 2.
    Timoshenko SP, Gere JM (1983) Theory of elastic stability. McGraw-Hill Book Company, LondonGoogle Scholar
  3. 3.
    Davission MT, Robinson KE (1965) Bending and buckling of partially embedded piles. In: 6th international conference on soil mechanics and foundation engineering 2:243–246Google Scholar
  4. 4.
    Heelis ME, Pavlović MN, West RP (2004) The analytical prediction of the buckling loads of fully and partially embedded piles. Géotechnique 54(6):363–373CrossRefGoogle Scholar
  5. 5.
    Seval Ç, Hikmet H (2006) Buckling analysis of partially embedded pile in elastic soil using differential transform method. Struct Eng Mech 24(2):247–268CrossRefGoogle Scholar
  6. 6.
    Khodair Y, Hassiotis S (2007) Buckling behaviour of single pile and pile bent in the Scotch Road Bridge. Geomech Geoeng 1(4):291–298.  https://doi.org/10.1080/17486020600834621 CrossRefGoogle Scholar
  7. 7.
    Kumar SP, Kamaraj SKA, Parameswaran P (2007) Buckling behaviour of axially loaded partially embedded concrete piles in sand. J Eng Appl Sci 2(9):1394–1398Google Scholar
  8. 8.
    Jesmani M, Nabavi SH, Kamalzare M (2014) Numerical analysis of buckling behaviour of concrete piles under axial load embedded in sand. Arab J Sci Eng. 39:2683.  https://doi.org/10.1007/s13369-014-0970-5 CrossRefGoogle Scholar
  9. 9.
    Shatri V, Bozo L, Shefkiu B, Shatri B (2014) Analysis of buckling of piles fully embedded in ground according to finite element method. Int J Curr Eng Technol 4(1):201–205Google Scholar
  10. 10.
    Lu W, Zhao D (2017) Analysis on calculated length for buckling stability of steel pipe pile based on energy method. Open Civ Eng J 11:167–175.  https://doi.org/10.2174/1874149501711010167 CrossRefGoogle Scholar
  11. 11.
    El Kamash W, El Naggar H (2018) Numerical study on buckling of end-bearing piles in soft soil subjected to axial loads. Geotech Geol Eng 1:1.  https://doi.org/10.1007/s10706-018-0529-4 CrossRefGoogle Scholar

Copyright information

© Springer Nature Switzerland AG 2019

Authors and Affiliations

  1. 1.Kafrelsheikh University Faculty of EngineeringKafr El SheikhEgypt

Personalised recommendations