Effect of vacuum packaging on bandwidth of push–pull type capacitive accelerometer structure
- 11 Downloads
This paper presents the effect of vacuum packaging on the band-width of push–pull type capacitive accelerometer structure. The accelerometer structure (for ± 30 g application) consists of silicon proof mass (1000 μm × 1000 μm × 30 μm) suspended by four L-shaped beams over 1 μm deep cavity. The fixed electrodes (Au) are on Pyrex glass substrates which are anodically bonded to the Si substrate. The squeeze film damping factor (ς) arising due to the trapped air between the electrodes is found to be ~ 2600 at atmospheric pressure. Introduction of holes in the proof-mass reduces ς to 750. In such a highly damped environment, the operational bandwidth (3 dB) bandwidth is found to be only around 20 Hz which is not suitable for many of the navigation applications. With vacuum packaging (vacuum level 100–760 Torr), there is not much noticeable improvement in the bandwidth due to high level of ς (> 150). In the 1–100 Torr range, the bandwidth is found to be improving linearly (from 20 Hz to 2 kHz) with the improving vacuum level. Further improvement of vacuum level (< 1 Torr) leads to the under-damped (ς < 1) condition and the proof mass start oscillating which also undesirable. Thus, vacuum packaging in the 1–10 Torr range (having ς: 2–15) is found to be suitable for achieving optimum operation bandwidth for the current accelerometer sensor.
Authors would like to thank Director SSPL for his kind permission to publish this paper.
- Bao M (2005) Analysis and design principles of MEMS Devices. Elsevier Publication, AmstrerdamGoogle Scholar
- Bhan RK, Shaveta Imran Md, Pal R, Dutta S (2015a) An improved analytical approach for estimation of misalignment error of sensing axis in MEMS accelerometers using simple tilt measurements. Sensors Transducers 189(6):128Google Scholar
- Bhan RK, Shaveta Panchal A, Parmar Y, Sharma C, Pal R, Dutta S (2015b) Determination of multiple spring constants, gaps and pull down voltages in MEMS crab type micro-accelerometer using near pull down capacitance voltage measurements. Sensors Transducers 192(9):44Google Scholar
- Bhan RK, Shaveta Imran Md, Pal R, Dutta S, Yadav I (2016) Development of unified fabrication process and testing of MEMS based comb and crab type capacitive accelerometers for navigational applications. Sensors Transducers 203(8):8Google Scholar
- Dutta S, Shaveta Pal R, Bhattacharya DK, Datta P, Chatterjee R (2008) Design and analysis of wet etching based comb type capacitive accelerometer. Sensors Transducers 91(4):31Google Scholar
- Dutta S, Pal R, Kumar P, Hooda OP, Singh J, Shaveta Saxena G, Datta P, Chatterjee R (2009) Fabrication challenges for realization of wet etching based comb type capacitive microaccelerometer structure. Sensors Transducers 111(12):18Google Scholar
- Mohammed Z, Dushaq G, Chatterjee A, Rasras M (2017) An optimization technique for performance improvement of gap-changeable MEMS accelerometers. Mechatronics. https://doi.org/10.1016/j.mechatronics.2017.10.011 Google Scholar
- Santos De Los HJ (2004) Introduction to micro-electro-mechanical (MEMS) microwave systems, Chap. 1 & 2, 2nd edn. Artech House, Boston, LondonGoogle Scholar