Advertisement

Acta Geotechnica

, Volume 14, Issue 3, pp 869–879 | Cite as

Ultimate bearing capacity of energy piles in dry and saturated sand

  • Han-long LiuEmail author
  • Cheng-long Wang
  • Gang-qiang Kong
  • Abdelmalek Bouazza
Research Paper
  • 307 Downloads

Abstract

The influence of thermal loads on the ultimate bearing capacity of energy piles is examined. Five laboratory model tests were carried out to investigate piles equipped with U-shaped and W-shaped heat exchangers in dry and saturated sand. The pile load–displacement relationships were investigated for one, three, and five heating–cooling cycles and under three different pile temperatures. The results show that the ultimate bearing capacity, in dry sand at high soil relative density, increased as pile temperature increased. After one heating–cooling cycle, the ultimate bearing capacity reduced slightly. Compared with dry sand, the thermo-mechanical response in saturated sand was less obvious and the reduction of pile ultimate capacity after one heating–cooling cycle was smaller. A reduction in the ultimate bearing capacity of 13.4% was observed after three heating–cooling cycles in dry sand, while a reduction in ultimate bearing capacity of 9.2% was observed after five heating–cooling cycles in saturated sand. The more noticeable reduction of ultimate bearing capacity in dry sand was related to the larger temperature variation which would induce more degradation at the pile–soil interface. In addition, the pore water viscosity in saturated sand may contribute to less degradation at pile–soil interface during heating and cooling.

Keywords

Energy pile Model tests Thermal load, heating–cooling cycles Ultimate bearing capacity 

Notes

Acknowledgements

The authors would like to acknowledge the funding from the Chongqing Scientific and Technological Talents Program (Grant No. KJXX2017005) and the National Natural Science Foundation of China (Grant No. 51378178).

