Advertisement

Flame retardancy and thermal degradation properties of polypropylene/wood flour composite modified with aluminum hypophosphite/melamine cyanurate

Article
  • 4 Downloads

Abstract

In this study, aluminum hypophosphite (AP) and melamine cyanurate (MCA) were used as flame retardant in polypropylene (PP)/wood flour (WF) composite. The flammability of the PP/WF composites was examined by the limiting oxygen index (LOI), vertical burning test (UL-94) and cone calorimeter test. When the PP/WF composite was loaded with 20% AP/MCA (the mass ratio of AP and MCA was 5: 1), the UL-94 achieved V-0 rating and the LOI was increased to 29.5%. In addition, the flexural strength was increased by about 11.0%. The results of cone calorimeter test revealed that the heat release rate and heat release rate peak of the PP/WF composite with AP/MCA were significantly reduced. The thermal degradation mechanism of PP/WF composites was investigated by thermo-gravimetric analysis, Fourier transform infrared spectrometry, energy-dispersive X-ray spectroscopy and scanning electron microscopy. The results indicate that AP/MCA had the effect of gas-phase and condensed-phase flame retardancy during the combustion and degradation of PP/WF composite. Consequently, a thermal property reinforcing mechanism of the PP/WF composite with AP/MCA was presented.

Keywords

Aluminum phosphate Melamine cyanurate Wood flour Flame retardance 

Notes

Acknowledgements

This work was financially supported by the National Natural Science Foundation of China (31570572 and 31670516) and Heilongjiang Key Project Technologies R&D Programme (GA15A101).

