Advertisement

Rate Effects on Shear Deformation of Rough Limestone Discontinuities

  • Doron Morad
  • Yossef H. Hatzor
  • Amir SagyEmail author
Original Paper
  • 116 Downloads

Abstract

The relationship between slip velocity, resistance to shear, and geometrical evolution of initially rough limestone surfaces is investigated in servo-controlled direct shear experiments. We focus on shear stress evolution throughout the deformation process, as function of the shear rates applied. Direct shear tests are performed on tensional fractures positioned in a perfectly mating configuration, using a hydraulic, closed-loop, servo-controlled system. The discontinuities are sheared to prescribed displacement target of 10 mm under a constant normal stress of 5 MPa while shear stress and dilation are recorded under controlled shear rates between 0.1 and 50 µ/s. Surface geometry is measured using laser profilometer before and after tests, and roughness evolution is statistically quantified. We find that, before peak shear stress is attained, the shear stiffness increases with slip velocity, manifesting asperity strain hardening during this largely elastic deformation stage. Peak shear stress and stress drop, however, are both inversely proportional to velocity, indicating velocity weakening coupled with rate-dependent healing of the interfaces. The final roughness of the sheared surfaces increases moderately with increasing slip velocity indicating enhanced fragmentation and brittle deformation with increasing shear rate.

Keywords

Rock discontinuities Slip velocity Multiscale roughness Shear stiffness Peak and residual shear strength 

Notes

Acknowledgements

This research is funded by Israel Science Foundation through contract no. ISF 937/17. We thank Ze’ev Reches and another anonymous reviewer for reviewing an earlier version of this manuscript and for their helpful comments.