References

  1. 1.
    Agar JG, Morgenstern NR, Scott JD (1986) Thermal expansion and pore pressure generation in oil sands. Can Geotech J 23(3):327–333Google Scholar
  2. 2.
    Akrouch GA, Sánchez M, Briaud JL (2014) Thermo-mechanical behavior of energy piles in high plasticity clays. Acta Geotech 9(3):399–412Google Scholar
  3. 3.
    Bouazza A, Singh RM, Wang B, Barry-Macaulay D, Haberfield C, Chapman G, Baycan S, Carden Y (2011) Harnessing onsite renewable energy through pile foundations. Aust Geomech 46(4):79–90Google Scholar
  4. 4.
    Bourne-Webb PJ, Amatya B, Soga K, Amis T, Davidson C (2009) Energy pile test at Lambeth College, London: geotechnical and thermodynamic aspects of pile response to heat cycles. Géotechnique 59(3):237–248Google Scholar
  5. 5.
    Brandl H (2006) Energy foundations and other thermo-active ground structures. Geotechnique 56(2):81–122Google Scholar
  6. 6.
    BSI (2004) BS EN 1997-1:2004: Eurocode 7. Geotechnical design—Part 1: general rules. BSI, LondonGoogle Scholar
  7. 7.
    Di Donna A, Ferrari A, Laloui L (2015) Experimental investigations of the soil-concrete interface: physical mechanisms, cyclic mobilization, and behavior at different temperatures. Can Geotech J 53(4):659–6728Google Scholar
  8. 8.
    Eslami H, Rosin-Paumier S, Abdallah A, Masrouri F (2017) Pressuremeter test parameters of a compacted illitic soil under thermal cycling. Acta Geotech 12(5):1–14Google Scholar
  9. 9.
    Faizal M, Bouazza A, Singh RM (2016) An experimental investigation of the influence of intermittent and continuous operating modes on the thermal behaviour of a full scale geothermal energy pile. Geomech Energy Environ 8:8–29Google Scholar
  10. 10.
    Goode J III, McCartney JS (2015) Centrifuge modeling of boundary restraint effects in energy foundations. J Geotech Geoenviron Eng 141(8):04015034Google Scholar
  11. 11.
    Housing Authority (HA) (1998) Hong Kong housing authority specification library for building works. Hong Kong Government, Hong KongGoogle Scholar
  12. 12.
    Hueckel T, Francois B, Laloui L (2011) Temperature-dependent internal friction of clay in a cylindrical heat source problem. Géotechnique 61(10):831–844Google Scholar
  13. 13.
    Kramer CA, Basu P (2014) Performance of a model geothermal pile in sand. In: Gaudin C, White D (eds) Proceedings 8th international conference on physical modelling in geotechnics, Perth. CRC Press/Balkema, Leiden, pp 771–777Google Scholar
  14. 14.
    Laloui L, Moreni M, Vulliet L (2003) Comportement d’un pieu bi-fonction, fondation et échangeur de chaleur. Can Geotech J 40(2):388–402Google Scholar
  15. 15.
    Laloui L, Nuth M, Vulliet L (2006) Experimental and numerical investigations of the behaviour of a heat exchanger pile. Int J Numer Anal Meth Geomech 30(8):763–781Google Scholar
  16. 16.
    Liu HL, Wang CL, Kong GQ, Ng CWW, Che P (2016) Model tests on thermo-mechanical behavior of an improved energy pile. Eur J Environ Civ Eng.  https://doi.org/10.1080/19648189.2016.1248792 Google Scholar
  17. 17.
    McCartney JS, Murphy KD (2012) Strain distributions in full-scale energy foundation. DFI Journal 6(2):28–36Google Scholar
  18. 18.
    McCartney JS, Rosenberg JE (2011) Impact of heat exchange on side shear in thermo-active foundations. In: Han J, Alzamora DE (eds) Procedings Geo-Frontiers 2011: advances in Geotechnical Engineering, Dallas, TX. ASCE, Reston, pp 488–498Google Scholar
  19. 19.
    Murphy KD, McCartney JS, Henry KS (2015) Evaluation of thermo-mechanical and thermal behavior of full-scale energy foundations. Acta Geotech 10(2):1–17Google Scholar
  20. 20.
    Ng CWW, Shi C, Gunawan A, Laloui L, Liu HL (2015) Centrifuge modelling of heating effects on energy pile performance in saturated sand. Can Geotech J 52(8):1045–1057Google Scholar
  21. 21.
    Ng CWW, Gunawan A, Shi C, Ma QJ, Liu HL (2016) Centrifuge modelling of displacement and replacement energy piles constructed in saturated sand: a comparative study. Géotech Lett 6(1):1–5Google Scholar
  22. 22.
    Ng CWW, Ma QJ, Gunawan A (2016) Horizontal stress change of energy piles subjected to thermal cycles in sand. Comput Geotech 78:54–61Google Scholar
  23. 23.
    Olgun CG, Ozudogru TY, Arson C (2014) Thermo-mechanical radial expansion of heat exchanger piles and possible effects on contact pressures at pile-soil interface. Géotech Lett 4(3):170–178Google Scholar
  24. 24.
    Pasten C, Santamarina JC (2014) Thermally induced long-term displacement of thermoactive piles. J Geotech Geoenviron Eng 140(5):70–75Google Scholar
  25. 25.
    Singh RM, Bouazza A, Wang B (2015) Near-field ground thermal response to heating of a geothermal energy pile: observations from a field test. Soils Found 55(6):1412–1426Google Scholar
  26. 26.
    Sutman M, Olgun C, Brettmann T (2015) Full-scale field testing of energy piles. In: Iskander M, Suleiman MT, Anderson JB, Laefer DF (eds) Proceedings of IFCEE 2015, San Antonio, TX, USA, vol 1. American Society of Civil Engineers (ASCE), Reston, pp 1638–1647Google Scholar
  27. 27.
    Wang B, Bouazza A, Haberfield C (2011) Preliminary observations from laboratory scale model geothermal pile subjected to thermo-mechanical loading. In: Han J, Alzamora DE (eds) Proceedings of Geo-Frontiers 2011: Advances in Geotechnical Engineering. ASCE, Reston, pp 430–439Google Scholar
  28. 28.
    Wang B, Bouazza A, Barry-Macaulay D, Singh MR, Webster M, Haberfield C, Chapman G, Baycan S (2012) Field and laboratory investigation of a heat exchanger pile. In: Hryciw RD, Athanasopoulos-Zekkos A, Yesiller N (eds) Proceeding Geo-Congress 2012: State of the Art and Practice in Geotechnical Engineering, Oakland, CA. ASCE, Reston, pp 4396–4405Google Scholar
  29. 29.
    Wang B, Bouazza A, Singh RM, Haberfield C, Barry-Macaulay D, Baycan S (2015) Posttemperature effects on shaft capacity of a full-scale geothermal energy pile. J Geotech Geoenviron Eng 141(4):04014125Google Scholar
  30. 30.
    Wang CL, Liu HL, Kong GQ, Ng CWW (2016) Model tests of energy piles with and without a vertical load. Environ Geotech 3(4):203–213Google Scholar
  31. 31.
    Wang CL, Liu HL, Kong GQ, Wu D (2016) Model tests on thermal mechanical behavior of energy piles influenced with heat exchangers types. Eng Mech 34(1):85–91 (in Chinese) Google Scholar
  32. 32.
    Wang CL, Liu HL, Kong GQ, Wu D (2017) Influence of circular temperature on the strain and stress of energy piles under a working load. Rock Soil Mech 37(S1):317–322 (in Chinese) Google Scholar
  33. 33.
    Wang CL, Liu HL, Kong GQ, Ng CWW (2017) Different types of energy piles with heating–cooling cycles. Proc Inst Civ Eng Geotech Eng 170(3):220–231Google Scholar
  34. 34.
    You S, Cheng XH, Guo HX (2016) Experimental study on structural response of CFG energy piles. Appl Therm Eng 96(1):640–651Google Scholar
  35. 35.
    Yu KL, Singh RM, Bouazza A, Bui HH (2015) Determining soil thermal conductivity through numerical simulation of a heating test on a heat exchanger pile. Geotech Geol Eng 33:239–252Google Scholar
  36. 36.
    Zhou H, Liu H, Kong G, Huang X (2014) Analytical solution of undrained cylindrical cavity expansion in saturated soil under anisotropic initial stress. Comput Geotech 55(2):232–239Google Scholar

Copyright information

© Springer-Verlag GmbH Germany, part of Springer Nature 2018

Authors and Affiliations

  • Han-long Liu
    • 1
    Email author
  • Cheng-long Wang
    • 1
  • Gang-qiang Kong
    • 2
  • Abdelmalek Bouazza
    • 3
  1. 1.College of Civil EngineeringChongqing UniversityChongqingChina
  2. 2.College of Civil and Transportation EngineeringHohai UniversityNanjingChina
  3. 3.Department of Civil EngineeringMonash UniversityClaytonAustralia

Personalised recommendations