Advertisement

Journal of Materials Science

, Volume 42, Issue 24, pp 10080–10084 | Cite as

Precipitation of MC phase and precipitation strengthening in hot rolled Nb–Mo and Nb–Ti steels

  • Jianchun CaoEmail author
  • Qilong Yong
  • Qingyou Liu
  • Xinjun Sun
Article

Abstract

Hot rolled Nb–Mo steel of yield strength 600 MPa and Nb–Ti steel of yield strength 525 MPa with polygonal and acicular ferrite microstructure have been developed. Using physicochemical phase analysis, XRD, TEM and EDS, the distribution, morphology, composition, crystal structure and particle size of precipitates were observed and identified in these steels. The results revealed that the steels containing both Nb and Mo exhibited fine and uniformly distributed MC-type carbides, while the carbides were coarse and sparsely distributed in the steels containing Nb and Ti. The physicochemical phase analysis showed MC-type carbides contain both Nb and Mo, and the ratio of Mo/Nb was 0.41. Meanwhile, the mass% of the fine particles (<10 nm in size) of Nb–Mo steel was 58.4%, and higher than that of Nb–Ti steel with 30.0%. Therefore, the results of strengthening mechanisms analysis showed the higher strength of Nb–Mo steel than that of Nb–Ti steel is attributed to its relatively more prominent precipitation strengthening effect. The yield strength increments from precipitation hardening of Nb–Mo steel attained 182.7 MPa and higher than that of Nb–Ti steel.

Keywords

Ferrite Austenite Yield Strength Precipitation Hardening Precipitation Strengthen 

Notes

Acknowledgements

This work was financially supported by the National High Technology Research and Development Program of China (863 program, grant No. 2002AA302501) and the Natural science Foundation of Yunnan Province, (in China, grant No. 2006E0017Q).

References

  1. 1.
    Senuma T (2002) ISIJ International 42:1CrossRefGoogle Scholar
  2. 2.
    Akben MG, Bacroix B, Jonas JJ (1983) Acta Metallurgy 31:161CrossRefGoogle Scholar
  3. 3.
    Andrade HL, Akben MG, Jonas JJ (1983) Metall Trans A 14A:1967CrossRefGoogle Scholar
  4. 4.
    Lee WB, Hong SG, Park CG et al (2002) Metall Mater Trans A 33A:1689CrossRefGoogle Scholar
  5. 5.
    Lee WB, Hong SG, Park CG et al (2000) Scripta Mater 43:319CrossRefGoogle Scholar
  6. 6.
    Misra RDK, Weatherly GC, Hartmann JE et al (2001) Mater Sci Technol 17:1119CrossRefGoogle Scholar
  7. 7.
    Gladman T (1999) Mater Sci Technol 15:30CrossRefGoogle Scholar
  8. 8.
    Wada H (1986) Metall Trans A 17A:391CrossRefGoogle Scholar
  9. 9.
    Wada T, Wada H, Elliott JF, Chipman J (1972) Metall Trans 3:2865CrossRefGoogle Scholar

Copyright information

© Springer Science+Business Media, LLC 2007

Authors and Affiliations

  • Jianchun Cao
    • 1
    Email author
  • Qilong Yong
    • 2
  • Qingyou Liu
    • 2
  • Xinjun Sun
    • 2
  1. 1.Department of Materials and Metallurgy EngineeringKunming University of Science & TechnologyKunmingChina
  2. 2.Institute of Structural MaterialsCentral Iron & Steel Research InstituteBeijingChina

Personalised recommendations