Journal of Failure Analysis and Prevention

, Volume 8, Issue 2, pp 193–198 | Cite as

Remote NDE Technology for Inaccessible Shipboard Piping Inspection

Technical Article---Peer-Reviewed

Abstract

Piping inside fuel and ballast tanks on US Navy ships requires periodic inspection and maintenance. However, because the cost to open and enter tanks for inspection is considerable the Navy has extended scheduled in-tank inspections by up to 12 years. This has reduced maintenance costs but has increased the risk that piping corrosion goes undetected. This has led to some unexpected piping failures and in a few cases has resulted in oil spills. To prevent these pipe failures the US Navy is evaluating technologies that can enable rapid and inexpensive periodic condition assessment of piping that is inside of fuel and ballast tanks. Pipe failures were investigated to determine the exact nature of the failures and the ship systems most affected. Then a detailed technical performance requirements list was developed on which to base a review of remote inspection equipment capability. Commercially available technologies were identified and candidates selected for laboratory evaluation. The technologies presently undergoing evaluation include those that involve the insertion of sensor(s) into the pipe from outside of the tank as well as non-invasive techniques that use externally placed sensors from outside of the tank. This paper provides an overview of the problem definition, the performance specifications and a description of some potential technology solutions. The capabilities and limitations of each of the technologies under investigation are presented along with some preliminary performance testing results.

Keywords

Condition assessment Corrosion and defect detection NDE requirements Optical pipe inspection Pipe inspection Remote NDE techniques Guided wave technology Ultrasonic inspection 

Notes

Acknowledgments

The authors gratefully acknowledge the program support and technical guidance provided by Mr. David Beardsley and Mr. Russ Kok of the Naval Sea Systems Command.

References

  1. 1.
    Naval Ships’ Technical Manual Chapter 505 Piping Systems, published by Commander, NAVSEA, 1 Dec. 2001Google Scholar
  2. 2.
  3. 3.
    Rose, J.L.: Ultrasonic Waves in Solid Media. Cambridge University Press (2004)Google Scholar
  4. 4.
    Cawley, P., Lowe, M.J.S., Alleyne, D.N., Pavlakovic, B., Wilcox, P.: Practical long range guided wave testing: application to pipe and rails. Mater. Eval. 61(1), 66–74 (2003)Google Scholar
  5. 5.
    Light, G.M., Kwan, H., Kim, S.Y., Spinks, R.L.: Health monitoring for aircraft structures. Mater. Eval. 61(7), 844–847 (2003)Google Scholar
  6. 6.
    Kaznoff, A.I., Brinckerhoff, B., Spadafora, S.J., Perez, A.: Success stories: navy, naval assets present tough but achievable challenges. AMPTIAC Quart. 7(4), 66–73 (2003)Google Scholar
  7. 7.
    Groeninger, B., Lemieux, E.: Naval Research Laboratory, private communications, 2004Google Scholar

Copyright information

© Society for Machinery Failure Prevention Technology 2005

Authors and Affiliations

  1. 1.Welding & NDE BranchNaval Surface Warfare Center Carderock Div.W. BethesdaUSA
  2. 2.Navy Research and Engineering DivisionScience Applications International Corporation (SAIC)WashingtonUSA

Personalised recommendations