Advertisement

Stress relaxation effect on fatigue life of biaxial prestressed woven E-glass/polyester composites

  • Nawras H. MostafaEmail author
Article
  • 11 Downloads

Abstract

In this study, the stress relaxation effect on the fatigue cycles-to-failure of the biaxial elastic fibre prestressed woven composite (E-glass/polyester) was investigated. The fibre pretension load was applied prior and during matrix cure, and then it has been released to induce compressive residual stresses within the matrix. The longevity of these stresses is questionable, and it needs investigation. The time of residual stress redistribution or relaxation was estimated experimentally for the E-glass fibre prestressing level be equal to 50 MPa. Residual stresses within the polyester matrix have declined by (27%) throughout 110 days leading to reduce the improved fatigue life by about 14% due to the stress relaxation process within the polyester matrix material. The study showed that even though the stress relaxation in the matrix reduced the improved fatigue cycles of the biaxial elastic prestressed E-glass fabric/polyester resin system, some improvement still is possible for long-term performance.

Keywords

Stress relaxation Elastic fibre prestressed composite Residual stress Fatigue life 

References

  1. Ashby, M.F., Jones, D.R.H.: Engineering Materials 1: An Introduction to Properties, Applications, and Design. Elsevier, The Boulevard, Langford Lane, Kidlington, Oxford (2012) Google Scholar
  2. Batra, S.: Creep Rupture and Life Prediction of Polymer Composites (2009) Google Scholar
  3. Fancey, K.S.: Composite fibre-containing materials, UK, Patent Number: 2281299B, 1997 Google Scholar
  4. Fancey, K.S.: A mechanical model for creep, recovery and stress relaxation in polymeric materials. J. Mater. Sci. 40, 4827–4831 (2005) CrossRefGoogle Scholar
  5. Fancey, K.S.: Viscoelastically prestressed polymeric matrix composites: an overview. J. Reinf. Plast. Compos. 35, 1290–1301 (2016) CrossRefGoogle Scholar
  6. Farrahi, G.H., Smith, D.J., Zhu, W.X., McMahon, C.A.: Influence of residual stress on fatigue life of hot forged and shot blasted steel components. Int. J. Eng. Trans. A Basics, Trans. B Appl. 15, 79–86 (2002) Google Scholar
  7. Fazal, A., Fancey, K.S.: UHMWPE fibre-based composites: prestress-induced enhancement of impact properties. Composites, Part B, Eng. 66, 1–6 (2014) CrossRefGoogle Scholar
  8. Fu, J., Liu, W., Liu, X., Tuladhar, S.L., Wan, Q., Wang, H.: Properties of a new dental photocurable resin based on the expanding monomer and three-component photoinitiator system. J. Wuhan Univ. Technol. Sci. Ed. 29, 384–390 (2014) CrossRefGoogle Scholar
  9. Gangaraj, S.M.H., Farrahi, G.H.: Side effects of shot peening on fatigue crack initiation life. Int. J. Eng., Trans. A: Basics 24, 275–280 (2011) Google Scholar
  10. Gopal, A.K., Adali, S., Verijenko, V.E.: Optimal temperature profiles for minimum residual stress in the cure process of polymer composites. Compos. Struct. 48, 99–106 (2000) CrossRefGoogle Scholar
  11. Kang, G., Liu, Y., Wang, Y., Chen, Z., Xu, W.: Uniaxial ratchetting of polymer and polymer matrix composites: time-dependent experimental observations. Mater. Sci. Eng. A 523, 13–20 (2009) CrossRefGoogle Scholar
  12. Korenev, S.: Electron beam curing of composites. Vacuum 62, 233–236 (2001) CrossRefGoogle Scholar
  13. Krishnamurthy, S.: Prestressed Advanced Fibre Reinforced Composites: Fabrication and Mechanical Performance (2006) Google Scholar
  14. Metehri, A., Serier, B., Bachir bouiadjra, B., Belhouari, M., Mecirdi, M.A.: Numerical analysis of the residual stresses in polymer matrix composites. Mater. Des. 30, 2332–2338 (2009) CrossRefGoogle Scholar
