# Drag reduction and thrust generation by tangential surface motion in flow past a cylinder

- 17 Downloads

## Abstract

Sensitivity of drag to tangential surface motion is calculated in flow past a circular cylinder in both two- and three-dimensional conditions at Reynolds number \(\textit{Re} \le 1000\). The magnitude of the sensitivity maximises in the region slightly upstream of the separation points where the contour lines of spanwise vorticity are normal to the cylinder surface. A control to reduce drag can be obtained by (negatively) scaling the sensitivity. The high correlation of sensitivities of controlled and uncontrolled flow indicates that the scaled sensitivity is a good approximation of the nonlinear optimal control. It is validated through direct numerical simulations that the linear range of the steady control is much higher than the unsteady control, which synchronises the vortex shedding and induces lock-in effects. The steady control injects angular momentum into the separating boundary layer, stabilises the flow and increases the base pressure significantly. At \(\textit{Re}=100\), when the maximum tangential motion reaches 50% of the free-stream velocity, the vortex shedding, boundary-layer separation and recirculation bubbles are eliminated and 32% of the drag is reduced. When the maximum tangential motion reaches 2.5 times of the free-stream velocity, thrust is generated and the power savings ratio, defined as the ratio of the reduced drag power to the control input power, reaches 19.6. The mechanism of drag reduction is attributed to the change of the radial gradient of spanwise vorticity (\(\partial _{r} \hat{\zeta }\)) and the subsequent accelerated pressure recovery from the uncontrolled separation points to the rear stagnation point.

## Keywords

Drag reduction Sensitivity Bluff body flow## Preview

Unable to display preview. Download preview PDF.

## Notes

### Acknowledgements

The authors would like to thank Professor Kwing-So Choi for helpful discussions. XM would like to acknowledge financial support under EPSRC grant EP/M025039/1. This work made use of the facilities of N8 HPC provided and funded by the N8 consortium and EPSRC (Grant No.EP/K000225/1). The Centre is co-ordinated by the Universities of Leeds and Manchester.

