Journal of Polymer Research

, 25:35 | Cite as

A miscibility study on biodegradable poly butylene succinate/polydioxanone blends

  • Melika Ebrahimpour
  • Ali Akbar Safekordi
  • Seyed Mahmoud Mousavi
  • Amir Heydarinasab
ORIGINAL PAPER
  • 72 Downloads

Abstract

Poly (butylene succinate) (PBS) and poly (dioxanone) (PDO) blends, both biodegradable semi crystalline polyester and poly (ether-ester) respectively, were prepared with the ratio of PBS/PDO ranging from 80/20 to 20/80 by the solvent evaporation method. The miscibility behavior of PBS/PDO blends in aqueous solution has been determined by dilute solution viscometry. Huggins plots of each homopolymer and polymer blend have been determined in aqueous solution at 25, 30 and 40 °C temperatures. From the data obtained from Huggins plots the miscibility parameters ΔB, α, and μ have been calculated. In addition to solution viscosity measurements, blend films were tested by SEM and FTIR analysis methods for the investigation of blend miscibility in the solid state. The results have shown that PBS/PDO blend with a blend composition of (80/20) is immiscible in solution with negative miscibility parameter values for ΔB, α, and μ respectively. SEM results indicate this immiscibility as well.

Keywords

Poly (butylene succinate) Poly (dioxanone) Miscibility Viscosity 

References

  1. 1.
    Mokhtarzadeh A, Alibakhshi A, Hashemi M, Hejazi M, Hosseini V, Guardia M, Ramezani M (2016) Biodegradable nano-polymers as delivery vehicles for therapeutic small non-coding ribonucleic acids. J Control Release 245:116–126CrossRefGoogle Scholar
  2. 2.
    Jones JR (2009) New Trends in Bioactive Scaffolds: The Importance of Nanostructure. J Eur Ceram Soc 29:1275–1281CrossRefGoogle Scholar
  3. 3.
    Song L, Qiu Z (2009) Crystallization behavior and thermal property of biodegradable poly(butylene succinate)/functional multi walled carbon nanotubes nanocomposite. Polym Degrad Stab 94:632–637CrossRefGoogle Scholar
  4. 4.
    Ghaffarian V, Mousavi SM, Bahreini M, Afifi M (2013) Preparation and Characterization of Biodegradable Blend Membranes of PBS/CA. J Polym Environ 21:1150–1157CrossRefGoogle Scholar
  5. 5.
    Ghaffarian V, Mousavi SM, Bahreini M, Jalaei H (2014) Polyethersulfone/poly (butylene succinate) membrane: Effect of preparation conditions on properties and performance. J Ind Eng Chem 20:1359–1366CrossRefGoogle Scholar
  6. 6.
    Qiu ZB, Komura M, Ikehara T, Nishi T (2003) Miscibility and crystallization behavior of biodegradable blends of two aliphatic polyesters. Poly(butylene succinate) and poly(epsilon-caprolactone). Polymer 44:7749–7756CrossRefGoogle Scholar
  7. 7.
    Gan Z, Abe H, Kurokawa H, Doi Y (2001) Solid-state microstructures, thermal properties, and crystallization of biodegradable poly(butylene succinate) (PBS) and its copolyesters. Biomacromolecules 2:605–610CrossRefGoogle Scholar
  8. 8.
    Shih YF, Chen LS, Jeng RJ (2008) Preparation and properties of biodegradable PBS/multi-walled carbon nanotube nanocomposites. Polymer 49:4602–4611CrossRefGoogle Scholar
  9. 9.
    Sahoo S, Misra M, Mohanty A (2014) Biocomposites From Switchgrass and Lignin Hybrid and Poly(butylene succinate) Bioplastic: Studies on Reactive Compatibilization and Performance Evaluation. Macromol Mater Eng 299:178–189CrossRefGoogle Scholar
  10. 10.
    Han H, Wang X, Wu D (2013) Mechanical enhancement, morphology, and crystallization kinetics of polyoxymethylene-based composites with recycled carbon fiber. J Chem Technol Biotechnol 88:1200–1211CrossRefGoogle Scholar
  11. 11.
    Guo W, Zhang Y, Zhang W (2013) Mechanical properties and crystallization behavior of hydroxyapatite/poly(butylenes succinate) composites. J Biomed Mater Res 101A:2500–2506CrossRefGoogle Scholar
  12. 12.
    Eckelt A, Eckelt J, Wolf BA (2012) Interpolymer complexes and polymer compatibility. Macromol Rapid Commun 33:1933–1937CrossRefGoogle Scholar
  13. 13.
    Malaki Birjandi E (2013) Thesis master thesis. University, Eastern MediterraneanGoogle Scholar
  14. 14.
    Pamies R, Cifre JGH, Martínez MCL, Torre JG (2008) Determination of intrinsic viscosities of macromolecules and nanoparticles. Comparison of single-point and dilution procedures. Colloid Polym Sci 286:1223–1231CrossRefGoogle Scholar
  15. 15.
    Sudharsan Reddy K, Prabhakar MN, Kumara Babu P, Venkatesulu G, Sajan Kumarji Rao U, Chowdoji Rao K, Subha MCS (2012) Miscibility Studies of Hydroxypropyl Cellulose/Poly(Ethylene Glycol) in Dilute Solutions and Solid State. Int J Carbohydr Chem 2012:1–9CrossRefGoogle Scholar
  16. 16.
    Chee KK (1990) Determination of polymer-polymer miscibility by viscometry. Eur Polym J 26:423–426CrossRefGoogle Scholar
  17. 17.
    Jiang WH, Han SJ (1998) An improved criterion of polymer–polymer miscibility determined by viscometry. Eur Polym J 34:1579–1584CrossRefGoogle Scholar

Copyright information

© Springer Science+Business Media B.V., part of Springer Nature 2017

Authors and Affiliations

  • Melika Ebrahimpour
    • 1
  • Ali Akbar Safekordi
    • 1
  • Seyed Mahmoud Mousavi
    • 2
  • Amir Heydarinasab
    • 1
  1. 1.Department of Chemical Engineering, Science and Research BranchIslamic Azad UniversityTehranIran
  2. 2.Department of Chemical Engineering, Faculty of EngineeringFerdowsi University of MashhadMashhadIran

Personalised recommendations