The effect of ultrasonic vibrations on a sample of Armco iron during deformation is to change the distribution of second-order residual stresses along the height of the sample. The highest residual stresses are found in the area of the contact surfaces and the lowest in the central part of the sample. But after deformation without ultrasonic vibrations the highest residual stresses are found in the central part of the sample and the lowest in the contact area.
Ultrasonic vibrations during deformation reduce the second-order residual stresses by approximately 20%.
This is a preview of subscription content, log in to check access.
Buy single article
Instant access to the full article PDF.
Price includes VAT for USA
Subscribe to journal
Immediate online access to all issues from 2019. Subscription will auto renew annually.
This is the net price. Taxes to be calculated in checkout.
F. Jones, Proc. Roy. Soc. (1938), Vol. 16, A 166.
G. V. Kurdyumov and L. I. Lysak, ZhTF (1947), No. 17.
V. Cagliotti and G. Sachs, Z. Phys. (1932), V. 14.
Physicotechnical Institute, Academy of Sciences of the BSSR. Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 9, pp. 11–14, September, 1966.
About this article
Cite this article
Severdenko, V.P., Klubovich, V.V. & Kharitonovich, M.V. Second-order residual stresses in Armco iron deformed in an ultrasonic field. Met Sci Heat Treat 8, 694–696 (1966). https://doi.org/10.1007/BF00686570
- Residual Stress
- Contact Area
- Contact Surface
- Ultrasonic Vibration