References

  1. 1.
    Klyosov AA. Wood-plastic composites. Hoboken: Wiley; 2007.CrossRefGoogle Scholar
  2. 2.
    Zhang QF, Cai HZ, Yang KY, Yi WM. Effect of biochar on mechanical and flame retardant properties of wood-plastic composites. Results Phys. 2017;7:2391–5.CrossRefGoogle Scholar
  3. 3.
    Hazarika A, Maji TK. Thermal decomposition kinetics, flammability, and mechanical property study of wood polymer nanocomposite. J Therm Anal Calorim. 2014;115:1679–91.CrossRefGoogle Scholar
  4. 4.
    Jacob A. WPC industry focuses on performance and cost. Reinf Plast. 2006;50:32–3.Google Scholar
  5. 5.
    Sun LC, Wu QL, Xie YJ, Song KL, Lee SY, Wang QW. Thermal decomposition of fire-retarded wood flour/polypropylene composites. J Therm Anal Calorim. 2016;123:309–18.CrossRefGoogle Scholar
  6. 6.
    Enamul Hoque M, Aminudin MAM, Jawaid M, Islam MS, Saba N, Paridah MT. Physical, mechanical, and biodegradable properties of meranti wood polymer composites. Mater Des. 2014;64:743–9.CrossRefGoogle Scholar
  7. 7.
    Wu QL, Chi K, Wu YQ, Lee SY. Mechanical, thermal expansion, and flammability properties of co-extruded wood polymer composites with basalt fiber reinforced shells. Mater Des. 2014;60:334–42.CrossRefGoogle Scholar
  8. 8.
    Annette N, Ina S, Matthias N. Material resistance of flame retarded wood-plastic composites against fire and fungal decay. Int Biodeterior Biodegrad. 2012;75:28–35.CrossRefGoogle Scholar
  9. 9.
    Ayrilmis N, Akbulut T, Dundar T, White RH, Mengeloglu F, Buyuksari U, Candan Z, Avci E. Effect of boron and phosphate compounds on physical, mechanical, and fire properties of wood-polypropylene composites. Constr Build Mater. 2012;33:63–9.CrossRefGoogle Scholar
  10. 10.
    Fang YQ, Wang QW, Guo CG, Song YM, Cooper PA. Effect of zinc borate and wood flour on thermal degradation and fire retardancy of polyvinyl chloride (PVC) composites. J Anal Appl Pyrol. 2013;100:230–6.CrossRefGoogle Scholar
  11. 11.
    Wang DY, Leuteritz A, Kutlu B, der Landwehr MA, Jehnichen D, Wagenknecht U, Heinrich G. Preparation and investigation of the combustion behavior of polypropylene/organomodified MgAl-LDH micro-nanocomposite. J Alloys Compd. 2011;509:3497–501.CrossRefGoogle Scholar
  12. 12.
    Bai G, Guo CG, Li LP. Synergistic effect of intumescent flame retardant and expandable graphite on mechanical and flame-retardant properties of wood flour-polypropylene composites. Constr Build Mater. 2014;50:148–53.CrossRefGoogle Scholar
  13. 13.
    Michael R, Clemens S, Uwe M, Harald S. Determination of reaction mechanisms and evaluation of flame retardants in wood-melamine resin-composites. J Anal Appl Pyrol. 2007;79:306–12.CrossRefGoogle Scholar
  14. 14.
    Seefeldt H, Braun U, Wagner MH. Residue stabilization in the fire retardancy of wood-plastic composites: combination of ammonium polyphosphate, expandable graphite, and red phosphorus. Macromol Chem Phys. 2012;213:2370–7.CrossRefGoogle Scholar
  15. 15.
    Covaci A, Harrad S, Abdallah MAE, Ali N, Law RJ, Herzke D, de Wit CA. Novel brominated flame retardants: a review of their analysis, environmental fate and behavior. Environ Int. 2011;37:532–56.CrossRefGoogle Scholar
  16. 16.
    Nie SB, Peng C, Yuan SJ, Zhang MX. Thermal and flame retardant properties of novel intumescent flame retardant polypropylene composites. J Therm Anal Calorim. 2013;113:865–71.CrossRefGoogle Scholar
  17. 17.
    Guan YH, Huang JQ, Yang JC, Shao ZB, Wang YZ. An effective way to flame-retard biocomposite with ethanolamine modified ammonium polyphosphate and its flame retardant mechanisms. Ind Eng Chem Res. 2015;54:3524–31.CrossRefGoogle Scholar
  18. 18.
    Jiang D, Pan MZ, Cai X, Zhao YT. Flame retardancy of rice straw-polyethylene composites affected by in situ polymerization of ammonium polyphosphate/silica. Compos Part A. 2018;109:1–9.CrossRefGoogle Scholar
  19. 19.
    Ge H, Tang G, Hu WZ, Wang BB, Pan Y, Song L, Hu Y. Aluminum hypophosphite microencapsulated to improve its safety and application to flame retardant polyamide 6. J Hazard Mater. 2015;294:186–94.CrossRefGoogle Scholar
  20. 20.
    Zhao B, Chen L, Long JW, Chen HB, Wang YZ. Aluminum hypophosphite versus alkyl-substituted phosphinate in polyamide 6: flame retardance, thermal degradation, and pyrolysis behavior. Ind Eng Chem Res. 2013;52:2875–86.CrossRefGoogle Scholar
  21. 21.
    Lu XS, Qiao XY, Yang T, Sun K, Chen XD. Preparation and properties of environmental friendly nonhalogen flame retardant melamine cyanurate/nylon 66 composites. J Appl Polym Sci. 2011;122:1688–97.CrossRefGoogle Scholar
  22. 22.
    Liu Y, Wang Q. The investigation on the flame retardancy mechanism of nitrogen flame retardant melamine cyanurate in polyamide 6. J Polym Res. 2009;16:583–9.CrossRefGoogle Scholar
  23. 23.
    Yan YW, Huang JQ, Guan YH, Shang K, Jian RK, Wang YZ. Flame retardance and thermal degradation mechanism of polystyrene modified with aluminum hypophosphite. Polym Degrad Stab. 2014;99:35–42.CrossRefGoogle Scholar
  24. 24.
    Wu NJ, Li XT. Flame retardancy and synergistic flame retardant mechanisms of acrylonitrile-butadiene-styrene composites based on aluminum hypophosphite. Polym Degrad Stab. 2014;105:265–76.CrossRefGoogle Scholar
  25. 25.
    Yuan BH, Bao CL, Guo YQ, Song L, Liew KM, Hu Y. Preparation and characterization of flame-retardant aluminum hypophosphite/poly(vinyl alcohol) composite. Ind Eng Chem Res. 2012;51:14065–75.CrossRefGoogle Scholar
  26. 26.
    Ceyda I, Jale H. Investigation of thermal degradation characteristics of polyamide-6 containing melamine or melamine cyanurate via direct pyrolysis mass spectrometry. J Anal Appl Pyrol. 2012;98:221–30.CrossRefGoogle Scholar
  27. 27.
    Jiao YH, Wang XL, Wang YZ, Wang DY, Zhai YL, Lin JS. Thermal degradation and combustion behaviors of flame-retardant polypropylene/thermoplastic polyurethane blends. J Macromol Sci B. 2009;48:887–909.Google Scholar

Copyright information

© Akadémiai Kiadó, Budapest, Hungary 2018

Authors and Affiliations

  1. 1.College of Materials and EnergySouth China Agricultural UniversityGuangzhouChina

Personalised recommendations