Advertisement

Effect of Al2O3 on the Microhardness of AMg2/Graphite Nanocomposite Powder Gas Dynamic Coatings on Aluminum Alloys

  • A. V. AborkinEmail author
  • V. E. Arkhipov
  • N. V. Sachkova
  • A. E. Sychev
  • M. I. Alymov
Article
  • 1 Downloads

Mechanically synthesized hybrid powders of the AMg2/graphite + Al2O3 system and coatings deposited by cold gas dynamic spraying from these powders are studied. The effect of Al2O3 concentration in the powder on surface morphology, structure and microhardness of the coatings formed is determined.

Key words

mechanical synthesis milling gas dynamic spraying hybrid coatings structure microhardness 

Notes

Research was carried with partial financial support of the RFFI within the scope of scientific project 16-48-330156p a. In order to perform research equipment of the distribution center of the collective usage of ASMAN RAN was used.

References

  1. 1.
    A. P. Alkhimov, V. F. Kosarev and A. N. Papyrin, “Method cold gas-dynamic deposition,” Soviet Physics Doklady, 35(12), 1047–1049 (1990).Google Scholar
  2. 2.
    C. Suryanarayana, “Mechanical alloying and milling,” Progr. Mater. Sci., 46, 1 – 184 (2001).CrossRefGoogle Scholar
  3. 3.
    C. Suryanarayana, “Nanocrystalline materials,” Int. Mater. Rev., 40, 41 – 64 (1995).CrossRefGoogle Scholar
  4. 4.
    A. V. Aborkin, I. A. Evdokimov, V. E. Vaganov, et al., “Influence of mechanical activation mode on morphology and phase composition of Al – 2Mg – nC nanostructured composite material,” Nanotechnologies in Russia, 11(5 – 6), 297 – 304 (2016).CrossRefGoogle Scholar
  5. 5.
    L. Ajdelsztajn, B. Jodoin, G. E. Kimand J. M. Schoenung, “Cold spray deposition of nanocrystalline aluminum alloys,” Metall. Mater. Trans. A, 36, 657 – 666 (2005).CrossRefGoogle Scholar
  6. 6.
    P. Richer, B. Jodoin, L. Ajdelsztajn, and E. J. Lavernia, “Substrate roughness and thickness effects on cold spray nanocrystalline Al – Mg coating,” J. Thermal Spray Technol., 15(5 – 6), 246 – 254 (2006).CrossRefGoogle Scholar
  7. 7.
    B. Jodoin, L. Ajdelsztajn, E. Sansoucy, et al., “Effect of particle size, morphology, and hardness on cold gas dynamic sprayed aluminum alloy coatings,” Surf. Coat. Technol., 201(6), 3422 – 3429 (2006).CrossRefGoogle Scholar
  8. 8.
    E. Irissou, J.-G. Legoux, B. Arsenault, and C. Moreau, “Investigation of Al – Al2O3 cold spray coating formation and properties,” J. Thermal Spray Technol., 16(5 – 6), 661 – 668 (2007).CrossRefGoogle Scholar
  9. 9.
    A. S. Oryshchenko and D. A. Gerashchenkov, “Aluminum matrix functional coatings with high microhardness on the basis of Al – Sn + Al2O3 composite powders fabricated by cold gas dynamic spraying,” Inorg. Mater.: Appl. Res., 7(6), 863 – 867 (2016).CrossRefGoogle Scholar
  10. 10.
    V. E. Arkhipov, A. F. Londarskii, G. V. Moskvitin, and M. S. Pugachev, Gas Dynamic Spraying Coating Structure and Properties [in Russian], KRASAND, Moscow (2017).Google Scholar
  11. 11.
    A. V. Aborkin, M. I. Alymov, V. E. Arkhipov, and D. S. Khrenov, “Formation of heterogeneous powder coatings with two-level micro- and nano-composite structure under gas dynamic spraying conditions,” Dokl. Akad. Nauk, 478(6), 1 – 5 (2018).Google Scholar
  12. 12.
    A. V. Aborkin, M. I. Alymov, A. V. Kireev, et al., “Mechanically synthesized composite powder based on AMg2 alloy with graphite additives: Particle size distribution and structural phase composition,” Nanotechnologies in Russia, 12(7 – 8), 383 – 387 (2017).Google Scholar
  13. 13.
    D. A. Gerashchenkov, B. V. Farmakovskii, A. F. Vasil’ev, and A. Ch. Mashek, “Study of the flow temperature in cold gas dynamic spraying of functional coatings,” Vopr. Materialoved., No. 2(77), 87 – 96 (2014).Google Scholar
  14. 14.
    S. Yin, X. Wang W. Y. Li, and H. Jie, “Effect of substrate hardness on the deformation behavior of subsequently incident particles in cold spraying,” Appl. Surf. Sci., 257, 7560 – 7565 (2011).CrossRefGoogle Scholar
  15. 15.
    O. Cetin, O. Tazegul, and E. S. Kayali, “Effect of parameters to the coating formation during cold spray process,” in: Proceedings of the 2nd World Congress on Mechanical, Chemical, and Material Engineering (MCM’16) (2016), pp. 1401 – 1407.Google Scholar
  16. 16.
    A. V. Aborkin, M. I. Alymov, A. V. Kireev, A. V. Sobol’kov, and V. E. Arkhipov, “Structure and efficiency of gas dynamic spraying of hybrid coatings based on a nano-crystalline aluminum matrix,” Metallurg, No. 8, 73 – 77 (2018).Google Scholar

Copyright information

© Springer Science+Business Media, LLC, part of Springer Nature 2019

Authors and Affiliations

  • A. V. Aborkin
    • 1
    Email author
  • V. E. Arkhipov
    • 2
  • N. V. Sachkova
    • 3
  • A. E. Sychev
    • 3
  • M. I. Alymov
    • 3
  1. 1.A. G. and N. G. Stoletov Vladimir State UniversityVladimirRussia
  2. 2.A. A. Blagonravov Engineering InstituteRussian Academy of SciencesMoscowRussia
  3. 3.A. G. Merzhanov Institute of Structural Macrokinetics and Materials Science Problems, Russian Academy of SciencesChernogolovkaRussia

Personalised recommendations