Advertisement

KSCE Journal of Civil Engineering

, Volume 23, Issue 9, pp 3897–3906 | Cite as

Experimental Study on Dynamic Water Grouting of Modified Water-Soluble Polyurethane

  • Xiaofan LiuEmail author
  • Junguang Wang
  • Kun Huang
  • Fengyun Li
Geotechnical Engineering
  • 11 Downloads

Abstract

In underground project, water inrush disaster often occurs, resulting in a large number of casualties and economic losses. To solve these problems, grouting is one of the main techniques for controlling water inrush. At present, the research results on the treatment of water inrush by grouting are based on anhydrous or hydrostatic grouting. However, the study of dynamic water grouting is relatively few and the grouting materials are a little bit. In this paper, water-soluble polyurethane was selected as grouting material, modified by adding hydroxypropyl methyl cellulose, and the bond strength and microstructure change before and after modification are studied via bond strength experiment and microscopic observation. In addition, the WPU (water-soluble polyurethane) diffusion regularity of dynamic water grouting is studied by indoor flat grouting test. The research also adopts the Bingham fluid model according to the slurry characteristics to derive the grouting diffusion radius. The results show that the compactness of HPMC (hydroxypropyl methyl cellulose)-WPU is improved, the heterogeneity is reduced by 50.4%, and the bonding strength is increased by 153%. Therefore, the anti-scour ability of the HPMC-WPU is enhanced. The deviation of the WPU in the X-axis diffusion radius is 7.7 cm, and the HPMC-WPU is 4.39 cm. What’s more, the formula of grouting diffusion radius is derived. By comparing the formula with experiment results, the deviation is less than 15%, therefore, the formula has the significance of guiding engineering practice.

Keywords

dynamic water grouting water-soluble polyurethane slurry hydroxypropyl methyl cellulose chemical modification diffusion radius 

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Notes

Acknowledgements

This study was financially supported by the national natural science foundation of China (51474168).