References

  1. Atapour H, Moosavi M (2014) The influence of shearing velocity on shear behavior of artificial joints. Rock Mech Rock Eng 47:1745–1761CrossRefGoogle Scholar
  2. Badt N, Hatzor YH, Toussaint R, Sagy A (2016) Geometrical evolution of interlocked rough slip surfaces: the role of normal stress. Earth Planet Sc Lett 443:153–161CrossRefGoogle Scholar
  3. Barton N (1976) The shear strength of rock and rock joints. Int J Rock Mech Min 13:255–279CrossRefGoogle Scholar
  4. Biran O, Hatzor YH, Ziv A (2009) Micro-scale roughness effects on the friction coefficient of granite surfaces under varying levels of normal stress. In: Hatzor Y, Sulem J, Vardoulakis I (eds) Shear physics at the meso-scale in earthquake and landslide mechanics. CRC Press, Boca Raton, pp. 145–158CrossRefGoogle Scholar
  5. Boneh Y, Reches ZE (2017) Geotribology-Friction, wear, and lubrication of faults. Tectonophysics‏Google Scholar
  6. Boneh Y, Sagy A, Reches Z (2013) Frictional strength and wear-rate of carbonate faults during high-velocity, steady-state sliding. Earth Planet Sci Lett 381:127–137CrossRefGoogle Scholar
  7. Bowden F, Tabor D (1950) The friction and lubrication of solids. Oxford University Press, OxfordGoogle Scholar
  8. Brodsky EE, Kirkpatrick JD, Candela T (2016) Constraints from fault roughness on the scale-dependent strength of rocks. Geology 44:19–22CrossRefGoogle Scholar
  9. Brown SR, Scholz CH (1985) Broad bandwidth study of the topography of natural rock surfaces. J Geophys Res 90:12,575–512,582CrossRefGoogle Scholar
  10. Byerlee J (1978) Friction of rocks. Pure appl Geophys 116:615–626CrossRefGoogle Scholar
  11. Byerlee JD, Brace WF (1968) Stick slip, stable sliding, and earthquakes—effect of rock type, pressure, strain rate, and stiffness. J Geophys Res 73:6031–6037CrossRefGoogle Scholar
  12. Candela T, Renard F, Klinger Y, Mair K, Schmittbuhl J, Brodsky EE (2012) Roughness of fault surfaces over nine decades of length scales. J Geophys Res-Solid Earth 117Google Scholar
  13. Chester FM, Chester JS (2000) Stress and deformation along wavy frictional faults. J Geophys Res: Solid Earth 105(B10):23421–23430CrossRefGoogle Scholar
  14. Cook NGW (1992) Natural jonts in rock—mechanical, hydraulic and seismic behavior and properties under normal stress. Int J Rock Mech Min Sci Geomech Abstracts 29:198–223CrossRefGoogle Scholar
  15. Crawford AM, Curran JH (1981) The influence of shear velocity on the frictional resistance of rock discontinuities. Int J Rock Mech Min 18:505–515CrossRefGoogle Scholar
  16. Davidesko G, Sagy A, Hatzor YH (2014) Evolution of slip surface roughness through shear. Geophys Res Lett 41:1492–1498CrossRefGoogle Scholar
  17. Di Toro G, Han R, Hirose T, De Paola N, Nielsen S, Mizoguchi K, Ferri F, Cocco M, Shimamoto T (2011) Fault lubrication during earthquakes. Nature 471:494–494+CrossRefGoogle Scholar
  18. Dieterich JH (1972) Time-dependent friction in rocks. J Geophys Res 77:3690–3697CrossRefGoogle Scholar
  19. Dieterich JH (1979) Modeling of rock friction, 1: Experimental results and constitutive equations. J Geophys Res 84:2161–2168CrossRefGoogle Scholar
  20. Fang ZJ, Dunham EM (2013) Additional shear resistance from fault roughness and stress levels on geometrically complex faults. J Geophys Res-Sol Ea 118:3642–3654CrossRefGoogle Scholar
  21. Goodman RE (1974) The mechaincal properties of joints. In: Proc. 3rd Conference ISRM, Denver CO, pp. 127–140Google Scholar
  22. Goodman RE (1989) Introduction to rock mechanics, 2nd edn. Wiley, New YorkGoogle Scholar
  23. Grasselli G, Egger P (2003) Constitutive law for the shear strength of rock joints based on three-dimensional surface parameters. Int J Rock Mech Min 40:25–40CrossRefGoogle Scholar
  24. Harbord CWA, Nielsen SB, De Paola N, Holdsworth RE (2017) Earthquake nucleation on rough faults. Geology 45:931–934CrossRefGoogle Scholar
  25. Heard HC (1963) Effect of large changes in strain rate in the experimental deformation of Yule marble. J Geol 71:162CrossRefGoogle Scholar
  26. Ide S (2013) The proportionality between relative plate velocity and seismicity in subduction zones. Nat Geosci 6(9):780‏CrossRefGoogle Scholar
  27. Ladanyi B, Archambault G (1970) Simulation of shear behaviour of a jointed rock mass. In: Proc. 11th Symposium on Rock Mechanics. AIME, New York, pp. 105–125Google Scholar
