Advertisement

Influence of aluminum oxide nanoparticle with different particle sizes on the working attributes of diesel engine fueled with blends of diesel and waste plastic oil

  • Chenniappan ChinnasamyEmail author
  • Palanisamy Tamilselvam
  • Rajamanickam Ranjith
Research Article
  • 14 Downloads

Abstract

In the present work, an experimental investigation was conducted to study the influence of adding aluminum oxide nanoparticles (Al2O3) with different average particle sizes as additive to blends of diesel and waste plastic oil (WPO) on performance, emission, and combustion attributes of single-cylinder diesel engine operated at a constant speed. Two samples of Al2O3 nanoparticle with average particle sizes of 20 and 100 nm were dispersed into a WPO20 blend containing 20% of WPO and 80% of diesel in the mass fractions of 10 and 20 ppm using ultrasonic stabilization. The experimental recordings revealed a decrease in engine performance and increase in all emission constituents while replacing diesel with WPO20. However, the addition of both 20- and 100-nm-sized Al2O3 nanoparticles into WPO20 was found to enhance the brake thermal efficiency (BTHE) by 12.2 and 8.9% respectively and decrease the brake-specific fuel consumption (BSFC) by 11 and 8% respectively. The emission constituents such as carbon monoxide (CO), hydrocarbons (HC), nitric oxide (NO), and smoke opacity were minimized by the addition of both 20- and 100-nm-sized nanoparticles into WPO20 blend. However, the reduction of emissions was better for 20-nm-sized particles compared with that of 100-nm-sized particles. The combustion attributes such as cylinder pressure, heat release rate (HRR), and rate of pressure rise (RPR) were raised with shortened ignition delay (ID) by the addition of both sized nanoparticles. Overall, the inclusion of 20-nm-sized nanoparticles performs better catalytic activity to enhance the engine output characteristics along with minimum exhaust emissions.

