Advertisement

Evaluation of Microfine Stone Dust as Filler Material in Binary and Ternary Blends

  • Radhakrishna
  • S. V. Venkatesh
  • K. N. Narasimha PrasadEmail author
Technical Note
  • 19 Downloads

Abstract

Most of the supplementary cementitious materials are derived from waste from different industries with varying properties. It is necessary to know the performance of these materials in cement composites. In this investigation, the effect of water-to-binder ratio and grade of concrete on the properties of the concrete containing stone dust and microfine slag in binary and ternary blend with cement are studied. A concrete mix of M20 grade was prepared for control concrete, and the different replacement binder compositions were introduced without any changes to the total cementitious content. In another grade of M35 concrete, the cementitious (binder) content was increased by 12.5% over that of the control concrete. Strength and workability of concretes were determined along with chloride ingress. The study has revealed that stone dust and microfine slag are more effective in a ternary blend than the respective binary blends. It is also found that chloride ingress into concretes with supplementary cementitious materials is more significantly reduced in higher grades of concrete with lower water-to-binder ratio.

Keywords

Stone dust Microfine slag Supplementary cementitious materials Chloride ingress 

References

  1. AASHTO T 277-86 (1990) Rapid determination of the chloride permeability of concrete. Standard specifications—part II tests, American Association of States Highway and Transportation Officials, Washington, DCGoogle Scholar
  2. ASTM C 1202 (2012) Standard test method for electrical indication of concrete’s ability to resist chloride ion penetration. ASTM International, West Conshohocken, PA. http://www.astm.org. Accessed 14 Aug 2016
  3. ASTM C595/C595M-16 (2016) Standard specification for blended hydraulic cements. ASTM International, West Conshohocken, PA. http://www.astm.org. Accessed 14 Aug 2016
  4. Bahurudeen A, Hemalatha MS, Santhanam M (2016) Need for efficient procedure for the evaluation of pozzolanic performance of supplementary cementitious materials. Indian Concr J 89(1):80–92Google Scholar
  5. Cho B, Choi H (2016) Physical and chemical properties of concrete using GGBFS-KRSlag-gypsum binder. Constr Build Mater 123:436–443CrossRefGoogle Scholar
  6. Dam VT (2013) Supplementary cementitious materials and blended cements to improve sustainability of concrete pavements. Tech Brief, National Concrete Pavement Technology Center, Iowa State University Institute for Transportation, Ames, IA, USA. Accessed 09 Sept 2016Google Scholar
  7. Elmoaty ABDA (2013) Mechanical properties and corrosion resistance of concrete modified with granite dust. Constr Build Mater 47:743–752CrossRefGoogle Scholar
  8. Galetakis M, Soultana A (2016) A review on the utilization of quarry and ornamental stone industry fine by-products in the construction sector. Constr Build Mater 102:769–781CrossRefGoogle Scholar
  9. IS 10262:2009 (1990) Concrete mix proportioning—guidelines. (First revision). Bureau of Indian Standards, New DelhiGoogle Scholar
  10. IS 1481:1991 (1991) Specification for Portland puzzolana cement, part 1: fly ash based code of practice. Bureau of Indian Standards, New DelhiGoogle Scholar
  11. IS 8112:2013 (2013) Specification for 43 grade ordinary Portland cement. Bureau of Indian Standards, New DelhiGoogle Scholar
  12. Narasimha Prasad KN, Ganesh N, Rakesh S, Radhakrishna, Venkatesh SV (2015) Setting and strength characteristics of cement mortar with micro fines. I Manag J Struct Eng 4(1):27–31Google Scholar
  13. Nayak P, Narasimhan HS, Kadaba RV (2014) Hardened properties of concrete made with micro silica and Alccofine—a performance optimization based comparative study. Int J Eng Res Dev 10(8):01–04Google Scholar
  14. Sengul O, Tasdemir M (2009) Compressive strength and rapid chloride permeability of concretes with ground fly ash and slag. J Mater Civ Eng 21(9):494–501CrossRefGoogle Scholar
  15. Vijayalakshmi M, Sekar ASS, Prabhu GG (2013) Strength and durability properties of concrete made with granite industry waste. Constr Build Mater 46:1–7CrossRefGoogle Scholar

Copyright information

© Shiraz University 2018

Authors and Affiliations

  • Radhakrishna
    • 1
  • S. V. Venkatesh
    • 2
  • K. N. Narasimha Prasad
    • 3
    Email author
  1. 1.Department of Civil Engineering, RV College of EngineeringBangalore Affiliated to Visveswaraya Technological UniversityBelgaumIndia
  2. 2.Department of Civil EngineeringPES Institute of TechnologyBangaloreIndia
  3. 3.NICMAR, Goa and Research ScholarRV College of EngineeringBangaloreIndia

Personalised recommendations