References

  1. Cheong, I. W., Nomura, M., and Kim, H. (2001). “Water-soluble Polyurethane resins as emulsifiers in emulsion polymerization of styrene: Nucleation and particle growth.” Macromolecular Chemistry and Physics, Vol. 202, No. 11, pp. 2454–2460, DOI:  https://doi.org/10.1002/1521-3935(20010701)202:11<2454::AID-MACP2454>3.0.CO;2-M.CrossRefGoogle Scholar
  2. Cheong, I. W., Song, S. H., Nomura, M., and Kim, H. (2001). “Water-soluble polyurethane resins as emulsifiers in the emulsion polymerization of styrene: The effect of the neutralization degree of the resin.” Macromolecular Chemistry and Physics, Vol. 202, No. 9, pp. 1710–1716, DOI:  https://doi.org/10.1002/1521-3935(20010601)202:9<1710::AID-MACP1710>3.0.CO;2-D.CrossRefGoogle Scholar
  3. Doseva, V., Shenkov, S., Vasilev, S., and Baranovsky, V. H. (2004). “Synthesis and properties of water soluble polyurethanes based on poly(ethylene glycol).” Journal of Applied Polymer Science, Vol. 91, No. 6, pp. 3651–3658, DOI:  https://doi.org/10.1002/app.13604.CrossRefGoogle Scholar
  4. Dou, J. L., Dou, J. F., and Guo, Y. J. (2015).“Researching on a new grouting material and its engineering application.” Advanced Materials Research, Vol. 1088, pp. 544–548, DOI:  https://doi.org/10.4028/www.scientific.net/AMR.1088.544.CrossRefGoogle Scholar
  5. Gullu, H. (2017). “A new prediction method for the rheological behavior of grout with bottom ash for jet grouting columns.” Soils and Foundations, Vol. 57, No. 3, pp. 384–396, DOI:  https://doi.org/10.1016/j.sandf.2017.05.006.CrossRefGoogle Scholar
  6. Hu, Y., Zhang, S. W., Han, D. D., and Ding, Z. X. (2018). “Construction and evaluation of the hydroxypropyl methyl cellulose-sodium alginate composite hydrogel system for sustained drug release.” Journal of Polymer Research, Vol. 25, No. 7, pp. 148(2–12), DOI:  https://doi.org/10.1007/s10965-018-1546-y.CrossRefGoogle Scholar
  7. Ismail, E. A. (1998). “Preparation of water-soluble polyurethane surfactants.” Journal of Applied Polymer Science, Vol. 68, No. 9, pp. 1531–1536, DOI:  https://doi.org/10.1002/(SICI)1097-4628(19980531)68:9<1531::AID-APP16>3.3.CO;2-3.CrossRefGoogle Scholar
  8. Liu, R. T., Li, S. C., Zhang, Q. S., Yuan, X. S., and Han, W. W. (2011). “Experiment and application research on a new type of dynamic water grouting material.” Chinese Journal of Rock Mechanics and Engineering, Vol. 30, No. 7, pp. 247–265 (in Chinese).Google Scholar
  9. Ma, B. G., Peng, Y., Tan, H. B., and Jian, S. W. (2018). “Effect of hydroxypropyl-methyl cellulose ether on rheology of cement paste plasticized by polycarboxylate superplasticizer.” Constr. Build. Mater., Vol. 160, pp. 341–350, DOI:  https://doi.org/10.1016/j.conbuildmat.2017.11.010.CrossRefGoogle Scholar
  10. Pineda, P. and Castizo-Morales, D. (2017). “Environmental and structural analysis of cement-based vs. natural material-based grouting mortars. Results from the assessment of strengthening works.” Constr. Build. Mater., Vol. 138, pp. 528–547, DOI:  https://doi.org/10.1016/j.conbuildmat.2017.02.013.CrossRefGoogle Scholar
  11. Qin, C. L., Cai, W. M., and Cai, J. (2004). “Damping properties and morphology of polyurethane/vinyl ester resin interpenetrating polymer network.” Materials Chemistry and Physics, Vol. 85, Nos. 2–3, pp. 402–409, DOI:  https://doi.org/10.1016/j.matchemphys.2004.01.019.CrossRefGoogle Scholar
  12. Saric-Coric, M., Khayat, K. H., and Tagnit-Hamou, A. (2003). “Performance characteristics of cement grouts made with various combinations of high-range water reducer and cellulose-based viscosity modifier.” Cem. Concr. Res., Vol. 33, pp. 1999–2008, DOI:  https://doi.org/10.1016/S0008-8846(03)00214-X.CrossRefGoogle Scholar
  13. Shi, M. S., Wang, F. M., and Luo, Jing. (2010). “Compressive strength of polymer grouting material at different temperatures.” Journal of Wuhan University of Technology-Mater. Sci., Vol. 25, No. 6, pp. 962–965, DOI:  https://doi.org/10.1007/s11595-010-0129-5.CrossRefGoogle Scholar
  14. Song, B. D., Park, B. G., Choi, Y. K., and Kim, T. H. (2017). “Determining the engineering characteristics of the Hi-FA series of grout materials in an underwater condition.” Constr. Build. Mater., Vol. 144, pp. 74–85, DOI:  https://doi.org/10.1016/j.conbuildmat.2017.03.101.CrossRefGoogle Scholar
  15. Tsuji, M., Kobayashi, S., Mikake, S., Sato, T., and Matsui, H. (2017). “Post-grouting experiences for reducing groundwater inflow at 500 m depth of the mizunami underground research laboratory.” ISRM European Rock Mechanics Symposium EUROCK 2017, Ostrava, Czech Republic, pp. 543–550.Google Scholar
  16. Verdejo, R., Stämpfli, R., and Alvarez-Lainez, M. (2009). “Enhanced acoustic damping in flexible polyurethane foams filled with carbon nanotubes.” Composites Science and Technology, Vol. 69, No. 10, pp. 1564–1569, DOI:  https://doi.org/10.1016/j.compscitech.2008.07.007.CrossRefGoogle Scholar
  17. Wang, J., Zhang, L. W., Feng, X., and Wang, H. (2015). “Experiment and application research on alkali-activated geopolymer two-component grouting material.” Chin. J. Rock Mech. Eng., Vol. 34, pp. 4188–4425, DOI:  https://doi.org/10.13722/j.cnki.jrme.2015.0984.Google Scholar
  18. Wang, Q. B., Zhu, Q. K., Shao, T. S., Yu, X. G., Xu, S. Y., Zhang, J. J., and Kong, Q. L. (2018). “The rheological test and application research of glass fiber cement slurry based on plugging mechanism of dynamic water grouting.” Constr. Build. Mater., Vol. 189, pp. 119–130, DOI:  https://doi.org/10.1016/j.conbuildmat.2018.08.081.CrossRefGoogle Scholar
  19. Wei, Y., Wang, F. M., and Gao, X. (2017). “Microstructure and fatigue performance of polyurethane grout materials under compression.” J. Mater. Civ. Eng., Vol. 29, No. 9, pp. 04017101(1–8), DOI:  https://doi.org/10.1061/(ASCE)MT.1943-5533.0001954.CrossRefGoogle Scholar
  20. Yahia, A. and Khayat, K. H. (2001). “Experiment design to evaluate interaction of high-range water-reducer and anti-washout admixture in high-performance cement grout.” Cem. Concr. Res., Vol. 31, No. 5, pp. 749–757, DOI:  https://doi.org/10.1016/S0008-8846(01)00496-3.CrossRefGoogle Scholar
  21. Yang, R. (2013). Experimental research on new chemical grouting material to reinforce broken coal, PhD Thesis, AnHui University of Science and Technology, AnHui, Huainan, China.Google Scholar
  22. Zhang, Q., Hu, X. M., Wu, M. Y., Zhao, Y. Y., and Yu, C. (2018). “Effects of different catalysts on the structure and properties of polyurethane/water glass grouting materials.” Journal of Applied Polymer Science, Vol. 135, No. 27, pp. 46460(1–11), DOI:  https://doi.org/10.1002/app.46460.Google Scholar
  23. Zhang, Q. C., Li, J. H., Liu, B. S., and Chen, X. G. (2011). “Directional drainage grouting technology of coal mine water damage treatment.” Procedia Engineering, Vol. 26, pp. 264–270, DOI:  https://doi.org/10.1016/j.proeng.2011.11.2167.CrossRefGoogle Scholar
  24. Zhou, W. F. and Liao, S. M. (2016). “The analysis and control of inrush and mud gushing in the broken rock tunnel under high water pressure.” Procedia Engineering, Vol. 165, pp. 259–264, DOI:  https://doi.org/10.1016/j.proeng.2016.11.798.CrossRefGoogle Scholar

Copyright information

© Korean Society of Civil Engineers 2019

Authors and Affiliations

  1. 1.School of Civil Engineering and ArchitectureWuhan Polytechnic UniversityWuhanChina

Personalised recommendations