Keywords

Waste plastic oil Aluminum oxide nanoparticle Emission Combustion Diesel engine 

Notes

References

  1. Aalam CS, Saravanan CG (2015) Effects of nanometal oxide blended Mahua biodiesel on CRDI diesel engine. Ain Shams Eng J 8:689–696CrossRefGoogle Scholar
  2. Aalam CS, Saravanan CG, Kannan M (2015) Experimental investigations on a CRDI system assisted diesel engine fuelled with aluminium oxide nanoparticles blended biodiesel. Alexandria Eng J 54:351–358CrossRefGoogle Scholar
  3. Abedin MJ, Masjuki HH, Kalam MA, Sanjid A, Rahman SMA, Fattah IMR (2014) Performance, emissions, and heat losses of palm and Jatropha biodiesel blends in a diesel engine. Ind Crop Prod 59:96–104CrossRefGoogle Scholar
  4. Awad S, Loubar K, Tazerout M (2014) Experimental investigation on the combustion, performance and pollutant emissions of biodiesel from animal fat residues on a direct injection diesel engine. Energy 69:826–836CrossRefGoogle Scholar
  5. Balaji G, Cheralathan M (2017) Influence of alumina oxide nanoparticles on the performance and emissions in a methyl ester of neem oil fuelled direct injection Diesel engine. Therm Sci 21:499–510CrossRefGoogle Scholar
  6. Basha JS, Anand RB (2010) Effects of alumina nanoparticles blended Jatropha biodiesel fuel on working characteristics of a diesel. Int J Ind Eng Technol 2:53–62Google Scholar
  7. Basha JS, Anand RB (2013) The influence of nanoadditive blended biodiesel fuels on the working characteristics of a diesel engine. J Braz Soc Mech Sci Eng 35:257–264CrossRefGoogle Scholar
  8. Browne MA, Dissanayake A, Galloway TS, Lowe DM, Thompson RC (2008) Ingested microscopic plastic translocates to the circulatory system of the mussel, Mytilus edulis (L.). Environ Sci Technol 42:5026–5031CrossRefGoogle Scholar
  9. El-Seesy AI, Abdel-Rahman AK, Bady M, Ookawara S (2016) The influence of multi-walled carbon nanotubes additives into non-edible biodiesel-diesel fuel blend on diesel engine performance and emissions. Energy Procedia 100:166–172CrossRefGoogle Scholar
  10. El-Seesy AI, Attia AMA, El-Batsh HM (2018) The effect of aluminum oxide nanoparticles addition with Jojoba methyl ester-diesel fuel blend on a diesel engine performance, combustion and emission characteristics. Fuel 224:147–166CrossRefGoogle Scholar
  11. Geyer R, Jambeck JR, Law KL (2017) Production, use, and fate of all plastics ever made. Sci Adv 3:e1700782CrossRefGoogle Scholar
  12. Gupta HN (2009) Fundamentals of internal combustion engines, 2nd edn. PHL Learning Private Limited, New DelhiGoogle Scholar
  13. Gupta H. K, Agrawal G. D, Mathur J (2012) An overview of nanofluids: a new media towards green environment. Int J Environ Sci 3. doi: https://doi.org/10.6088/ijes.2012030131042.
  14. Heywood JB (1988) Internal combustion engine fundamentals. USA: McGraw Hill Series in Mechanical Engineering TJ755.H45, 621.43, 87-15251 ISBN 0-07-028637-XGoogle Scholar
  15. Hosseini SH, Taghizadeh-Alisaraei A, Ghobadian B, Abbaszadeh-Mayvan A (2017) Effect of added alumina as nano-catalyst to diesel-biodiesel blends on performance and emission characteristics of CI engine. Energy 124:543–552CrossRefGoogle Scholar
  16. Kaimal VK, Vijayabalan P (2015) A detailed study of combustion characteristics of a DI diesel engine using waste plastic oil and its blends. Energy Convers Manag 105:951–956CrossRefGoogle Scholar
  17. Kalargaris I, Tian G, Gu S (2017) Combustion, performance and emission analysis of a DI diesel engine using plastic pyrolysis oil. Fuel Process Technol 157:108–115CrossRefGoogle Scholar
  18. Kannan GR, Karvembu R, Anand R (2011) Effect of metal based additive on performance emission and combustion characteristics of diesel engine fuelled with biodiesel. Appl Energy 88:3694–3703CrossRefGoogle Scholar
  19. Kumar S, Dinesha P, Bran I (2017) Influence of nanoparticles on the performance and emission characteristics of a biodiesel fuelled engine: an experimental analysis. Energy 140:98–105CrossRefGoogle Scholar
  20. Mani M, Nagarajan G, Sampath S (2010) An experimental investigation on a di diesel engine using waste plastic oil with exhaust gas recirculation. Fuel 89:1826–1832CrossRefGoogle Scholar