  28. Lajtai EZ, Duncan EJS, Carter BJ (1991) The effect of strain rate on rock strength. Rock Mech Rock Eng 24:99–109CrossRefGoogle Scholar
  29. Liu QS, Tian YC, Ji PQ, Ma H (2018) Experimental investigation of the peak shear strength criterion based on three-dimensional surface description. Rock Mech Rock Eng 51:1005–1025CrossRefGoogle Scholar
  30. Marone C (1998) The effect of loading rate on static friction and the rate of fault healing during the earthquake cycle. Nature 391:69–72CrossRefGoogle Scholar
  31. Muhuri SK, Dewers TA, Scott Jr TE, Reches ZE (2003) Interseismic fault strengthening and earthquake-slip instability: Friction or cohesion? Geology 31(10):881–884CrossRefGoogle Scholar
  32. Nayak PR (1971) Random process model of rough surfaces. J Lubr Technol 93:398CrossRefGoogle Scholar
  33. Nishikawa T, Ide S (2014) Earthquake size distribution in subduction zones linked to slab buoyancy. Nat Geosci 7(12):904CrossRefGoogle Scholar
  34. Ohnaka M (2003) A constitutive scaling law and a unified comprehension for frictional slip failure, shear fracture of intact rock, and earthquake rupture. J Geophys Res-Solid Earth 108Google Scholar
  35. Patton FD (1966) Multiple modes of shear failure in rock. In: Proc. 1st congr. Int. Soc. Rock Mech. ISRM, Lisbon, pp. 509–513Google Scholar
  36. Persson BNJ (2006) Contact mechanics for randomly rough surfaces. Surf Sci Rep 61:201–227CrossRefGoogle Scholar
  37. Power WL, Tullis TE, Weeks JD (1988) Roughness and wear during brittle faulting. J Geophys Res-Solid Earth Planets 93:15268–15278CrossRefGoogle Scholar
  38. Rangers N (1970) Influence of surface roughness on friction properties of rock planes. In: Proc. 2nd Cong. ISRM, Bergrade, pp. 229–234Google Scholar
  39. Reches Z, Lockner DA (2010) Fault weakening and earthquake instability by powder lubrication. Nature 467:452-102CrossRefGoogle Scholar
  40. Ruina A (1983) Slip instability and state variable friction laws. J Geophys Res 88:10,359–310,370CrossRefGoogle Scholar
  41. Rutter EH (1972) Effects of strain-rate changes on strength and ductility of solenhofen limestone at low temperatures and confining pressures. Int J Rock Mech Min Sci 9:183–189CrossRefGoogle Scholar
  42. Sagy A, Brodsky EE, Axen GJ (2007) Evolution of fault-surface roughness with slip. Geology 35:283–286CrossRefGoogle Scholar
  43. Saucier F, Humphreys E, Weldon R (1992) Stress near geometrically complex strike-slip faults: application to the San Andreas fault at Cajon Pass, southern California. J Geophys Res: Solid Earth 97(B4):5081–5094.‏CrossRefGoogle Scholar
  44. Scholz CH (1998) Earthquakes and friction laws. Nature 391(6662):37CrossRefGoogle Scholar
  45. Seidel JP, Haberfield CM (2002) A theoretical model for rock joints subjected to constant normal stiffness direct shear. Int J Rock Mech Min 39:539–553CrossRefGoogle Scholar
  46. Tal Y, Hager BH, Ampuero JP (2018) The effects of fault roughness on the earthquake nucleation process. J Geophys Res-Solid Earth 123:437–456CrossRefGoogle Scholar
  47. Tesei T, Carpenter BM, Giorgetti C, Scuderi MM, Sagy A, Scarlato P, Collettini C (2017) Friction and scale-dependent deformation processes of large experimental carbonate faults. J Struct Geol 100:12–23CrossRefGoogle Scholar
  48. Thomson DJ (1982) Spectrum estimation and harmonic-analysis. Proc IEEE 70:1055–1096CrossRefGoogle Scholar
  49. Tsutsumi A, Shimamoto T (1997) High-velocity frictional properties of gabbro. Geophys Res Lett 24:699–702CrossRefGoogle Scholar
  50. Wang KL, Bilek SL (2011) Do subducting seamounts generate or stop large earthquakes? Geology 39, 819–822CrossRefGoogle Scholar
  51. Zhao J (1997) Joint surface matching and shear strength.B. JRC-JMC shear strength criterion. Int J Rock Mech Min Sci 34:179–185CrossRefGoogle Scholar
  52. Zielke O, Galis M, Mai PM (2017) Fault roughness and strength heterogeneity control earthquake size and stress drop. Geophys Res Lett 44:777–783CrossRefGoogle Scholar

Copyright information

© Springer-Verlag GmbH Austria, part of Springer Nature 2019

Authors and Affiliations

  1. 1.Department of Geological and Environmental ScienceBen Gurion University of the NegevBeer ShevaIsrael
  2. 2.Geological Survey of IsraelJerusalemIsrael

Personalised recommendations