  15. Miravalles, M.: The Creep Behaviour of Adhesives: A Numerical and Experimental Investigation (2007) Google Scholar
  16. Mostafa, N.H., Ismarrubie, Z., Sapuan, S., Sultan, M.: Effect of equi-biaxially fabric prestressing on the tensile performance of woven E-glass/polyester reinforced composites. J. Reinf. Plast. Compos. 35, 1093–1103 (2016a) CrossRefGoogle Scholar
  17. Mostafa, N.H., Ismarrubie, Z.N., Sapuan, S.M., Sultan, M.T.H.: Effect of equi-biaxially fabric prestressing on the tensile performance of woven E-glass/polyester reinforced composites. J. Reinf. Plast. Compos. 35 (2016b) Google Scholar
  18. Mostafa, N.H., Ismarrubie, Z.N., Sapuan, S.M., Sultan, M.T.H.: Effect of fabric biaxial prestress on the fatigue of woven E-glass/polyester composites. Mater. Des. 92 (2016c) Google Scholar
  19. Mostafa, N.H., Ismarrubie, Z.N., Sapuan, S.M., Sultan, M.T.H.: Fibre prestressed composites: theoretical and numerical modelling of unidirectional and plain-weave fibre reinforcement forms. Compos. Struct. 159, 410–423 (2017) CrossRefGoogle Scholar
  20. Mostafa, N.H., Ismarrubie, Z.N., Sapuan, S.M., Sultan, M.T.H.: Theoretical development of biaxial fabric prestressed composites under tensile or flexural loading. In: IOP Conference Series: Materials Science and Engineering (2018a) Google Scholar
  21. Mostafa, N.H., Ismarrubie, Z.N., Sapuan, S.M., Sultan, M.T.H.: Theoretical development of biaxial fabric prestressed composites under tension-tension fatigue loading. Pertanika J. Sci. Technol. 26, 1253–1264 (2018b) Google Scholar
  22. Naghashian, S., Fox, B.L., Barnett, M.R.: Actuation curvature limits for a composite beam with embedded shape memory alloy wires. Smart Mater. Struct. 23, 1–10 (2014) CrossRefGoogle Scholar
  23. Naik, N.K., Ganesh, V.K.: An analytical method for plain weave fabric composites. Composites 26, 281–289 (1995) CrossRefGoogle Scholar
  24. Pang, J.W.C., Fancey, K.S.: An investigation into the long-term viscoelastic recovery of Nylon 6, 6 fibres through accelerated ageing. Mater. Sci. Eng. A 431, 100–105 (2006) CrossRefGoogle Scholar
  25. Papanicolaou, G.C., Zaoutsos, S.P.: Viscoelastic constitutive modeling of creep and stress relaxation in polymers and polymer matrix composites. In: Guedes, R.M. (ed.) Creep and Fatigue in Polymer Matrix Composites, pp. 3–47. Woodhead Publishing Limited, Cambridge (2011) CrossRefGoogle Scholar
  26. Parlevliet, P.P., Bersee, H.E.N., Beukers, A.: Residual stresses in thermoplastic composites—a study of the literature. Part III: Effects of thermal residual stresses. Composites, Part A, Appl. Sci. Manuf. 38, 1581–1596 (2007) CrossRefGoogle Scholar
  27. Safarabadi, M., Shokrieh, M.M.: Residual stresses in composite materials. In: Shokrieh, M.M. (ed.) Residual Stresses in Composite Materials, pp. 197–232. Woodhead Publishing Limited, Cambridge (2014) CrossRefGoogle Scholar
  28. Talreja, R., Singh, C.V.: Damage and Failure of Composite Materials. Cambridge University Press, University Press, Cambridge (2012) CrossRefGoogle Scholar
  29. White, S.R., Hahn, H.T.: Cure cycle optimization for the reduction of processing-induced residual stresses in composite materials. J. Compos. Mater. 27, 1352–1378 (1993) CrossRefGoogle Scholar
  30. Zhigun, I.G.: Experimental evaluation of the effect of prestressing the fibers in two directions on certain elastic characteristic of woven-glass reinforced plastics. Polym. Mech. 4, 691–695 (1968) CrossRefGoogle Scholar

Copyright information

© Springer Nature B.V. 2019

Authors and Affiliations

  1. 1.Department of Mechanical Engineering, Faculty of EngineeringUniversity of BabylonAl-Hillah CityIraq

Personalised recommendations