  21. Mani M, Nagarajan G, Sampath S (2011) Characterisation and effect of using waste plastic oil and diesel fuel blends in compression ignition engine. Energy 36:212–219CrossRefGoogle Scholar
  22. Misra RD, Murthy MS (2011) Blending of additives with biodiesels to improve the cold flow properties, combustion and emission performance in a compression ignition engine—a review. Renew Sust Energ Rev 15:2413–2422CrossRefGoogle Scholar
  23. Mohee R, Unmar GD, Mudhoo A, Khadoo P (2008) Biodegradability of biodegradable/degradable plastic materials under aerobic and anaerobic conditions. Waste Manag 28:1624–1629CrossRefGoogle Scholar
  24. Murugan S, Ramaswamy MC, Nagarajan G (2008) The use of tyre pyrolysis oil in diesel engines. Waste Manag 28:2743–2749CrossRefGoogle Scholar
  25. Nanthagopal K, Ashok B, Tamilarasu A, Johny A, Mohan A (2017) Influence on the effect of zinc oxide and titanium dioxide nanoparticles as an additive with Calophyllum inophyllum methyl ester in a CI engine. Energy Convers Manag 146:8–19CrossRefGoogle Scholar
  26. Panda AK, Murugan S, Singh RK (2016) Performance and emission characteristics of diesel fuel produced from waste plastic oil obtained by catalytic pyrolysis of waste polypropylene. Energy Sources A Recover Util Environ Eff 38:568–576CrossRefGoogle Scholar
  27. Panwar NL, Shrirame HY, Rathore NS, Jindal S, Kurchania AK (2010) Performance evaluation of a diesel engine fueled with methyl ester of castor seed oil. Appl Therm Eng 30:245–249CrossRefGoogle Scholar
  28. Phan AN, Phan TM (2008) Biodiesel production from waste cooking oils. Fuel 87:3490–3496CrossRefGoogle Scholar
  29. Prabu A, Anand RB (2016) Emission control strategy by adding alumina and cerium oxide nanoparticle in biodiesel. J Energy Inst 89:366–372CrossRefGoogle Scholar
  30. Sáez-Bastante J, Pinzi S, Reyero I, Priego-Capote F, Luque De Castro MD, Dorado MP (2014) Biodiesel synthesis from saturated and unsaturated oils assisted by the combination of ultrasound, agitation and heating. Fuel 131:6–16CrossRefGoogle Scholar
  31. Sajeevan AC, Sajith V (2013) Diesel Engine Emission Reduction Using Catalytic Nanoparticles: An Experimental Investigation. J Eng 2013:1–9CrossRefGoogle Scholar
  32. Sakthivel G, Nagarajan G, Ilangkumaran M, Gaikwad AB (2014) Comparative analysis of performance, emission and combustion parameters of diesel engine fuelled with ethyl ester of fish oil and its diesel blends. Fuel 132:116–124CrossRefGoogle Scholar
  33. Sharma SK, Das RK, Sharma A (2016) Improvement in the performance and emission characteristics of diesel engine fueled with Jatropha methyl ester and tyre pyrolysis oil by addition of nanoadditives. J Braz Soc Mech Sci Eng 38:1907–1920CrossRefGoogle Scholar
  34. Sivakumar M, Shanmuga Sundaram N, Ramesh kumar R, Syed Thasthagir MH (2018) Effect of aluminium oxide nanoparticles blended pongamia methyl ester on performance, combustion and emission characteristics of diesel engine. Renew Energy 116:518–526CrossRefGoogle Scholar
  35. Stone R (1989) Introduction to internal combustion engines. 2nd ed. Macmillan Press Ltd. J Chem Inf Model. doi:  https://doi.org/10.1017/CBO9781107415324.004
  36. Tang Z, Huang Q, Cheng J, Yang Y, Yang J, Guo W, Nie Z, Zeng N, Jin L (2014) Polybrominated diphenyl ethers in soils, sediments, and human hair in a plastic waste recycling area: a neglected heavily polluted area. Environ Sci Technol 48:1508–1516CrossRefGoogle Scholar
  37. Venu H, Madhavan V (2016) Effect of Al2O3 nanoparticles in biodiesel-diesel-ethanol blends at various injection strategies: performance, combustion and emission characteristics. Fuel 186:176–189.  https://doi.org/10.1016/j.fuel.2016.08.046 CrossRefGoogle Scholar
  38. Wright SL, Thompson RC, Galloway TS (2013) The physical impacts of microplastics on marine organisms: a review. Environ Pollut 178:483–492CrossRefGoogle Scholar
  39. Yuvarajan D, Ramanan MV (2016) Effect of magnetite ferrofluid on the performance and emissions characteristics of diesel engine using methyl esters of mustard oil. Arab J Sci Eng 41:2023–2030CrossRefGoogle Scholar

Copyright information

© Springer-Verlag GmbH Germany, part of Springer Nature 2019

Authors and Affiliations

  1. 1.Department of Mechanical EngineeringSNS College of TechnologyCoimbatoreIndia

Personalised recommendations