Surface trap effects on flashover voltages of epoxy/Al2O3 nanocomposites for high voltage insulation
- 23 Downloads
In this paper, surface trap distribution and the affected surface charge transport properties in epoxy/Al2O3 nanocomposites were studied to provide theoretical and experimental basis for improving surface flashover performance in vacuum. Four different contents of nano-Al2O3 particles were doped into epoxy and different trap distribution of samples was calculated from the surface potential decay method. Surface charge injection was identified by a direct current integrated charge [DCIC-Q(t)] method. Secondary electron emission (SEE) coefficient were obtained combing testing and fitting method. Results showed improved charge injection resistance, reduced charge mobility and SEE coefficient at a slight concentration of 0.5 wt% and 1 wt% by introducing deep traps. Continuing to increase nanoparticles in matrix was proved to reduce trap depth and have adverse effects. The surface flashover voltages reached the highest at 1 wt% nano-doping, which was in accordance with the percolate threshold loading content for trap depth, charge injection field and SEE coefficient. Surface charge injection caused the local field enhancement at the counter electrode and increased the possibility of surface flashover. Deep traps over 1 eV contributed to carrier capture, reduced charge injection and had a positive effect on increasing surface flashover voltage.
This work was supported by the National Key R&D Program of China (Grant Nos. 2017YFB0902700, 2017YFB0902702) and National Natural Science Foundation of China (NSFC) under Project with No. 51907147.
Compliance with ethical standards
Conflict of interest
On behalf of all authors, the corresponding authors state that there is no conflict of interest.
- 2.M.T. Nazir, B.T. Phung, S. Li, S. Yu, Comparative AC tracking and erosion resistance of micro-A1 N and BN filled silicone rubber composites, in IEEE Int’l Conference on Electrical Materials and Power Equipment (ICEMPE), (2017), p. 603–606Google Scholar
- 6.M. Tariq Nazir, X. Jiang, S. Akram, Laboratory investigation on hydrophobicity of new silicon rubber insulator under different environmental conditions. Int. J. Electr. Comput. Sci. 12, 1–8 (2012)Google Scholar
- 7.J. Zhan, H. Mu, G. Zhang, X. Huang, X. Shao, J. Deng, Cathode-like luminescence from vacuum-dielectric interface induced by self-stabilizing secondary electron emission. Appl. Phys. Lett. DOI 10(1063/1), 4738999 (2012)Google Scholar
- 10.J. Zhijie, F. Jianbin, L. Jinzhong et al., DC flashover characteristics of epoxy resin insulator with and without fillers under different SF6 gas pressures. Power Syst. Technol. 34, 155–159 (2010)Google Scholar
- 11.J.S. Rajan, K. Dwarakanath, N. Srinivasan, Surface flashover strength of different insulating materials in N2-SF6 gas mixtures under combined AC/DC voltages. in Proceedings of the International Symposium on Electrical Insulating Materials, (2001), p. 262–265Google Scholar
- 16.Y. Sekiguchi, M. Fukuma, Electrical charges and currents distribution analysis in plaque samples by the DCIC-Q(t) method, in Int’l Symposium on Electrical Insulating Materials (ISEIM), (2017), p. 609–612Google Scholar
- 20.A. Bahari, M. Babaeipour, B. Soltani, Theoretical investigation of quantum tunneling and self-energy phenomena in Al2O3/PVP nanocomposite. J. Mater. Sci. 27, 2131–2137 (2016)Google Scholar
- 22.S. Yu, S. Li, The relationship between surface flashover properties and trap characteristics of nanocomposites, in Int’l Conference on Condition Monitoring and Diagnosis (CMD), (2016), p. 960–963Google Scholar
- 26.Y. Sekiguchi, T. Takada, H. Miyake, T. Yasuhiro, A study on electric charge behaviors in polymeric materials using direct current integrated charge method, in Int’l Symposium on Electrical Insulating Materials, (2017), p. 691–694Google Scholar
- 27.S. Yu, S. Li, Surface flashover characteristics of EP/Al2O3 nanocomposites in different atmosphere, in IEEE Int’l Conference on Dielectrics (ICD), (2016), p. 120–123Google Scholar
- 29.B. Du, J. Li, H. Du, Effects of fluorination on surface charge accumulation and decay of polyimide film. Jpn. J. Appl. Phys. 52, 599–602 (2013)Google Scholar
- 36.Y. Novikov, A.V. Rakov, S.V. Sedov, A.N. Simonov, I. Yu Stekolin, I.B. Strizhkov, Secondary electron emission from a relief surface: effect of a relief depth. Phys. Chem. Mech. Surf. 10, 679–685 (1995)Google Scholar
- 37.J. Cazaux, A new model of dependence of secondary electron emission yield on primary electron energy for application to polymers. J. Appl. Phys. 38, 2433 (2005)Google Scholar
- 38.J. Li, B. Du, Y. Xing, J. Jin, Trap distribution and flashover characteristics of carbon-black-filled EPDM in low temperature. IEEE Trans. Appl. Supercond. 26, 1–5 (2016)Google Scholar
- 40.G. Zhang, W. Zhao, Z. Yan, Y. Liu, Optical investigation of AC preflashover of alumina ceramic in vacuum. IEEE Trans. Dielectr. Electr. Insul. 11, 498–505 (2004)Google Scholar