Evaluation and optimization of the engineering properties of polymer-modified asphalt
- 340 Downloads
Polymers are increasingly being used to modify asphalt and enhance highway pavement performance. This paper reports the development of a procedure to evaluate and optimize a polymer-modified asphalt (PMA). Two asphalt cements and two styrene-butadiene-styrene (SBS) copolymers were mixed at ten concentration levels. The engineering properties and morphologies of the binders were investigated using a dynamic shear rheometer, scanning electron microscopy (SEM), and other rheological techniques. The morphology of the PMA was characterized by the SBS concentration and the microstructure of the copolymer. Polymer modification increased the elastic responses and dynamic moduli of asphalt binders. As the SBS concentration increased, the copolymer gradually became the dominant phase, accompanied by a change in engineering properties. Results from SEM demonstrated that, up to 6% concentration, good compatibility exists between SBS and asphalt binder. The modified binders show either a continuous asphalt phase with dispersed SBS particles or a continuous polymer phase with dispersed asphalt globules, or two interlocked continuous phases. The optimum SBS content was determined based on the formation of a critical network between asphalt and polymer.
Keywordspolymer-modified asphalt styrene-butadiene-styrene compatibility
Unable to display preview. Download preview PDF.
- 1.T.S. Shuler, D.L. Hanson, and R.G. McKeen: “Design and Construction of Asphalt Concrete Using Polymer Modified Asphalt Binders,”Polymer Modified Asphalt Binders, ASTM STP1108, ASTM, W. Conshohocken, PA, 1992, pp. 97–128.Google Scholar
- 2.F.S. Choquet and E.J. Ista: “The Determination of SBS, EVA and APP Polymers in Modified Bitumens,”Polymer Modified Asphalt Binders, ASTM STP1108, ASTM, W. Conshohocken, PA, 1992, pp. 35–49.Google Scholar
- 3.L.H. Lewandowski: “Polymer Modification of Paving Asphalt Binders,”Rubber Chem. Technol., 1994,67, pp. 447–480.Google Scholar
- 5.S. Maccarrone, G. Holleran, and G.P. Gnanaseelan: “Properties of Polymer Modified Binders and Relationship to Mix and Pavement Performance,“J. Assoc. Asphalt Paving Technol., 1996,64, pp. 209–240.Google Scholar
- 10.U. Isacsson and X. Lu: “Laboratory Investigation of Polymer Modified Bitumens,”J. Assoc. Asphalt Paving Technol., 1999,68, pp. 35–63.Google Scholar
- 16.G. Kraus: “Modification of Asphalt by Block Polymers of Butadiene and Styrene,”Rubber Chem. Technol., 1982,55, pp. 1389–1402.Google Scholar
- 17.Anon.: “StandardTestMethodforToughness and Tenacity of Bituminous Materials,” ASTM D 5801,Annual Book of ASTM Standards, vol. 04.03, ASTM, W. Conshohocken, PA, 1999.Google Scholar
- 19.R.L. Schalek and L.T. Drzal: “Characterization of Advanced Materials Using SEM,”J. Adv. Mater., 2000,2, pp. 32–38.Google Scholar
- 21.Anon.: “Standard Specification for Type IV Polymer-Modified Asphalt Cement for Use in Pavement Construction,” ASTM D 5892,Annual Book of ASTM Standards, vol. 04.03, ASTM, W. Conshohocken, PA, 1999.Google Scholar