Abstract
In this paper, carbon-supported palladium (Pd) and its alloys with iridium (Ir) were investigated for the purpose of alkaline sulfide oxidation and ultimately for application as anodes in direct alkaline sulfide fuel cell (DASFC). Physical and electrochemical characterizations, such as X-ray diffraction, transmission electron microscopy, energy dispersive X-ray, cyclic voltammetry, linear sweep voltammetry, I–V analysis, and electrochemical impedance spectroscopy were carried out. Pd9Ir1/C exhibited the highest activity, showing the lowest onset potential and the highest current density, mass activity, and specific activity. The maximum power density of a DASFC single cell with a Pd9Ir1/C anode was 33.98 mW cm−2 at 70 °C, which was 35 % higher than that obtained with Pd/C. It is thought that the incorporation of more oxophilic Ir into Pd promoted the adsorption of OHads at a lower potential, and Pd9Ir1/C led to optimal OHads coverage, which played a catalytic role and thus resulted in the best performance.
References
Mao Z, Anani A, White RE, Srinivasan S, Appleby AJ (1991) A modified electrochemical process for the decomposition of hydrogen sulfide in an aqueous alkaline solution. J Electrochem Soc 138:1299–1303. doi:10.1149/1.2085775
Anani A, Mao Z, White RE, Srinivasan S, Appleby AJ (1990) Electrochemical production of hydrogen and sulfur by low-temperature decomposition of hydrogen sulfide in an aqueous alkaline solution. J Electrochem Soc 137:2703–2709. doi:10.1149/1.2087021
Liu M, He P, Luo JL, Sanger AR, Chuang KT (2001) Performance of a solid oxide fuel cell utilizing hydrogen sulfide as fuel. J Power Sources 94:20–25. doi:10.1016/S0378-7753(00)00660-1
He P, Liu M, Luo JL, Sanger AR, Chuang KT (2002) Stabilization of platinum anode catalyst in a H2S–O2 solid oxide fuel cell with an intermediate TiO2 layer. J Electrochem Soc 149:A808–A814. doi:10.1149/1.1479156
Slavov SV, Chuang KT, Sanger AR, Donini JC, Kot J, Petrovic S (1998) A proton-conducting solid state H2S–O2 fuel cell. 1. Anode catalysts, and operation at atmospheric pressure and 20–90 °C. Int J Hydrogen Energy 23:1203–1212. doi:10.1016/S0360-3199(98)00003-2
Chuang KT, Donini JC, Sanger AR, Slavov SV (2000) A proton-conducting solid state H2S–O2 fuel cell. 2. Production of liquid sulfur at 120–145 °C. Int J Hydrogen Energy 25:887–894. doi:10.1016/S0360-3199(00)00009-4
Kim K, Han JI (2014) Performance of direct alkaline sulfide fuel cell without sulfur deposition on anode. Int J Hydrogen Energy 39:7142–7146. doi:10.1016/j.ijhydene.2014.02.085
Kim K, Kim HT, Han JI (2015) Compatibility of platinum with alkaline sulfide fuel: Effectiveness and stability of platinum as an anode catalyst in direct alkaline sulfide fuel cell. Int J Hydrogen Energy 40:4141–4145. doi:10.1016/j.ijhydene.2015.01.160
Kim K, Son J, Han JI (2014) Metal sulfides as anode catalysts in direct alkaline sulfide fuel cell. Int J Hydrogen Energy 39:10493–10497. doi:10.1016/j.ijhydene.2014.04.208
Kim K, Han JI (2015) Heteropolyacids as anode catalysts in direct alkaline sulfide fuel cell. Int J Hydrogen Energy 40:2979–2983. doi:10.1016/j.ijhydene.2015.01.011
Kim K, Han JI (2015) Carbon supported bimetallic Pd–Co catalysts for alkaline sulfide oxidation in direct alkaline sulfide fuel cell. Int J Hydrogen Energy 40:4567–4572. doi:10.1016/j.ijhydene.2015.02.009
Aldea R, Alper H (1995) Selective aerobic oxidation of sulfides using a novel palladium complex as the catalyst precursor. J Org Chem 60:8365–8366. doi:10.1021/jo00131a009
