Advertisement

Slope stability analysis and protection measures in bridge and tunnel engineering: a practical case study from Southwestern China

  • Shangqu Sun
  • Shucai Li
  • Liping Li
  • Shaoshuai ShiEmail author
  • Jing Wang
  • Jie Hu
  • Cong Hu
Original Paper

Abstract

This study addresses the instability problem of typical slopes in the engineering constructions of bridges and tunnels in Southwestern China by combining the results of detailed field monitoring, geological and geometrical investigation, and numerical simulations and then proposes comprehensive protection measures. The study area is a vital part of the Chengdu–Lanzhou high-speed railway in Sichuan Province, located in the 5·12 Wenchuan’s meizoseismic area. The slope stability was analysed based on the data collected by field monitoring. The results indicated that the slope toe was stable under a natural state, while a large deformation was observed occasionally owing to tunnel blasting and excavation. Subsequently, a digital binocular camera installed on a fixed-wing unmanned aerial vehicle was used to identify unstable rockmass. By analysing the slope and the dip direction angles, three potential paths of rockfall hazard were selected for further studies. A retaining wall and a soft protecting net were installed along the slope to intercept potential debris flow and possible falling rocks above the tunnel portal, respectively. A Mohr–Coulomb model was built using universal distinct element code to identify the rockfall initiation position. Overall, the field monitoring results were in good agreement with those obtained by numerical simulations. Moreover, the Rocscience Rocfall program was used to calculate the bounce height and the total kinetic energy of falling rocks. Finally, mitigation measures for the potential landslide, rockfall, and mudslide hazard were proposed and adopted in practical engineering applications, and aimed to provide a useful reference for similar engineering practices.

Keywords

Bridge and tunnel engineering High and steep slope Stability analysis Rockfall Protection measures 

Abbreviations

3D

Three-dimension

COR

Coefficient of restitution

DBLR

Digital binocular lens reflex

DEM

Digital elevation mode

ISRM

International society for rock mechanics

SNS

Soft net system

UAV

Unmanned aerial vehicle

UDEC

Universal distinct element code

Notes

Acknowledgements

This work was supported by the National Program on Key Basic Research Project of China (973 Program) (2013CB036000), the National Natural Science Foundation of China (No. 51679131), the National Natural Science Foundation of China (No. 51609129) and the Shandong Provincial Natural Science Foundation, China (No. ZR2014EEQ002).

