Advertisement

Residual factor as a variable in slope reliability analysis

  • Gautam BhattacharyaEmail author
  • Robin Chowdhury
  • Subhadeep Metya
Original Paper
  • 181 Downloads

Abstract

In the past, residual factor R in strain-softening soil slopes has been included, either directly or indirectly, as a deterministic variable in both deterministic and probabilistic studies. This paper discusses the uncertainties associated with R and outlines a systematic approach for the reliability analysis of a natural slope in which shear strength parameters and pore pressure ratio are random variables, each assumed with a lognormal probability distribution. For the residual factor R, seven probability distribution options under the generalized beta-distribution system are considered. Slope reliability is computed based on the first order reliability method (FORM) and validated against Monte-Carlo simulation (MCS). Results obtained from two illustrative examples indicate that the probability of failure, with R as one of six random variables, can be orders of magnitude higher than that based on five random variables with R considered as a deterministic parameter. The magnitude of influence of R as a random variable is, however, highly dependent on its probability distribution, the left-skewed triangular distribution having the most significant influence in both the examples. Results of sensitivity analyses reveal that, for almost all of its assumed probability distributions, R is the most dominant among the six random variables. Effects of variation of some of the statistical and correlation properties of the other random variables, viz. the shear strength parameters and the pore pressure ratio, on the results of reliability analyses are also studied.

Keywords

Slope reliability Peak and residual strengths Probability distribution Pore water pressure Coefficient of variation Correlation coefficient 

