Strength properties of Scots pine from harbour piles degraded by erosion bacteria
- 30 Downloads
140-year-old Scots pine piles displaying various levels of degradation by erosion bacteria were excavated from the harbour of Hamburg and investigated. Bending and compression strength correlated to the basic density, moisture content and lignin content. The compression strength was determined both on samples with dimensions of 30 mm × 20 mm × 20 mm and using 6.6 mm-increment cores taken perpendicular to the grain direction. Both sizes of the samples showed almost identical results. The sapwood of all samples was completely water-saturated; the heartwood did not even achieve 50% water saturation. The sapwood samples showed a good correlation between moisture content and strength properties, whereas basic density correlated well with the strength properties of both sapwood and heartwood. With increasing bacterial attack and resulting lower basic density, the lignin content increased in relation to holocellulose. The measured lignin content of the sapwood showed a good conformity with all strength properties. Determination of the lignin content represents an alternative method for predicting strength values of waterlogged wood while leaving most of the test material intact.
We thank the Hamburg Port Authority (HPA) for their valuable support.
- ASTM D2395-14e1 Standard test methods for density and basic density (relative density) of wood and wood-based materialsGoogle Scholar
- Broda M, Mazela B, Królikowska-Pataraja K, Hill CAS (2015) The use of FT-IR and computed tomography non-destructive technique for waterlogged wood characterisation. Wood Res 60(5):707–722Google Scholar
- DIN 52185 (1976) Testing of wood—compression test parallel to grain. Deutsches Institut für Normung, BerlinGoogle Scholar
- DIN 52186 (1978) Testing of wood—bending test. Deutsches Institut für Normung, BerlinGoogle Scholar
- ISO 3131 (1975) Wood—Determination of density for physical and mechanical tests. ISO International Organization for StandardizationGoogle Scholar
- Lukowsky D (2015) Failure analysis of wood and wood-based products. McGraw-Hill Education, New YorkGoogle Scholar
- Schniewind AP (1990) Physical and mechanical properties of archaeological wood. In: Archaeological wood—properties, chemistry, and preservation. american chemical society, vol 225, Chap 4, pp 87–109. https://doi.org/10.1021/ba-1990-0225.ch004
- Thiele R (1996) Zerstörungsarme Bestimmung von inneren, festigkeitsbeschreibenden Kennwerten bei historischen Holzgründungskonstruktionen (Minor- destructive assessment of specific values that determine the strength of historical wooden foundations) (In German). Dissertation, Technische Hochschule LeipzigGoogle Scholar
- Wilcox WW (1978) Review of literature on the effects of early stages of decay on wood strength. Wood Fiber 9(4):252–257Google Scholar