## References

- 1.Arakeri, J., Shukla, R.: A unified view of energetic efficiency in active drag reduction, thrust generation and self-propulsion through a loss coefficient with some applications. J. Fluids Struct.
**41**, 22–32 (2013)CrossRefGoogle Scholar - 2.Barkley, D., Blackburn, H.M., Sherwin, S.J.: Direct optimal growth analysis for timesteppers. Int. J. Numer. Methods Fluids
**57**, 1435–1458 (2008)MathSciNetCrossRefMATHGoogle Scholar - 3.Barkley, D., Henderson, R.D.: Three-dimensional Floquet stability analysis of the wake of a circular cylinder. J. Fluid Mech.
**322**, 215–241 (1996)CrossRefMATHGoogle Scholar - 4.Beaudoin, J., Cadot, O., Aider, J., Wesfreid, J.: Drag reduction of a bluff body using adaptive control methods. Phys. Fluids
**18**, 085107 (2006)CrossRefGoogle Scholar - 5.Choi, H., Jeon, W., Kim, J.: Control of flow over a bluff body. Annu. Rev. Fluid Mech.
**40**, 113–139 (2008)MathSciNetCrossRefMATHGoogle Scholar - 6.Fujisawa, N., Tanahashi, S., Srinivas, K.: Evaluation of pressure field and fluid forces on a circular cylinder with and without rotational oscillation using velocity data from PIV measurement. Meas. Sci. Technol.
**16**, 989–996 (2005)CrossRefGoogle Scholar - 7.Glezer, A., Amitay, M.: Synthetic jets. Annu. Rev. Fluid Mech.
**34**, 503–529 (2002)MathSciNetCrossRefMATHGoogle Scholar - 8.He, J., Glowinski, R., Metcalfe, R., Nordlander, A., Periaux, J.: Active control and drag optimization for flow past a circular cylinder. J. Comput. Phys.
**163**, 83–117 (2000)MathSciNetCrossRefMATHGoogle Scholar - 9.Jukes, T., Choi, K.S.: Flow control around a circular cylinder using pulsed dielectric barrier discharge surface plasma. Phys. Fluids
**21**, 084103 (2009)CrossRefMATHGoogle Scholar - 10.Jukes, T., Choi, K.S.: Long lasting modifications to vortex shedding using a short plasma excitation. Phys. Rev. Lett.
**102**, 254501 (2009)CrossRefGoogle Scholar - 11.Karniadakis, G.E., Choi, K.S.: Mechanisms on transverse motions in turbulent wall flows. Annu. Rev. Fluid Mech.
**35**, 45–62 (2003)MathSciNetCrossRefMATHGoogle Scholar - 12.Lu, L., Qin, J., Teng, B., Li, Y.: Numerical investigations of lift suppression by feedback rotary oscillation of circular cylinder at low Reynolds number. Phys. Fluids
**23**, 033601 (2011)CrossRefGoogle Scholar - 13.Mao, X., Blackburn, H.M., Sherwin, S.J.: Calculation of global optimal initial and boundary perturbations for the linearised incompressible Navier–Stokes equations. J. Comput. Phys.
**235**, 258–273 (2013)MathSciNetCrossRefMATHGoogle Scholar - 14.Mao, X., Blackburn, H.M., Sherwin, S.J.: Nonlinear optimal suppression of vortex shedding from a circular cylinder. J. Fluid Mech.
**775**, 241–265 (2015)MathSciNetCrossRefMATHGoogle Scholar - 15.Mao, X., Hogg, S.: Calculation of optimal surface roughness with respect to lift/drag forces acting on wind turbine blade. In: ASME Turbo Expo 2014: Turbine Technical Conference and Exposition, Düsseldorf, Germany (2014)Google Scholar
- 16.Mao, X., Sherwin, S.J., Blackburn, H.M.: Transient growth and bypass transition in stenotic flow with a physiological waveform. Theor. Comput. Fluid Dyn.
**25**, 31–42 (2011)CrossRefMATHGoogle Scholar - 17.Modi, V.: Moving surface boundary-layer control: a review. J. Fluids Struct.
**11**, 627–663 (1997)CrossRefGoogle Scholar - 18.Naito, H., Fukagata, K.: Control of flow around a circular cylinder for minimizing energy dissipation. Phys. Rev. E
**90**, 053008 (2014)CrossRefGoogle Scholar - 19.Patnaik, B.S., Wei, G.: Controlling wake turbulence. Phys. Rev. Lett.
**88**, 054502 (2002)CrossRefGoogle Scholar - 20.Peers, E., Huang, X., Luo, X.: A numerical model of plasma-actuator effects in flow-induced noise control. IEEE Trans. Plasma Sci.
**37**, 2250–2256 (2009)CrossRefGoogle Scholar - 21.Poncet, P., Hildebrand, R., Cottet, G., Koumoutsakos, P.: Spatially distributed control for optimal drag reduction of the flow past a circular cylinder. J. Fluid Mech.
**599**, 111–120 (2008)MathSciNetCrossRefMATHGoogle Scholar - 22.Protas, B., Wesfreid, J.: Drag force in the open-loop control of the cylinder wake in the laminar regime. Phys. Fluids
**14**(2), 810 (2002)CrossRefMATHGoogle Scholar - 23.Shiels, D., Leonard, A.: Investigation of a drag reduction on a circular cylinder in rotary oscillation. J. Fluid Mech.
**431**, 297–322 (2001)CrossRefMATHGoogle Scholar - 24.Shinbrot, T., Ditto, W., Grebogi, C., Ott, E., Spano, M., Yorke, J.: Using the sensitive dependence of chaos (the “butterfly effect”) to direct trajectories in an experimental chaotic system. Phys. Rev. Lett.
**68**, 2863 (1992)MathSciNetCrossRefMATHGoogle Scholar - 25.Shukla, R., Arakeri, J.: Minimum power consumption for drag reduction on a circular cylinder by tangential surface motion. J. Fluid Mech.
**715**, 597–641 (2013)MathSciNetCrossRefMATHGoogle Scholar - 26.Tao, J., Bao, Y.: Drag reduction of wake flow by shear-driven rotation. Phys. Rev. E
**87**, 023013 (2013)CrossRefGoogle Scholar - 27.Tokumaru, P., Dimotakis, P.: Rotary oscillation control of a cylinder wake. J. Fluid Mech.
**224**, 77–90 (1991)CrossRefGoogle Scholar - 28.Wang, Q., Gao, J.: The drag-adjoint field of a circular cylinder wake at reynolds numbers 20, 100 and 500. J. Fluid Mech.
**730**, 145–161 (2013)MathSciNetCrossRefMATHGoogle Scholar - 29.Wang, Q., Hu, R., Blonigan, P.: Least squares shadowing sensitivity analysis of chaotic limit cycle oscillations. J. Comput. Phys.
**267**, 210–224 (2014)MathSciNetCrossRefMATHGoogle Scholar - 30.Zhang, H., Fan, B., Chen, Z.: Optimal control of cylinder wake flow by electro-magnetic force based on adjoint flow field. Eur. J. Mech. B Fluids
**29**, 53–60 (2010)CrossRefMATHGoogle Scholar