References

  1. Ang A.H-S Tang WH (1984) Probability concepts in engineering planning and design, vol. II. Decisions, risk, and reliability. Wiley, New YorkGoogle Scholar
  2. Bhattacharya G, Ojha S, Jana D, Chakraborty SK (2003) Direct search for minimum reliability index of earth slopes. Comput Geotech 30(6):455–462Google Scholar
  3. Cho SE (2007) Effects of spatial variability of soil properties on slope stability. Engng Geol 92(3–4):97–109Google Scholar
  4. Chowdhury R, Zhang S (1993) Modelling the risk of progressive slope failure: a new approach. Reliab Eng Syst Safe 40(1):17–30Google Scholar
  5. Chowdhury R, Tang WH, Sidi I (1987) Reliability model of progressive slope failure. Geotechnique 37(4):467–481Google Scholar
  6. Christian JT, Whitman RV (1969) A one-dimensional model for progressive failure. Proc. 7th Int. Conf. Soil Mech. Found. Engng, Mexico 2:541–545Google Scholar
  7. Duncan JM (2000) Factors of safety and reliability in geotechnical engineering. ASCE J Geotech Geoenv Eng 126(4):307–316Google Scholar
  8. Gilbert RB, Wright SG, Liedtke E (1998) Uncertaintuy in back analysis of slopes: Kettleman Hills case history. ASCE J Geotech Geoenv Eng 124(12):1167–1176Google Scholar
  9. Haldar A, Mahadevan S (2000) Probability, reliability, and statistical methods in engineering design. Wiley, New YorkGoogle Scholar
  10. Hamel JV, Adams WR Jr (2011) Discussion of “Shear Strength in Preexisting Landslides” by T.D. Stark and M. Hussain (2011). ASCE J Geotech Geoenv Eng 137(8):809–811Google Scholar
  11. Harr ME, (1977) Mechanics of particulate media-a probabilistic approach. McGraw-Hill, New YorkGoogle Scholar
  12. Hasofer AM, Lind NC (1974) An exact and invariant first order reliability format. ASCE J Eng Mech 100(EM-1):111–121Google Scholar
  13. Hassan AM, Wolff TF (1999) Search algorithm for minimum reliability index of earth slopes. ASCE J Geotech Geoenv Eng 125(4):301-308Google Scholar
  14. Hong HP, Roh G (2008) Reliability evaluation of earth slopes. ASCE J Geotech Geoenv Eng 134(12):1700–1705Google Scholar
  15. Huang J, Griffiths DV (2011) Observations on FORM in a simple geomechanics example. Struct Safe 33(1):115–119Google Scholar
  16. James PM (1971) The role of progressive failure in clay slopes. Proc. 1st Australia-New Zealand Conf. on Geomech, Melbourne 1:344–348Google Scholar
  17. Ji J, Liao HJ, Low BK (2012) Modeling 2-D spatial variation in slope reliability analysis using interpolated autocorrelations. Comput Geotech 40:135–146Google Scholar
  18. Jiang SH, Huang J (2016) Efficient slope reliability analysis at low-probability levels in spatially variable soils. Comput Geotech 75:18–27Google Scholar
  19. Jiang SH, Li DQ, Zhang LM, Zhou CB (2014) Slope reliability analysis considering spatially variable shear strength parameters using a non-intrusive stochastic finite element method. Eng Geol 168:120–128Google Scholar
  20. Khajehzadeh M, El-Shafie A, Taha MR (2010) Modified particle swarm optimization for probabilistic slope stability analysis. IJPS 5(15):2248–2258Google Scholar
  21. Li KS, Lumb P (1987) Probabilistic Design of Slopes. Can Geotech J 24:520–535Google Scholar
  22. Lo KY, Lee CF (1973) Stress analysis and slope stability in strain softening materials. Geotechnique 23(1):1–11Google Scholar
  23. Low BK, Tang WH (1997) Reliability analysis of reinforced embankments on soft ground. Can Geotech J 34(5):672–685Google Scholar
  24. Low BK, Tang WH (2004) Reliability analysis using object-oriented constrained optimisation. Struct Safe 26(1):69–89Google Scholar
  25. Lumb P (1970) Safety factors and the probability distribution of soil strength. Can Geotech J 7(3):225–242Google Scholar
  26. Matsuo M, Kuroda K (1974) Probabilistic approach to the design of embankments. Soils Found 14(1):1–17Google Scholar
  27. Mesri G, Shahien M (2003) Residual shear strength mobilized in first-time slope failures. ASCE J Geotech Geoenv Eng 129(1):12–31Google Scholar
  28. Metya S (2017) Reliability analysis of soil slopes using the first order reliability method. PhD dissertation, Indian Institute of Engineering Science and Technology (IIEST), Shibpur, IndiaGoogle Scholar
  29. Metya S, Bhattacharya G (2012) Slope reliability analysis using the first order reliability method. SRESA JLCRSE 1(3):1–7Google Scholar
  30. Metya S, Bhattacharya G (2014) Probabilistic critical slip surface for earth slopes based on the first order reliability method. Indian Geotech J 44(3):329–340Google Scholar
  31. Metya S, Bhattacharya G (2016a) Probabilistic stability analysis of the Bois Brule Levee considering the effect of spatial variability of soil properties based on a new discretization model. Indian Geotech J 46(2):152–163Google Scholar
  32. Metya S, Bhattacharya G (2016b) Reliability analysis of earth slopes considering spatial variability. Geotech Geolog Eng 34(1):103–123Google Scholar
  33. Metya S, Bhattacharya G, Chowdhury R (2016a). Reliability analysis of slopes in strain-softening soils considering critical slip surfaces. Innov Infrastruct Solut 1:35. doi:  https://dx.doi.org/10.1007/s41062-016-0033-8.
  34. Metya S, Dey S, Bhattacharya G, Chowdhury G (2016b) Reliability analysis of slopes in soils with strain-softening behaviour. Proc. of the Indian Geotechnical Conference (IGC 2016), at IIT Madras, India, Dec 15–17, 2016 (Paper ID – 512).Google Scholar
  35. Metya S, Mukhopadhyay T, Adhikari S, Bhattacharya G (2017) System reliability analysis of soil slopes with general slip surfaces using multivariate adaptive regression splines. Comput Geotech 87:212–228Google Scholar
  36. Morgenstern NR (1977) Slopes and excavations. State of the art report. Proc. 9th Int. Conf. Soil Mech. and Found. Engng, Tokyo 4:2201–2208.Google Scholar
  37. Rao SS (2009) Engineering optimisation-theory and practice, 4th edn. Wiley, New YorkGoogle Scholar
  38. Schittkowski K (1980) Nonlinear programming codes - information, tests, performance. Lecture notes in economics and mathematical systems, vol. 183. Springer, BerlinGoogle Scholar
  39. Skempton AW (1964) Long-term stability of clay slopes. Geotechnique 14(2):77–101Google Scholar
  40. Skempton AW (1966) Bedding plane slip, residual strength and the Vaiont landslide. Geotechnique 16(1):82–84Google Scholar
  41. Skempton AW (1985) Residual strength of clay in landslides, folded strata and the laboratory. Geotechnique 35(1):3–18Google Scholar
  42. Skempton AW, Petley DJ (1967) The strength along structural discontinuities in stiff clay. Proc. Geotechnical Conference, Oslo 2:29–47Google Scholar
  43. Skempton AW, Vaughan PR (1995) The failure of Carsington Dam. Discussion. Geotechnique 45(4):719–739Google Scholar
  44. Stark TD, Hussain M (2010) Shear strength in preexisting landslides. ASCE J Geotech Geoenv Eng 136(7):957–962Google Scholar
  45. Stark TD, Hussain M (2011) Closure to discussion on shear strength in preexisting landslides. ASCE J Geotech Geoenv Eng 137(8):811–812Google Scholar
  46. Wang Y, Cao Z, Au S-K (2011) Practical reliability analysis of slope stability by advanced Monte Carlo simulations in a spreadsheet. Can Geotech J 48(1):162–172Google Scholar
  47. Wolff TF (1985) Analysis and design of embankment dam slopes: a probabilistic approach. PhD dissertation, Purdue University, West Lafayette, INGoogle Scholar
  48. Xue JF, Gavin K (2007) Simultaneous determination of critical slip surface and reliability index for slopes. ASCE J Geotech Geoenv Eng 133(7):878–886Google Scholar
  49. Yucemen MS, Tang WH, Ang AHS (1973) A probabilistic study of safety and design of earth slopes. Structural Research Series No. 402, University of Illinois at Urbana-ChampaignGoogle Scholar

Copyright information

© Springer-Verlag Berlin Heidelberg 2017

Authors and Affiliations

  1. 1.Department of Civil EngineeringIndian Institute of Engineering Science and Technology (IIEST)ShibpurIndia
  2. 2.Department of Civil, Mining and Environmental EngineeringUniversity of WollongongWollongongAustralia

Personalised recommendations