Li X, Huang Q, Zou Z, Xia B, Yang H (2008) Low temperature preparation of carbon-supported Pd Co alloy electrocatalysts for methanol-tolerant oxygen reduction reaction. Electrochim Acta 53:6662–6667. doi:10.1016/j.electacta.2008.04.032
Gharibi H, Farhad Golmohammadi, Kheirmand M (2013) Fabrication of MEA based on optimum amount of Co in PdxCo/C alloy nanoparticles as a new cathode for oxygen reduction reaction in passive direct methanol fuel cells. Electrochim Acta 89:212–221. doi:10.1016/j.electacta.2012.10.147
Wang Y, Zhao Y, Yin J, Liu M, Dong Q, Su Y (2014) Synthesis and electrocatalytic alcohol oxidation performance of Pd–Co bimetallic nanoparticles supported on graphene. Int J Hydrogen Energy 39:1325–1335. doi:10.1016/j.ijhydene.2013.11.002
Lee KR, Woo SI (2014) Promoting effect of Ni on PdCo alloy supported on carbon for electrochemical oxygen reduction reaction. Catal Today 232:171–174. doi:10.1016/j.cattod.2013.10.010
Zhang Z, Xin L, Sun K, Li W (2011) Pd–Ni electrocatalysts for efficient ethanol oxidation reaction in alkaline electrolyte. Int J Hydrogen Energy 36:12686–12697. doi:10.1016/j.ijhydene.2011.06.141
Shen SY, Zhao TS, Xu JB (2010) Carbon-supported bimetallic PdIr catalysts for ethanol oxidation in alkaline media. Electrochim Acta 55:9179–9184. doi:10.1016/j.electacta.2010.09.018
Assumpção MHMT, da Silva SG, De Souza RFB, Buzzo GS, Spinacé EV, Santos MC, Neto AO, Silva JCM (2014) Investigation of PdIr/C electrocatalysts as anode on the performance of direct ammonia fuel cell. J Power Sources 268:129–136. doi:10.1016/j.jpowsour.2014.06.025
Wang X, Tang Y, Gao Y, Lu T (2008) Carbon-supported Pd–Ir catalyst as anodic catalyst in direct formic acid fuel cell. J Power Sources 175:784–788. doi:10.1016/j.jpowsour.2007.10.011
Assumpção MHMT, da Silva SG, De Souza RFB, Buzzo GS, Spinacé EV, Neto AO, Silva JCM (2014) Direct ammonia fuel cell performance using PtIr/C as anode electrocatalysts. Int J Hydrogen Energy 39:5148–5152. doi:10.1016/j.ijhydene.2014.01.053
Strmcnik D, Uchimura M, Wang C, Subbaraman R, Danilovic N, van der Vliet D et al (2013) Improving the hydrogen oxidation reaction rate by promotion of hydroxyl adsorption. Nat Chem 5:300–306. doi:10.1038/nchem.1574
Liu J, Zhou Z, Zhao X, Xin Q, Sun G, Yi B (2004) Studies on performance degradation of a direct methanol fuel cell (DMFC) in life test. Phy Chem Chem Phys 6:134–137. doi:10.1039/b313478d
He C, Kunz HR, Fenton JM (1997) Evaluation of platinum-based catalysts for methanol electro-oxidation in phosphoric acid electrolyte. J Electrochem Soc 144:970–979. doi:10.1149/1.1837515
Yuan X, Wang H, Sun JC, Zhang J (2007) AC impedance technique in PEM fuel cell diagnosis—a review. Int J Hydrogen Energy 32:4365–4380. doi:10.1016/j.ijhydene.2007.05.036
Hsu NY, Yen SC, Jeng KT, Chien CC (2006) Impedance studies and modeling of direct methanol fuel cell anode with interface and porous structure perspectives. J Power Sou 161:232–239. doi:10.1016/j.jpowsour.2006.03.076
Acknowledgments
This research was supported by a grant from the National Research Foundation of Korea (NRF) funded by the Korean Ministry of Science, ICT and Future Planning (NRF-2012M1A2A2026587) and a grant from the Advanced Biomass R&D Center (ABC) of Korea funded by the Ministry of Science, ICT and Future Planning (ABC-2012053875).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kim, K., Han, JI. Carbon-supported bimetallic Pd–Ir catalysts for alkaline sulfide oxidation in direct alkaline sulfide fuel cell. J Appl Electrochem 45, 533–539 (2015). https://doi.org/10.1007/s10800-015-0835-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10800-015-0835-y