Advertisement

Effect of the nonlinear displacement-dependent characteristics of a hydraulic damper on high-speed rail pantograph dynamics

  • Wenlin WangEmail author
  • Yuwen Liang
  • Weihua Zhang
  • Simon Iwnicki
Original Paper
  • 30 Downloads

Abstract

A new simplified parametric model, which is more suitable for pantograph–catenary dynamics simulation, is proposed to describe the nonlinear displacement-dependent damping characteristics of a pantograph hydraulic damper and validated by the experimental results in this study. Then, a full mathematical model of the pantograph–catenary system, which incorporates the new damper model, is established to simulate the effect of the damping characteristics on the pantograph dynamics. The simulation results show that large \(F_{\mathrm{const}}\) (saturation damping force of the damper during compression) and \(C_{\mathrm{0}}\) (initial damping coefficient of the damper during extension) in the pantograph damper model can improve both the raising performance and contact quality of the pantograph, whereas a large \(C_{\mathrm{0}}\) has no obvious effect on the lowering time of the pantograph; the nonlinear displacement-dependent damping characteristics described by the second item in the new damper model have dominating effects on the total lowering time, maximum acceleration and maximum impact acceleration of the pantograph. Thus, within the constraint of total lowering time, increasing the nonlinear displacement-dependent damping coefficient of the damper will improve the lowering performance of the pantograph and reduce excessive impact between the pantograph and its base frame. In addition, damping performance of the new damper model would vary with the vehicle speeds, when operating beyond the nominal-speed range of the vehicle, the damping performance would deteriorate obviously. The proposed concise pantograph hydraulic damper model appears to be more adaptive to working conditions of the pantograph, and more complete and accurate than the previous single-parameter linear model, so it is more useful in the context of pantograph–catenary dynamics simulation and further parameter optimizations. The obtained simulation results are also valuable and instructive for further optimal specification of railway pantograph hydraulic dampers.

Keywords

Pantograph hydraulic damper Displacement dependent Nonlinear damping characteristics Pantograph–catenary dynamics Contact quality Raising and lowering performance 

Notes

Acknowledgements

The authors gratefully acknowledge financial support from the National Natural Science Foundation of China (Grant No. 11572123), the Joint Funds of Hunan Provincial Natural Science Foundation and Zhuzhou Science and Technology Bureau (Grant No. 2017JJ4015), the State Key Laboratory of Traction Power in Southwest Jiaotong University (Grant No. TPL1609) and the Research Fund for High-level Talent of Dongguan University of Technology (Project No. GC200906-30).

Compliance with ethical standards

Conflict of interest

The authors declared no potential conflicts of interest with respect to this research, authorship, and/or publication of this article.

