Advertisement

Journal of Superconductivity and Novel Magnetism

, Volume 31, Issue 10, pp 3141–3146 | Cite as

Comparison of AC Losses of YBCO Circular Pancake Coils and Infinitely Long Stack Approximation

  • Guole Liu
  • Guomin Zhang
  • Liwei Jing
  • Liwang Ai
  • Wanjie Li
  • Shizhuo Liu
  • Qi Liu
Original Paper
  • 70 Downloads

Abstract

High-temperature superconducting (HTS) coils are key parts of many large-scale AC applications, such as transformers, superconducting magnetic energy storage, and motors. The estimation of AC losses of pancake coils is necessary for optimizing the design of HTS devices and cryogenic systems. To speed up the computation of AC losses, the numerical model of an infinitely long HTS stack is often utilized. An HTS stack is a good approximation of the circular coil only if the coil radius is sufficiently large, since AC losses will exhibit a stronger asymmetry along the radial direction for small values of coil radii. To assess the validation of an infinitely long stack approximation, the comparisons of AC losses between infinitely long stacks and circular coils with different radii are presented. The turn number varies from 10 to 80. We find that the AC losses of HTS circular coils will gradually increase to the same value as an infinitely long stack with increasing coil radii. A new parameter is proposed to quantitatively describe the correctness of infinitely long stack approximation. Finally, a method of AC loss estimation of HTS pancake coils is proposed.

Keywords

AC loss Infinitely long stack Pancake coil YBCO Finite element model 

Notes

Acknowledgements

The authors would like to acknowledge Dr. Hui Yu for her help in reading this manuscript and for providing valuable comments.

Funding Information

This work was supported in part by the National Natural Science Foundation of China under Grant 51677180 and in part by the Key Research Program of Frontier Science of the Chinese Academy of Sciences under Grant QYZDJ-SSW-JSC025.

References

  1. 1.
    Pardo, E. et al.: Ac loss modelling and measurement of superconducting transformers with coated-conductor Roebel-cable in low-voltage winding. Supercond. Sci. Technol. 28(11), 114008 (2015)ADSCrossRefGoogle Scholar
  2. 2.
    Liang, F. et al.: Experimental test of two types of non-inductive solenoidal coils for superconducting fault current limiters use. IEEE Trans. Appl. Supercond. 27(4), 1–5 (2017)CrossRefGoogle Scholar
  3. 3.
    Ainslie, M. et al.: Numerical analysis and finite element modelling of an HTS synchronous motor. Physica C: Superconductivity 470(20), 1752–1755 (2010)ADSCrossRefGoogle Scholar
  4. 4.
    Xing, D. et al.: AC loss comparison between multifilament and nonstriated YBCO coils designed for HTS propulsion motors. IEEE Trans. Appl. Supercond. 27(4), 1–5 (2017)CrossRefGoogle Scholar
  5. 5.
    Ainslie, M. D. et al.: An improved FEM model for computing transport AC loss in coils made of RABiTS YBCO coated conductors for electric machines. Supercond. Sci. Technol. 24(4), 045005 (2011)ADSCrossRefGoogle Scholar
  6. 6.
    Zhang, M. et al.: Experimental and numerical study of a YBCO pancake coil with a magnetic substrate. Supercond. Sci. Technol. 25(12), 125020 (2012)ADSCrossRefGoogle Scholar
  7. 7.
    Wang, L. et al.: Numerical simulation of AC loss in 2G high-temperature superconducting coils with 2D-axisymmetric finite element model by magnetic field formulation module. J. Supercond. Nov. Magn. 29(8), 2011–2018 (2016)CrossRefGoogle Scholar
  8. 8.
    Brambilla, R., Grilli, F., Martini, L.: Development of an edge-element model for AC loss computation of high-temperature superconductors. Supercond. Sci. Technol. 20(1), 16 (2007)ADSCrossRefGoogle Scholar
  9. 9.
    Zhang, M. et al.: Study of second generation, high-temperature superconducting coils: determination of critical current. J. Appl. Phys. 111(8), 083902 (2012)ADSCrossRefGoogle Scholar
  10. 10.
    Ainslie, M. D., Flack, T. J., Campbell, A. M.: Calculating transport AC losses in stacks of high temperature superconductor coated conductors with magnetic substrates using FEM. Physica C-Superconductivity and Its Applications 472(1), 50–56 (2012)ADSCrossRefGoogle Scholar
  11. 11.
    Yuan, W., Campbell, A. M., Coombs, T. A.: Ac losses and field and current density distribution during a full cycle of a stack of superconducting tapes. J. Appl. Phys. 107(9), 093909 (2010)ADSCrossRefGoogle Scholar
  12. 12.
    de Bruyn, B. J. H., Jansen, J. W., Lomonova, E. A.: Finite element model simplification methods for stacks of superconducting tapes. IEEE Trans. Magn. 52(7), 1–4 (2016)CrossRefGoogle Scholar
  13. 13.
    Yuan, W. et al.: Comparison of AC losses, magnetic field/current distributions and critical currents of superconducting circular pancake coils and infinitely long stacks using coated conductors. Supercond. Sci. Technol. 23(8), 085011 (2010)ADSCrossRefGoogle Scholar
  14. 14.
  15. 15.
    Liu, G. et al.: Influence of substrate magnetism on frequency-dependent transport loss in HTS-coated conductors. IEEE Trans. Appl. Supercond. 27(8), 1–7 (2017)CrossRefGoogle Scholar
  16. 16.
    Liu, G. et al.: Experimental and numerical study of frequency-dependent transport loss in YBa2Cu3O7–δ coated conductors with ferromagnetic substrate and copper stabilizer. J. Appl. Phys. 121(24), 243902 (2017)ADSCrossRefGoogle Scholar
  17. 17.
    Liu, G. et al.: Numerical study on AC loss reduction of stacked HTS tapes by optimal design of flux diverter. Supercond. Sci. Technol. 30(12), 125014 (2017)ADSCrossRefGoogle Scholar
  18. 18.
    Weast, R. C.: CRC Handbook of Chemistry and Physics, p 1438. CRC Press, Inc, Boca Raton (2001)Google Scholar
  19. 19.
    Lu, J., Choi, E., Zhou, H.: Physical properties of HastelloyⓇ C-276™ at cryogenic temperatures. J. Appl. Phys. 103(6), 064908 (2008)ADSCrossRefGoogle Scholar
  20. 20.
    Kim, Y., Hempstead, C., Strnad, A.: Critical persistent currents in hard superconductors. Phys. Rev. Lett. 9(7), 306 (1962)ADSCrossRefGoogle Scholar

Copyright information

© Springer Science+Business Media, LLC, part of Springer Nature 2018

Authors and Affiliations

  1. 1.Key Laboratory of Applied SuperconductivityChinese Academy of SciencesBeijingChina
  2. 2.Institute of Electrical EngineeringChinese Academy of SciencesBeijingChina
  3. 3.University of Chinese Academy of SciencesBeijingChina
  4. 4.Xi’an XD Electrical Research Institute Co. Ltd.Xi’anChina
  5. 5.Institute of ScienceInformation Engineering UniversityZhengzhouChina

Personalised recommendations