Advertisement

Journal of Materials Science

, Volume 30, Issue 19, pp 4861–4870 | Cite as

Mechanical properties of extruded dual-phase NiAl Alloys

  • R. Tiwari
  • S. N. Tewari
  • R. Asthana
  • A. Garg
Article

Abstract

The mechanical behaviour of dual-phase microstructures, consisting of elongated primary NiAl grains aligned with an intergranular NiAl/X eutectic phase, produced by extrusion of cast NiAl-X (whereX=Cr and W) alloys, has been examined. Chromium, added to create a dual-phase NiAl-based aligned microstructure, resulted in large increases in the yield strength, but only marginal improvement in the toughness. In contrast, tungsten alloying leads to ductility or toughness increases with no significant strengthening. The constitutional hardening rate due to deviations from stoichiometry in Ni rich NiAl was estimated to be about 66 MPa (Ni−1 at%).

Keywords

Polymer Microstructure Chromium Tungsten Ductility 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. 1.
    D. B. Miracle,Acta. Metall. Mater,41 (1993) 649.CrossRefGoogle Scholar
  2. 2.
    R. D. Noebe, R. R. Bowman andM. V. Nathal,Int. Met. Rev. 38 (1993) 193.CrossRefGoogle Scholar
  3. 3.
    J. D. Cotton, R. D. Noebe andM. J. Kaufman,Intermetallics 1 (1993) 3.CrossRefGoogle Scholar
  4. 4.
    K. S. Kumar, S. K. Mannan andR. K. Viswanadham,Acta Metall. Mater. 40 (1992) 1201.CrossRefGoogle Scholar
  5. 5.
    R. Darolia, D. Lahrman andR. Field,Scripta Metall. Mater. 126 (1992) 1007.CrossRefGoogle Scholar
  6. 6.
    R. D. Noebe, A. Misra andR. Gibala,ISIJ Int. 31 (1991) 1172.CrossRefGoogle Scholar
  7. 7.
    S. N. Tewari, NASA TN D-8355 (NASA, Lewis Research Center, Cleveland, OH, 1977).Google Scholar
  8. 8.
    D. R. Pank, M. V. Nathal andD. A. Koss,J. Mater. Res. 5 (1990) 942.CrossRefGoogle Scholar
  9. 9.
    K. Ishida, R. Kainuma, N. Ueno andT. Nishizawa,Metall. Trans. A 22A (1991) 441.CrossRefGoogle Scholar
  10. 10.
    S. Guha, P. R. Munroe andI. Baker,Mater. Res. Symp. Proc. 133 (1989) 633.CrossRefGoogle Scholar
  11. 11.
    R. Gibala, H. Chang, C. M. Czarnik, K. M. Edwards andA. Misra, in “Structural Intermetallics”, edited by R. Darolia, J. J. Lewandowski, C. T. Liu, P. L. Martin, D. B. Miracle and M. V. Nathal (The Minerals and Metals Society, 1993) pp. 561–567.Google Scholar
  12. 12.
    J. D. Cotton, R. D. Noebe andM. J. Kaufman,Phase Equilibria submitted.Google Scholar
  13. 13.
    S. M. Merchant andM. R. Notis,Mater. Sci. Engng 66 (1984) 47.CrossRefGoogle Scholar
  14. 14.
    S. B. Maslenkov andV. A. Rodmkina,Izvestiya Akademii Nauk SSSR, Metally 1 (1989) 194.Google Scholar
  15. 15.
    P. Nash, S. Fielding andD. R. F. West,Met. Sci. 17 (1983) 192.CrossRefGoogle Scholar
  16. 16.
    L. Kaufman andH. Nesor,Can Metall. Quart. 14 (1975) 221.CrossRefGoogle Scholar
  17. 17.
    K. H. Hahn andK. Vedula,Scripta Metall. Mater. 23 (1989) 7.CrossRefGoogle Scholar
  18. 18.
    R. T. Pascoe andC. W. A. Newey,Met. Sci. J. 2 (1968) 138.CrossRefGoogle Scholar
  19. 19.
    E. M. Schulson,Mater. Res. Soc. Symp. Proc. 39 (1985) 193.CrossRefGoogle Scholar
  20. 20.
    J. H. Westbrook, H. E. Grenoble andD. L. Wood, WADD-TR-60-184, Pt V, (1964) p. 22.Google Scholar
  21. 21.
    C.C. Law andM. J. Blackburn, Final Technical Report No. AFWAL-TR-87-4102, (1987).Google Scholar
  22. 22.
    P. Nagpal andI. Baker,Mater. Character. 27 (1991) 167.CrossRefGoogle Scholar
  23. 23.
    “Metals Handbook”, desk edition (ASM International, 1985).Google Scholar
  24. 24.
    “High Temperature Materials II”, edited by G. M. Ault, W. F. Barclay and H. P. Munger (Wiley, New York, 1963).Google Scholar
  25. 25.
    J. D. Cotton, R. D. Noebe andM. J. Kaufman, “Structural Intermetallics”, edited by R. Darolia, J. J. Lewandowski, C. T. Liu, P. L. Martin, D. B. Miracle and M. V. Nathal (The Minerals and Metals Society, 1993) pp. 513–522.Google Scholar
  26. 26.
    I. Baker, P. Nagpal, F. Liu andP. R. Munroe,Acta. Metall. Mater 39 (1991) 1637.CrossRefGoogle Scholar
  27. 27.
    R. R. Bowman, R. D. Noebe, S. V. Raj andI. E. Locci,Met. Trans A 23A (1992) 1493.CrossRefGoogle Scholar
  28. 28.
    K. Matsugi, D. W. Wenman andN. S. Stoloff,Scripter Met. 27 (1992) 1633.CrossRefGoogle Scholar

Copyright information

© Chapman & Hall 1995

Authors and Affiliations

  • R. Tiwari
    • 1
  • S. N. Tewari
    • 1
  • R. Asthana
    • 2
  • A. Garg
    • 2
  1. 1.Chemical Engineering DepartmentCleveland State UniversityClevelandUSA
  2. 2.NASA Lewis Research CenterClevelandUSA

Personalised recommendations