References

  1. 1.
    Zhang, W.H.: The development of China’s high-speed railway systems and a study of the dynamics of coupled systems in high-speed trains. IMechE, Part F: J. Rail Rapid Transit 228(4), 367–377 (2014)Google Scholar
  2. 2.
    Pombo, J., Ambrósio, J.: Influence of pantograph suspension characteristics on the contact quality with the catenary for high speed trains. Comput. Struct. 110–111, 32–42 (2012)CrossRefGoogle Scholar
  3. 3.
    Lopez-Garcia, O., Carnicero, A., Maroño, J.L.: Influence of stiffness and contact modelling on catenary-pantograph system dynamics. J. Sound Vib. 299(4), 806–821 (2007)CrossRefGoogle Scholar
  4. 4.
    Kim, J.W., Chae, H.C., Park, B.S., Lee, S.Y., Han, C.S., Jang, J.H.: State sensitivity analysis of the pantograph system for a high-speed rail vehicle considering span length and static uplift force. J. Sound Vib. 303(3–5), 405–427 (2007)CrossRefGoogle Scholar
  5. 5.
    Cho, Y.H.: Numerical simulation of the dynamic responses of railway overhead contact lines to a moving pantograph considering a nonlinear dropper. J. Sound Vib. 315, 433–454 (2008)CrossRefGoogle Scholar
  6. 6.
    Cho, Y.H., Lee, K., Park, Y., Kang, B., Kim, K.: Influence of contact wire pre-sag on the dynamics of pantograph-railway catenary. Int. J. Mech. Sci. 52(11), 1471–1490 (2010)CrossRefGoogle Scholar
  7. 7.
    Bautista, A., Montesinos, J., Pintado, P.: Dynamic interaction between pantograph and rigid overhead lines using a coupled FEM—multibody procedure. Mech. Mach. Theory 97, 100–111 (2016)CrossRefGoogle Scholar
  8. 8.
    Gregori, S., Tur, M., Nadal, E., Aguado, J.V., Fuenmayor, F.J., Chinesta, F.: Fast simulation of the pantograph—catenary dynamic interaction. Finite Elem. Anal. Des. 129, 1–13 (2017)CrossRefGoogle Scholar
  9. 9.
    Zhang, W.H., Liu, Y., Mei, G.M.: Evaluation of the coupled dynamical response of a pantograph-catenary system: contact force and stresses. Veh. Syst. Dyn. 44(8), 645–658 (2006)CrossRefGoogle Scholar
  10. 10.
    Benet, J., Cuartero, N., Cuartero, F., Rojo, T., Tendero, P., Arias, E.: An advanced 3D-model for the study and simulation of the pantograph catenary system. Transp. Res. Part C 36, 138–156 (2013)CrossRefGoogle Scholar
  11. 11.
    Song, Y., Ouyang, H.J., Liu, Z.G., Mei, G.M., Wang, H.R., Lu, X.B.: Active control of contact force for high-speed railway pantograph-catenary based on multi-body pantograph model. Mech. Mach. Theory 115, 35–59 (2017)CrossRefGoogle Scholar
  12. 12.
    Zhou, N., Zhang, W.H.: Investigation on dynamic performance and parameter optimization design of pantograph and catenary system. Finite Elem. Anal. Des. 47(3), 288–295 (2011)CrossRefGoogle Scholar
  13. 13.
    Ma, G.N.: A study on the pantograph-catenary system. Master’s degree thesis, South-west Jiaotong University (2009) (in Chinese)Google Scholar
  14. 14.
    Lee, J.H., Kim, Y.G., Paik, J.S., Park, T.W.: Performance evaluation and design optimization using differential evolutionary algorithm of the pantograph for the high-speed train. J. Mech. Sci. Tech. 26(10), 3253–3260 (2012)CrossRefGoogle Scholar
  15. 15.
    Ambrósio, J., Pombo, J., Pereira, M.: Optimization of high-speed railway pantographs for improving pantograph-catenary contact. Theor. Appl. Mech. Lett. 3(1), 013006 (2013)CrossRefGoogle Scholar
  16. 16.
    Kim, J.W., Yu, S.N.: Design variable optimization for pantograph system of high-speed train using robust design technique. Int. J. Precis. Eng. Man. 14(2), 267–273 (2013)MathSciNetCrossRefGoogle Scholar
  17. 17.
    Mellado, A.C., Gómez, E., Viñolas, J.: Advances on railway yaw damper characterisation exposed to small displacements. Int. J. Heavy Veh. Syst. 13(4), 263–280 (2006)CrossRefGoogle Scholar
  18. 18.
    Alonso, A., Giménez, J.G., Gomez, E.: Yaw damper modelling and its influence on railway dynamic stability. Veh. Syst. Dyn. 49(9), 1367–1387 (2011)CrossRefGoogle Scholar
  19. 19.
    Wang, W.L., Yu, D.S., Huang, Y., Zhou, Z., Xu, R.: A locomotive’s dynamic response to in-service parameter variations of its hydraulic yaw damper. Nonlinear Dyn. 77(4), 1485–1502 (2014)CrossRefGoogle Scholar
  20. 20.
    Wang, W.L., Zhou, Z.R., Yu, D.S., Qin, Q.H., Iwnicki, S.: Rail vehicle dynamic response to the nonlinear physical in-service model of its secondary suspension hydraulic dampers. Mech. Syst. Signal Proc. 95, 138–157 (2017)CrossRefGoogle Scholar
  21. 21.
    Oh, J.S., Shin, Y.J., Koo, H.W., Kim, H.C., Park, J., Choi, S.B.: Vibration control of a semi-active railway vehicle suspension with magneto-rheological dampers. Adv. Mech. Eng. 8(4), 1–13 (2016)CrossRefGoogle Scholar
  22. 22.
    Stein, G.J., Múčka, P., Gunston, T.P.: A study of locomotive driver’s seat vertical suspension system with adjustable damper. Veh. Syst. Dyn. 47(3), 363–386 (2009)CrossRefGoogle Scholar
  23. 23.
    Wang, W.L., Zhou, Z.R., Zhang, W.H., Iwnicki, S.: A new nonlinear displacement-dependent parametric model of a high-speed rail pantograph hydraulic damper. Veh. Syst. Dyn.  https://doi.org/10.1080/00423114.2019.1578385 (2019)
  24. 24.
  25. 25.
    Zhang, W.H.: Dynamic Simulation of Railway Vehicles. China Railway Publishing House, Beijing (2006). (in Chinese)Google Scholar
  26. 26.
    Guo, J.B.: Stable current collection and control for high-speed locomotive pantograph. Ph.D. thesis, Beijing Jiaotong University (2006) (in Chinese)Google Scholar
  27. 27.
    Chinese National Standard: Railway applications—Rolling stock—Pantographs—Characteristics and tests—Part 1: Pantographs for mainline vehicles, GB/T 21561.1–2008 (2008) (in Chinese)Google Scholar

Copyright information

© Springer Nature B.V. 2019

Authors and Affiliations

  1. 1.School of Mechanical EngineeringDongguan University of TechnologyDongguanPeople’s Republic of China
  2. 2.College of Mechanical and Vehicle EngineeringHunan UniversityChangshaPeople’s Republic of China
  3. 3.State Key Laboratory of Traction PowerSouthwest Jiaotong UniversityChengduPeople’s Republic of China
  4. 4.Institute of Railway ResearchUniversity of HuddersfieldHuddersfieldUK

Personalised recommendations