References

  1. Asteriou P, Saroglou H, Tsiambaos G (2012) Geotechnical and kinematic parameters affecting the coefficients of restitution for rock fall analysis. Int J Rock Mech Min Sci 54:103–113CrossRefGoogle Scholar
  2. Azzoni A, De Freitas MH (1995) Experimentally gained parameters, decisive for rock fall analysis. Rock Mech Rock Eng 28(2):111–124CrossRefGoogle Scholar
  3. Bertolo P, Oggeri C, Peila D (2009) Full-scale testing of draped nets for rock fall protection. Can Geotech J 46(3):306–317CrossRefGoogle Scholar
  4. Chandler J (1999) Effective application of automated digital photogrammetry for geomorphological research. Earth Surf Process Landf 24(1):51–63CrossRefGoogle Scholar
  5. Chau KT, Wong RHC, Wu JJ (2002) Coefficient of restitution and rotational motions of rockfall impacts. Int J Rock Mech Min Sci 39(1):69–77CrossRefGoogle Scholar
  6. Chen Y, Li L, Li J, Li G (2008) Wenchuan earthquake: way of thinking is changed. Episodes 31(4):374–377Google Scholar
  7. Crosta GB, Agliardi F (2003) Failure forecast for large rock slides by surface displacement measurements. Can Geotech J 40(1):176–191CrossRefGoogle Scholar
  8. Cundall PA (1971) A computer model for simulating progressive largescale movemnets in blocks rock system. Proceedings of the Symposium of the International Society of Rock Mechanics. Nancy, FranceGoogle Scholar
  9. Dorren LKA, Berger F, Putters US (2006) Real-size experiments and 3-D simulation of rockfall on forested and non-forested slopes. Nat Hazards Earth Syst Sci 6(1):145–153CrossRefGoogle Scholar
  10. Evans SG, Hungr O (1993) The assessment of rockfall hazard at the base of talus slopes. Can Geotech J 30:620–636CrossRefGoogle Scholar
  11. Gottardi G, Govoni L (2010) Full-scale modelling of falling rock protection barriers. Rock Mech Rock Eng 43(3):261–274CrossRefGoogle Scholar
  12. Goodman RE (1989) Introduction to rock mechanics. Wiley, New YorkGoogle Scholar
  13. Guzzetti F, Crosta G, Detti R, Agliardi F (2002) STONE: a computer program for the three-dimensional simulation of rock-falls. Comput Geosci 28(9):1079–1093CrossRefGoogle Scholar
  14. Hambleton JP, Buzzi O, Giacomini A, Spadari M, Sloan SW (2013) Perforation of flexible rockfall barriers by normal block impact. Rock Mech Rock Eng 46(3):515–526CrossRefGoogle Scholar
  15. Hu J, Li SC, Li LP, Shi SS, Zhou ZQ, Liu HL, He P (2017) Field, experimental, and numerical investigation of a rockfall above a tunnel portal in southwestern China. Bull Eng Geol Environ 1–18Google Scholar
  16. Hu J, Li SC, Shi SS, Li LP, Zhang Q, Liu HL, He P (2018) Experimental study on parameters affecting the runout range of rockfall. Adv Civ Eng 1–9Google Scholar
  17. ISRM (1979) Suggested method for determining tensile strength of rock materials. Int J Rock Mech Min Sci Geomech 15:99–103Google Scholar
  18. ISRM (1981) Suggested method for determining the uniaxial compressive strength and deformability of rock materials. International Society for Rock Mechanics. Commision on Standardisation of Laboratory sand Field Tests 111–116Google Scholar
  19. Lane SN, James TD, Crowell MD (2000) Application of digital photogrammetry to complex topography for geomorphological research. Photogramm Rec 16(95):793–821CrossRefGoogle Scholar
  20. Li LP, Sun SQ, Li SC, Zhang QQ, Hu C, Shi SS (2015) Coefficient of restitution and kinetic energy loss of rockfall impacts. KSCE J Civ Eng 20(6):2297–2307CrossRefGoogle Scholar
  21. Lin P, Liu HY, Zhou WY (2015a) Experimental study on failure behaviour of deep tunnels under high in-situ stresses. Tunn Undergr Space Technol 46:28–45CrossRefGoogle Scholar
  22. Lin P, Liu XL, Hu SY, Li PJ (2016) Large deformation analysis of a high steep slope relating to the Laxiwa reservoir, China. Rock Mech Rock Eng 49(6):2253–2276CrossRefGoogle Scholar
  23. Lin P, Liu XL, Zhou WY, Wang RK, Wang SY (2015b) Cracking, stability and slope reinforcement analysis relating to the Jinping dam based on a geomechanical model test. Arab J Geosci 8(7):4393–4410CrossRefGoogle Scholar
  24. Mora P, Baldi P, Casula G, Fabris M, Ghirotti M, Mazzini E, Pesci A (2003) Global positioning systems and digital photogrammetry for the monitoring of mass movements: application to the Ca’di Malta landslide (northern Apennines, Italy). Eng Geol 68(1):103–121CrossRefGoogle Scholar
  25. Ohnishi Y, Nishiyama S, Yano T, Matsuyama H, Amano K (2006) A study of the application of digital photogrammetry to slope monitoring systems. Int J Rock Mech Min Sci 43(5):756–766CrossRefGoogle Scholar
  26. Peila D, Oggeri C, Castiglia C (2007) Ground reinforced embankments for rockfall protection: design and evaluation of full scale tests. Landslides 4(3):255–265CrossRefGoogle Scholar
  27. Rau JY, Jhan JP, Lo CF, Lin YS (2011) Landslide mapping using imagery acquired by a fixed-wing UAV. Int Arch Photogramm Remote Sens Spat Inf Sci 38:1–C22Google Scholar
  28. Ritchie AM (1963) Evaluation of rockfall and its control. Highw Res Rec (17)Google Scholar
  29. Rocscience (2004) RocFall user’s manual, Toronto, CanadaGoogle Scholar
  30. Sadagah B (2010) Rockfalls risk reduction and redesign of rock slopes using rocfall program. In ISRM International Symposium-6th Asian Rock Mechanics Symposium. International Society for Rock MechanicsGoogle Scholar
  31. Spang RM, Sönser T (1995) Optimized rockfall protection by "ROCKFALL". In 8th ISRM Congress. International Society for Rock MechanicsGoogle Scholar
  32. Sturzenegger M, Stead D (2009) Close-range terrestrial digital photogrammetry and terrestrial laser scanning for discontinuity characterization on rock cuts. Eng Geol 106(3):163–182CrossRefGoogle Scholar
  33. Sun SQ, Li LP, Li SC, Zhang QQ, Hu C (2017) Rockfall hazard assessment on Wangxia rock mass in Wushan (Chongqing, China). Geotech Geol Eng 35(4):1895–1905CrossRefGoogle Scholar
  34. Van TP, Maegawa K, Fukada S (2013) Experiments and dynamic finite element analysis of a wire-rope rockfall protective fence. Rock Mech Rock Eng 46(5):1183–1198CrossRefGoogle Scholar
  35. Volkwein A, Schellenberg K, Labiouse V (2011) Rockfall characterisation and structural protection – a review. Nat Hazards Earth Syst Sci 11:2617–2651CrossRefGoogle Scholar
  36. Wang ZC, Zong Z, Qiao LP, Li W (2018a) Transversely isotropic creep model for rocks. Int J Geomech 18(6):04018033.1-18CrossRefGoogle Scholar
  37. Wang ZC, Zong Z, Qiao LP, Li W (2018b) Elastoplastic model for transversely isotropic rocks. Int J Geomech 18(2):04017149.1-15Google Scholar
  38. Wang ZC, Li W, Li SC, Qiu WG, Ding WT (2018c) Development of an Optimum Forepole Spacing (OFS) determination method for tunnelling in silty clay with a case study. Tunn Undergr Space Technol 74:20–32CrossRefGoogle Scholar
  39. Wei LW, Chen H, Lee CF, Huang WK, Lin ML, Chi CC, Lin HH (2014) The mechanism of rockfall disaster: a case study from Badouzih, Keelung, in northern Taiwan. Eng Geol 183:116–126CrossRefGoogle Scholar
  40. Xu F, Li SC, Zhang QQ, Li LP, Shi SS, Zhang Q (2017) A new type support structure introduction and its contrast study with traditional support structure used in tunnel construction. Tunn Undergr Space Technol 63:171–182CrossRefGoogle Scholar
  41. Xu XW, Wen XZ, Yu GH, Chen GH, Klinger Y, Hubbard J, Shaw J (2009) Coseismic reverse-and oblique-slip surface faulting generated by the 2008 Mw 7.9 Wenchuan earthquake, China. Geology 37(6):515–518CrossRefGoogle Scholar
  42. Yuan YF (2008) Impact of intensity and loss assessment following the great Wenchuan earthquake. Earthq Eng Eng Vib 7(3):247–254CrossRefGoogle Scholar
  43. Zheng G, Xu Q, Du YB (2011) Evaluation of the stability and the study of engineering support measures for the high and steep rock slope in a bridge and tunnel engineering. J Chengdu Univ Technol (Sci Technol Ed) 38(4):430–437Google Scholar

Copyright information

© Springer-Verlag GmbH Germany, part of Springer Nature 2018

Authors and Affiliations

  1. 1.Geotechnical and Structural Engineering Research CenterShandong UniversityJinanChina
  2. 2.Laboratoire de Mecanique de Lille (LML)Ecole Centrale de LilleVilleneuve d’AscqFrance

Personalised recommendations